Skip to content
FaultCrate
日本語

This is an open preview: every record can be read without an account.

GMC Yukon XL 2000–2006

GMC Yukon XLModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

The vehicle (where a record says)

A record is under an engine, a drive or a series only where it says so: the characters of the vehicle identification number filed with a complaint, its text, or what its document says it applies to. A record that does not say is kept as "not stated". The filed numbers and the documents do not tell 4WD from AWD.

Common on this vehicle:Warning lightLeakNoiseMisfire or rough idleCorrosion or rustStalls or shuts offVibration or shudderDoes not start

Record by record

3 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.

Work done

How it is said to have ended

  • says it did not fix it1

A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.

Read the records one by one (3)

Known issuesUnwanted ABS activation at low speed (front wheel speed sensor mounting corrosion)2

  1. Owner complaint2002 GMC YUKON XL 1500 ・ 2014-04-23

    ABS activates without reason when braking on clean, dry roads

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      Not stated

      What the documents say to do

      Unwanted ABS activation at low speed (front wheel speed sensor mounting corrosion)

      Confirm

      • The reading should be at least 350 mV AC; if it is less, the wheel speed sensor must be replaced.

      Repair

      1. Dealers remove the sensor, clean its mounting surface on the bearing, apply rust inhibitor and grease, reinstall it and check peak-to-peak output voltage.
      2. The passage heading states that the repair is cleaning the wheel speed sensor mounting surface.

      Caution

      • Do not pry the sensor out of the bore; prying breaks the sensor body off in the bore.
    Read the sentences of the record
    Fault
    I TRIED TO STOP AND WHEN I APPLIED THE BRAKES THE ABS ACTIVATED WITHOUT ANY REASON. (1 more)
    Outcome
    OBVIOUSLY THE FIX WAS NOT EFFECTIVE IF I AM EXPERIENCING THE PROBLEM NOW. *TR

  2. Owner complaint2002 GMC YUKON XL ・ 2007-07-24

    ABS engaged unexpectedly at low speed and caused jerking

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

    Read the sentences of the record
    Fault
    WHILE DRIVING 5 MPH (= 8.05 km/h) OR LESS, THE ABS ENGAGED WITHOUT WARNING AND CAUSED THE VEHICLE TO JERK. (1 more)

SERVICE BRAKES, HYDRAULIC1

  1. Owner complaint2002 GMC YUKON XL ・ 2006-01-23

    Brake failure at 20-25 MPH, collision with school bus

    1. 1Fault

    2. 2Finding the cause

      THIS INCIDENT FOLLOWED THE PATTERN SET FORTH IN NHTSA RECALL 05V379000 ON AUGUST 29 2005.

    3. 3Correction

      Not stated

    Read the sentences of the record
    Fault
    AROUND 7:50 AM THE BUS STOPPED FOR RED LIGHT. (3 more)
    Cause
    THIS INCIDENT FOLLOWED THE PATTERN SET FORTH IN NHTSA RECALL 05V379000 ON AUGUST 29 2005.
    Consequence
    THE VEHICLE BUMPED THE REAR OF THE BUS, PUSHING IN THE BUMPER OF VEHICLE.