Skip to content
FaultCrate
日本語

This is an open preview: every record can be read without an account.

GMC Yukon XL 2000–2006

GMC Yukon XLModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

Common on this vehicle:Seat beltWarning lightAir bag did not deployNoiseVibration or shudder

Record by record

6 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.

Symptom

Component named as the cause

A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.

Read the records one by one (6)

SEAT BELTS4

  1. Manufacturer communication2001–2006 GMC YUKON XL ・ 2017-08-15

    Seat belt buckle operation and warning light issues

    1. 1Fault

      • Seat belt buckles do not operate and/or the seat belt warning light is on; the buckle is hard to latch or unlatch, or the release button sticks.

    2. 2Finding the cause

      Possible causes

      • Sticky beverages spilled onto or into the buckle assembly; debris from food, candy wrappers, paper and coins can also contribute.

      Steps to confirm (in the document’s order)

      • Shine a light on the latch plate insertion area of the buckle and look for debris or foreign objects.

    3. 3Correction

      Repair

      1. If debris is seen, try to vacuum it out, then latch and unlatch the belt; if it works properly, do not replace the buckle assembly.
      2. If not corrected, inspect the buckle for sticky residue; if found, the buckle assembly must be replaced at the customer's expense.

      Caution

      • Never insert anything but the latch plate into the buckle, do not dig anything out with a tool, and never wash out a buckle to remove a spilled liquid because this may damage it.
      • This is not a manufacturing defect and is not covered by the new vehicle warranty.
    Read the sentences of the record

    From the manufacturer’s document

    • Applies to：2016 and prior GM passenger cars and trucks.
    • Condition：Seat belt buckles do not operate and/or the seat belt warning light is on; the buckle is hard to latch or unlatch, or the release button sticks.
    • Cause：Sticky beverages spilled onto or into the buckle assembly; debris from food, candy wrappers, paper and coins can also contribute.
    • Caution：Never insert anything but the latch plate into the buckle, do not dig anything out with a tool, and never wash out a buckle to remove a spilled liquid because this may damage it.
    • Confirm：Shine a light on the latch plate insertion area of the buckle and look for debris or foreign objects.
    • Repair：If debris is seen, try to vacuum it out, then latch and unlatch the belt; if it works properly, do not replace the buckle assembly.
    • Repair：If not corrected, inspect the buckle for sticky residue; if found, the buckle assembly must be replaced at the customer's expense.
    • Caution：This is not a manufacturing defect and is not covered by the new vehicle warranty.

    Open the manufacturer’s document (PDF) ↗ The points above were read from this document.

    Remedy
    This informational bulletin provides information to advise dealers about seat belt buckles not operating and/or seat belt warning light illumination, as well as difficulty latching and unlatching the buckle or the buckle release button sticking.

  2. Manufacturer communication2001–2002 GMC YUKON XL ・ 2001-11-20

    Second Row Seatbelt Rattle Noise

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      CUSTOMERS MAY COMPLAIN OF A RATTLE NOISE COMING FROM THE SECOND ROW SEATBELT. *SLC

    Read the sentences of the record
    Remedy
    CUSTOMERS MAY COMPLAIN OF A RATTLE NOISE COMING FROM THE SECOND ROW SEATBELT. *SLC

  3. Manufacturer communication2000–2002 GMC YUKON XL ・ 2001-10-25

    Front Seat Belt Retractor and Buckle Replacement Information

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

    Read the sentences of the record
    Remedy
    INFORMATION REGARDING REPLACEMENT OF THE FRONT SEAT BELT RETRACTOR AND BUCKLE USAGE. *TT

  4. Owner complaint2002 GMC YUKON XL 1500 ・ 2010-08-20

    Middle row seatbelt issues on multiple vehicles

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

      Not stated

    Read the sentences of the record
    Fault
    THE MIDDLE ROW SEATS IN ALL OF THESE HAVE SEATBELT ISSUES.

AIR BAGS1

  1. Owner complaint2002 GMC YUKON XL ・ 2007-09-04

    ABS light on and abnormal vibration throughout vehicle

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      SO, HE INSTRUCTED ME TO RAISE THE HOOD AND REMOVE THE 60AMP ABS FUSE.

    Read the sentences of the record
    Fault
    FAILURE/CONSEQUENCES: 2002 YUKON: I STARTED MY CAR AND ABS LIGHT STAYED ON. (2 more)
    Remedy
    SO, HE INSTRUCTED ME TO RAISE THE HOOD AND REMOVE THE 60AMP ABS FUSE.
    Inspection
    HIS INITIAL GUESS WAS THAT IT WAS THE ABS MODULE OR EBCM NEEDED TO BE REPLACED.

SEATS AND RESTRAINTS1

  1. Recall2001–2002 GMC YUKON XL ・ 2002-04-11

    Seat Belt Retractor Sensor Inoperative Recall

    1. 1Fault

    2. 2Finding the cause

      Certain vehicles fail to conform to CMVSS 209, seat belt assemblies. These vehicles have a condition where one or two sensors in the driver's and front seat passengers seat belt retractors may be inoperative. The seat belt retractors will lock when the belt webbing is extracted during a crash; however the mechanism that locks the seat belt retractor when the vehicle decelerates quickly, such as during heavy braking, may not restrain the occupant as intended during a crash, and could result in injury to the occupant. Correction update: None required as no effect on vehicle safety. See recall 04-158.

    3. 3Correction

      Not stated

    Read the sentences of the record
    Cause
    Certain vehicles fail to conform to CMVSS 209, seat belt assemblies. These vehicles have a condition where one or two sensors in the driver's and front seat passengers seat belt retractors may be inoperative. The seat belt retractors will lock when the belt webbing is extracted during a crash; however the mechanism that locks the seat belt retractor when the vehicle decelerates quickly, such as during heavy braking, may not restrain the occupant as intended during a crash, and could result in injury to the occupant. Correction update: None required as no effect on vehicle safety. See recall 04-158.