Skip to content
FaultCrate

This is an open preview: every record can be read without an account.

GMC Yukon XL 2000–2006

GMC Yukon XLModel years 2000–2006

Change vehicle →
Clear the search
1 conditions added

Common on this vehicle:Noise

causeIntermediate Steering ShaftRemove

Record by record

4 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.

Symptom

Component named as the cause

A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.

Read the records one by one (4)

Known issuesSteering intermediate shaft clunk2

  1. Owner complaint2002 GMC YUKON XL ・ 2013-08-25

    Steering rattle in new vehicle

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

      DEALER RE-GREASED WITH WHAT THEY SAID WAS A NEW GREASE THAT SHOULD SOLVE THE RATTLE PROBLEM.

      What the documents say to do

      Steering intermediate shaft clunk

      Confirm

      • When properly lubricated, there should be 13 mm (1/2 inch) of grease showing on the shaft splines.

      Repair

      1. Replace the upper intermediate steering shaft assembly.
      2. There are significant differences between the car and truck procedures: the lubricant is applied to a different part of the steering system and uses a different lubrication kit, 26098419.
    Read the sentences of the record
    Cause
    I UNDERSTAND THERE IS A REDESIGNED STEERING SHAFT THAT SOLVES THIS RATTLE PROBLEM.
    Remedy
    DEALER RE-GREASED WITH WHAT THEY SAID WAS A NEW GREASE THAT SHOULD SOLVE THE RATTLE PROBLEM.
  2. Owner complaint2002 GMC YUKON XL ・ 2005-12-14

    Intermediate steering shaft play and hesitation when turning; clunking sound

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

      THE SHAFT WAS THEN LUBED AS PER BULLETIN #II-00-02-35-003B AND WE WERE TOLD AT THE TIME THAT THE PROBLEM SHOULD NOT REOCCUR.

      What the documents say to do

      Steering intermediate shaft clunk

      Confirm

      • When properly lubricated, there should be 13 mm (1/2 inch) of grease showing on the shaft splines.

      Repair

      1. Replace the upper intermediate steering shaft assembly.
      2. There are significant differences between the car and truck procedures: the lubricant is applied to a different part of the steering system and uses a different lubrication kit, 26098419.
    Read the sentences of the record
    Fault
    ON OCCASION, THE STEERING WHEEL HAD EXCESSIVE PLAY IN THE WHEEL AND WOULD HESITATE WHEN TURNING.
    Remedy
    THE SHAFT WAS THEN LUBED AS PER BULLETIN #II-00-02-35-003B AND WE WERE TOLD AT THE TIME THAT THE PROBLEM SHOULD NOT REOCCUR.
    Inspection
    SUSS PONTIAC VERIFIED THE COMPLAINT AND FOUND THE "INTERMEDIATE STEERING SHAFT" DRY AND CLUNKING.

STEERING2

  1. Owner complaint2004 GMC YUKON XL ・ 2007-03-03

    Loud rattle from left front side, December 2005

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

      Not stated

    Read the sentences of the record
    Fault
    IN DECEMBER OF 2005, STARTING HEARING A LOUD RATTLE COMING FROM THE LEFT FRONT SIDE OF MY 2004 GMC YUKON WITH 26,099 MILES (= 42,002 km).
    Cause
    APPARENTLY THERE IS ACTUALLY THE LOWER STEERING COLUMN BEARING THAT NEEDS REPLACED.
  2. Owner complaint2003 GMC YUKON XL ・ 2004-07-19

    Intermediate steering shaft bolt loose while driving up mountain

    1. 1Fault

      WHILE DRIVING UP A MOUNTAIN INTERMEDIATE STEERING SHAFT BOLT BECAME LOOSE, AND WAS JUST 3 TURNS FROM FALLING OFF.

    2. 2Finding the cause

    3. 3Correction

      Not stated

    Read the sentences of the record
    Fault
    WHILE DRIVING UP A MOUNTAIN INTERMEDIATE STEERING SHAFT BOLT BECAME LOOSE, AND WAS JUST 3 TURNS FROM FALLING OFF.