GMC Yukon XL 2000–2006
Common on this vehicle:Corrosion or rustLeakParking brakeStalls or shuts off
Record by record
2 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.
Component named as the cause
Work done
How it is said to have ended
- result not stated4
A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.
Read the records one by one (2)
Known issuesBrake pipe (brake line) corrosion and rupture1
Owner complaint2002 GMC YUKON XL DENALI ・ 2012-08-22
Broken and leaking brake lines due to severe underbody corrosion
Known issuesCrankshaft position sensor may work intermittently or fail (8.1L V8) - recall 07V-5211
Owner complaint2001 GMC YUKON XL 2500 ・ 2009-12-03
Engine stalling intermittently due to crank position sensor issue
1Fault
2Finding the cause
3Correction
Read the sentences of the record
- Fault
- THE CRANK CASE POSITION SENSOR SHUTS ON AND OFF INTERMITTENTLY WHICH CAUSED THE ENGINE TO STALL AND IT MAY NOT RESTART IMMEDIATELY.
- Cause
- THE FAILURE IS RELATED TO NHTSA#07V521000 AND GM RECALL# 06083, ENGINE AND ENGINE COOLING.
- Remedy
- A LOCAL MECHANIC REPAIRED THE TRANSMISSION AT FOR LESS THAN $800.
- Inspection
- A DIFFERENT AUTHORIZED DEALER PERFORMED A DIAGNOSTIC TEST AND STATED THAT THE CRANK SHAFT POSITION SENSOR NEEDED TO BE REPLACED.
1 owner complaints have no classified sentences yet, so their causes and repairs are not picked out. Their text is in the list of records.

