Skip to content
FaultCrate
日本語

This is an open preview: every record can be read without an account.

GMC Yukon XL 2000–2006

GMC Yukon XLModel years 2000–2006

Change vehicle →
Clear the search
Add conditions (optional: symptom, model year, system, warning display, trouble code, kind of record)

The vehicle (where a record says)

A record is under an engine, a drive or a series only where it says so: the characters of the vehicle identification number filed with a complaint, its text, or what its document says it applies to. A record that does not say is kept as "not stated". The filed numbers and the documents do not tell 4WD from AWD.

Common on this vehicle:Gauge or instrument faultAir conditioning or heaterOverheatingSmoke or fire

issueShift lever position indicator in the instrument cluster may not illuminate (FMVSS 102) - recall 05V-055Remove

Record by record

5 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.

Component named as the cause

Work done

A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.

Read the records one by one (5)

Known issuesShift lever position indicator in the instrument cluster may not illuminate (FMVSS 102) - recall 05V-0555

  1. Recall2005 GMC YUKON XL ・ —

    Automatic Transmission Shift Lever Position Indicator Illumination Recall

    1. 1Fault

      • Under certain starting conditions the shift lever position indicator in the instrument panel cluster may not illuminate; on later start-ups the condition may or may not recur.
      • If the indicator does not illuminate, the driver may not know which gear is selected and the vehicle may move in an unintended direction, possibly injuring people outside the vehicle.

    2. 2Finding the cause

      Possible causes

      • The PRNDL indicator behavior is induced only by a very specific battery voltage waveform and depends on vehicle level characteristics, while the vehicle otherwise operates normally.
      • The "blank PRNDL" anomaly appeared at the assembly plants after interim 2005 model year instrument panel cluster revisions that began on January 31, 2005.

    3. 3Correction

      Repair

      1. Dealers are to reprogram the instrument panel cluster.
      2. Prepare the vehicle for instrument panel cluster (IPC) reprogramming, then program the IPC using TIS data version 2.25.

      Parts

      • No parts are required for this recall.

      Caution

      • The service calibration is in Techline Information System (TIS) data version 2.25 and on TIS CD-ROM version 3.
      • A later dealer message says TIS Data 2.50 has been released, so dealers no longer need to contact the Techline Customer Support Center (TCSC) for a VCI number to access the calibration.
      • Vehicles with manual transmissions are not involved in this recall and need no further action.
    Read the sentences of the record

    From the manufacturer’s document

    • Applies to：The recall covers certain 2005 Cadillac Escalade, Escalade ESV, Escalade EXT; Chevrolet Avalanche, Silverado, Suburban, Tahoe; and GMC Sierra, Yukon, Yukon XL vehicles equipped with an automatic transmission and built within the listed VIN breakpoints.
    • Condition：Under certain starting conditions the shift lever position indicator in the instrument panel cluster may not illuminate; on later start-ups the condition may or may not recur.
    • Condition：If the indicator does not illuminate, the driver may not know which gear is selected and the vehicle may move in an unintended direction, possibly injuring people outside the vehicle.
    • Cause：The PRNDL indicator behavior is induced only by a very specific battery voltage waveform and depends on vehicle level characteristics, while the vehicle otherwise operates normally.
    • Cause：The "blank PRNDL" anomaly appeared at the assembly plants after interim 2005 model year instrument panel cluster revisions that began on January 31, 2005.
    • Repair：Dealers are to reprogram the instrument panel cluster.
    • Repair：Prepare the vehicle for instrument panel cluster (IPC) reprogramming, then program the IPC using TIS data version 2.25.
    • Caution：The service calibration is in Techline Information System (TIS) data version 2.25 and on TIS CD-ROM version 3.
    • Caution：A later dealer message says TIS Data 2.50 has been released, so dealers no longer need to contact the Techline Customer Support Center (TCSC) for a VCI number to access the calibration.
    • Parts：No parts are required for this recall.
    • Caution：Vehicles with manual transmissions are not involved in this recall and need no further action.
    Cause
    CERTAIN SPORT UTILITY VEHICLES EQUIPPED WITH AN AUTOMATIC TRANSMISSION, FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 102, "TRANSMISSION SHIFT LEVER SEQUENCE, STARTER INTERLOCK AND TRANSMISSION BRAKING EFFECT." UNDER CERTAIN VEHICLE STARTING CONDITIONS, THE SHIFT LEVER POSITION INDICATOR LOCATED IN THE INSTRUMENT PANEL CLUSTER MAY NOT ILLUMINATE. IF THE SHIFT LEVER POSITION INDICATOR DOES NOT ILLUMINATE, THE DRIVER MAY NOT KNOW WHICH GEAR THE VEHICLE IS IN.
    Remedy
    DEALERS WILL REPROGRAM THE INSTRUMENT PANEL CLUSTER FREE OF CHARGE. THE RECALL BEGAN ON FEBRUARY 14, 2005. OWNERS MAY CONTACT CADILLAC AT 1-866-982-2339, CHEVROLET AT 1-800-630-2438, AND GMC AT 1-866-996-9463.
    Consequence
    THE VEHICLE MAY MOVE IN AN UNINTENDED DIRECTION RESULTING IN POSSIBLE INJURY TO OTHERS OUTSIDE OF THE VEHICLE.

  2. Recall2005 GMC YUKON XL ・ 2005-02-15

    Shift Lever Position Indicator Illumination Recall

    1. 1Fault

      Not stated

    2. 2Finding the cause

    3. 3Correction

      Not stated

      What the documents say to do

      Shift lever position indicator in the instrument cluster may not illuminate (FMVSS 102) - recall 05V-055

      Repair

      1. Dealers reprogram the instrument panel cluster.
      2. Prepare the vehicle for instrument panel cluster (IPC) reprogramming, then program the IPC using TIS data version 2.25.
    Read the sentences of the record
    Cause
    Certain vehicles equipped with an automatic transmission fail to comply with the requirements of CMVSS 101 - Location, identification and illumination of displays. Under certain vehicle starting conditions, the shift lever position indicator located in the instrument panel cluster may not illuminate. In subsequent vehicle start-ups, this condition may or may not occur again. If the shift lever position indicator does not illuminate, the driver may not know which gear the vehicle is in and the vehicle may move in an unintended direction, resulting in possible injury to others outside of the vehicle. Correction: Dealers will reprogram the instrument panel cluster.

  3. Owner complaint2005 GMC YUKON DENALI XL ・ 2012-05-29

    Gear indicator on instrument panel no longer illuminates

    1. 1Fault

      THE CONTACT STATED THAT THE GEAR INDICATOR ON THE INSTRUMENT PANEL NO LONGER ILLUMINATED.

    2. 2Finding the cause

      Not stated

    3. 3CorrectionNot repaired

      THE VEHICLE WAS NOT TAKEN TO HAVE THE FAILURE DIAGNOSED OR REPAIRED.

      What the documents say to do

      Shift lever position indicator in the instrument cluster may not illuminate (FMVSS 102) - recall 05V-055

      Repair

      1. Dealers reprogram the instrument panel cluster.
      2. Prepare the vehicle for instrument panel cluster (IPC) reprogramming, then program the IPC using TIS data version 2.25.
    Read the sentences of the record
    Fault
    THE CONTACT STATED THAT THE GEAR INDICATOR ON THE INSTRUMENT PANEL NO LONGER ILLUMINATED.
    Remedy
    THE VEHICLE WAS NOT TAKEN TO HAVE THE FAILURE DIAGNOSED OR REPAIRED.
    Consequence
    AS A RESULT, THE CONTACT WAS UNAWARE AS TO WHAT GEAR THE VEHICLE WAS ENGAGED.

  4. Owner complaint2005 GMC YUKON XL 1500 ・ 2014-08-15

    A/C blower runs at highest setting; gear indicator light dimmed

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      THE BLOWER DID NOT STOP RUNNING UNTIL MY HUSBAND REMOVED THE FUSE.

      What the documents say to do

      Shift lever position indicator in the instrument cluster may not illuminate (FMVSS 102) - recall 05V-055

      Repair

      1. Dealers reprogram the instrument panel cluster.
      2. Prepare the vehicle for instrument panel cluster (IPC) reprogramming, then program the IPC using TIS data version 2.25.
    Read the sentences of the record
    Fault
    YESTERDAY I STARTED MY VEHICLE AND TURNED ON THE A/C. THE A/C BLOWER WAS BLOWING AT THE HIGHEST SETTING REGARDLESS OF THE CONTROL SETTING. (1 more)
    Remedy
    THE BLOWER DID NOT STOP RUNNING UNTIL MY HUSBAND REMOVED THE FUSE.

  5. Owner complaint2005 GMC YUKON DENALI XL ・ 2010-11-12

    Shift indicator in instrument panel does not illuminate

    1. 1Fault

      THE SHIFT INDICATOR IN THE INSTRUMENT PANEL DOES NOT ILLUMINATE.

    2. 2Finding the cause

      Not stated

    3. 3Correction

      Not stated

      What the documents say to do

      Shift lever position indicator in the instrument cluster may not illuminate (FMVSS 102) - recall 05V-055

      Repair

      1. Dealers reprogram the instrument panel cluster.
      2. Prepare the vehicle for instrument panel cluster (IPC) reprogramming, then program the IPC using TIS data version 2.25.
    Read the sentences of the record
    Fault
    THE SHIFT INDICATOR IN THE INSTRUMENT PANEL DOES NOT ILLUMINATE.
    Consequence
    WHEN THE SHIFT LEVER POSITION INDICATOR DOES NOT ILLUMINATE, THE DRIVER DOES NOT KNOW WHICH GEAR THE VEHICLE IS IN.