Skip to content
FaultCrate
日本語

This is an open preview: every record can be read without an account.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
Add conditions (optional: symptom, model year, system, warning display, trouble code, kind of record)

The vehicle (where a record says)

A record is under an engine, a drive or a series only where it says so: the characters of the vehicle identification number filed with a complaint, its text, or what its document says it applies to. A record that does not say is kept as "not stated". The filed numbers and the documents do not tell 4WD from AWD.

Common on this vehicle:ABS activates (at low speed and the like)NoiseWarning lightReduced brakingCorrosion or rustLoss of engine power, no acceleration

remedyHub AssemblyRemove

Record by record

11 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.

Symptom

Component named as the cause

Work done

How it is said to have ended

  • says it was fixed2
  • says it did not fix it2
  • result not stated11

A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.

Read the records one by one (11)

Known issuesUnwanted ABS activation at low speed (front wheel speed sensor mounting corrosion)2

  1. Owner complaint2002 GMC YUKON ・ 2005-08-12

    ABS engagement with loss of brakes at low speeds

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

    Read the sentences of the record
    Fault
    WHILE DRIVING AT LOW SPEEDS UNDER 5 MPH (= 8.05 km/h) ABS ENGAGED WHEN APPLYING BRAKES.
    Remedy
    TOOK VEHICLE TO THE DEALER FOR REPAIRS AND THE LEFT FRONT WHEEL HUB BEARING ASSEMBLY WAS REPLACED ALONG WITH THE WHEEL SPEED SENSOR.
    Outcome
    SINCE THIS REPAIRS THE PROBLEM HAS BEEN CORRECTED.

  2. Owner complaint2001 GMC YUKON ・ 2005-05-24

    ABS activates at low speed, causing extended stopping distances

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

    Read the sentences of the record
    Fault
    DT: CONTACT STATES THE ABS COMES ON WHILE DRIVING APPROXIMATELY 5 MPH (= 8.05 km/h), CAUSING THE MANUAL BRAKES TO PUMP AT LOW SPEED, LEADING TO EXTENDED STOPPING DISTANCES. (1 more)
    Remedy
    THE SERVICE DEALER REPLACED THE RIGHT FRONT HUB AND THE SENSOR.

Known issuesBrake pipe (brake line) corrosion and rupture1

  1. Owner complaint2000 GMC YUKON ・ 2014-01-23

    Brake failure and ABS activation while driving, brake line corroded

    1. 1Fault

    2. 2Finding the cause

    3. 3CorrectionNot repaired

    Read the sentences of the record
    Fault
    THE CONTACT STATED THAT WHILE DRIVING APPROXIMATELY 5 MPH (= 8.05 km/h), THE BRAKES FAILED TO ENGAGE WHEN DEPRESSED AND THE BRAKE PEDAL ABNORMALLY TRAVELED TO THE FLOOR BOARD. (1 more)
    Remedy
    THE VEHICLE WAS NOT REPAIRED. (1 more)
    Inspection
    THE VEHICLE WAS TAKEN TO A DEALER WHERE IT WAS DISCOVERED THAT THE BRAKE LINE WAS CORRODED.

Known issuesAftermarket part (not the vehicle as built): Federal-Mogul National / Carquest replacement wheel hub assembly retention nut - recall 07E-1061

  1. Recall2000–2006 GMC YUKON ・ —

    Wheel Hub Assembly Bearing Nut Loosening Recall

    1. 1Fault

      • The inboard retention nut that maintains the hub bearing assembly can loosen, resulting in an ABS light indication, noise, and/or wheel separation from the vehicle; wheel separation can result in a vehicle crash.

    2. 2Finding the cause

      Steps to confirm (in the document’s order)

      1. On 2x4 vehicles, raise the vehicle on an approved hoist first; the hub assembly is good if a yellow, green or blue paint mark is seen on the grease cap on the inboard side of the steering knuckle.
      2. If the paint mark is not present, remove the wheel and the brake rotor and clean rust from the hub assembly face to check for the date code stamping.
      3. Defective hub assemblies can be identified by the country of origin on the package together with a recalled date code, by the date code on the package, or by the date code on the hub assembly.
      4. If a round yellow sticker is present on the box label, the part is good.

    3. 3Correction

      Repair

      1. The hub assemblies were manufactured for aftermarket use; owners of these parts should have them removed and replaced as soon as possible.
      2. Federal-Mogul will replace the recalled hub assemblies free of charge.

      Parts

      • The recalled part numbers are 515020, 515021, 515025, 515053, 515054, 515059 and 515060.
    Read the sentences of the record

    From the manufacturer’s document

    • Applies to：This is an equipment recall by Federal-Mogul of certain wheel hub assemblies sold as replacement parts only.
    • Applies to：The recalled hub assemblies were packaged and sold between January 23, 2006 and December 20, 2007 under the National and CARQUEST Premium (BGS/Blue) brands, in 7 base part numbers.
    • Parts：The recalled part numbers are 515020, 515021, 515025, 515053, 515054, 515059 and 515060.
    • Applies to：The application lists include GMC 1500 Yukon (2WD) and GMC 1500 Yukon XL (2WD), 2001-2006.
    • Applies to：ILJIN manufactured the recalled hub assemblies from December 27, 2005 to November 29, 2007.
    • Condition：The inboard retention nut that maintains the hub bearing assembly can loosen, resulting in an ABS light indication, noise, and/or wheel separation from the vehicle; wheel separation can result in a vehicle crash.
    • Confirm：On 2x4 vehicles, raise the vehicle on an approved hoist first; the hub assembly is good if a yellow, green or blue paint mark is seen on the grease cap on the inboard side of the steering knuckle.
    • Confirm：If the paint mark is not present, remove the wheel and the brake rotor and clean rust from the hub assembly face to check for the date code stamping.
    • Confirm：Defective hub assemblies can be identified by the country of origin on the package together with a recalled date code, by the date code on the package, or by the date code on the hub assembly.
    • Confirm：If a round yellow sticker is present on the box label, the part is good.
    • Repair：The hub assemblies were manufactured for aftermarket use; owners of these parts should have them removed and replaced as soon as possible.
    • Repair：Federal-Mogul will replace the recalled hub assemblies free of charge.
    Cause
    CERTAIN FEDERAL-MOGUL REPLACEMENT WHEEL HUB ASSEMBLIES WITH THE BRAND NAMES: NATIONAL, CARQUEST P/NOS. 515020, 515021, 515025, 515053, 515054, 515059, AND 515060, SHIPPED BETWEEN JANUARY 23, 2006, AND DECEMBER 20, 2007, SOLD FOR LIGHT DUTY AND MEDIUM DUTY TRUCKS. THE INBOARD RETENTION NUT USED TO MAINTAIN HUB BEARING ASSEMBLY CAN LOOSEN RESULTING IN AN ABS LIGHT INDICATION, NOISE, AND/OR WHEEL SEPARATION.
    Remedy
    FEDERAL-MOGUL WILL NOTIFY CUSTOMERS AND WILL REPLACE THE HUB ASSEMBLY FREE OF CHARGE. THE RECALL BEGAN ON FEBRUARY 7, 2008. OWNERS CAN CONTACT FEDERAL-MOGUL TOLL-FREE AT 877-489-6659.
    Consequence
    WHEEL SEPARATION CAN RESULT IN A VEHICLE CRASH.

SERVICE BRAKES, HYDRAULIC3

  1. Owner complaint2003 GMC YUKON ・ 2007-04-03

    2003 GMC Yukon: rear rotors and front wheel hub assemblies replaced

    1. 1Fault

      Not stated

    2. 2Finding the cause

    3. 3Correction

    Read the sentences of the record
    Remedy
    BOTH REAR ROTORS AND FRONT WHEEL HUB AND BEARING ASSEMBLY UNITS WERE REPLACED.

  2. Owner complaint2002 GMC YUKON ・ 2005-12-06

    Skidding and grinding when brake pedal applied, vehicle not included in recall

    1. 1Fault

      THE VEHICLE WOULD SKID AND GRIND WHEN THE BRAKE PEDAL WAS APPLIED.

    2. 2Finding the cause

      Not stated

    3. 3Correction

    Read the sentences of the record
    Fault
    THE VEHICLE WOULD SKID AND GRIND WHEN THE BRAKE PEDAL WAS APPLIED.
    Remedy
    THE SAME DAY THE VEHICLE WAS TAKEN TO A LOCAL REPAIR FACILITY WHERE THEY REPLACED THE LEFT FRONT UNITIZED BEARING AND FRONT WHEEL DRIVE HUB ASSEMBLY. *NM

  3. Owner complaint2002 GMC YUKON ・ 2005-11-30

    Front wheel assembly replacement on 2002 GMC Yukon

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

    Read the sentences of the record
    Remedy
    2002 GMC YUKON FRONT WHEEL ASSEMBLY HAD TO BE REPLACED.

ELECTRONIC STABILITY CONTROL (ESC)1

  1. Owner complaint2004 GMC YUKON DENALI ・ 2012-10-16

    Stability control disabled and reduced engine power warnings, then engine stalls while driving

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

    Read the sentences of the record
    Fault
    WHILE IN THE MIDDLE OF DRIVING, THE "STABILITY CONTROL DISABLED" SENSOR COMES ON FOLLOWED BY "REDUCED ENGINE POWER" AND MY VEHICLE JUST SHUTS OFF.
    Remedy
    I HAVE ALREADY REPLACED A HUB THAT MY MECHANIC SAID WAS CAUSING A "TRACTION CONTROL" PROBLEM FROM EARLIER.

POWER TRAIN1

  1. Owner complaint2001 GMC YUKON ・ 2012-06-18

    Slight grinding noise resembling brake dragging

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

    Read the sentences of the record
    Fault
    I HEARD A SLIGHT GRINDING NOISE, THAT SOUNDED LIKE A BRAKE DRAGGING.
    Remedy
    I REPLACED BRAKES ALL THE WAY AROUND, AND THAT DIDN'T STOP THE NOISE. (1 more)

SERVICE BRAKES1

  1. Owner complaint2002 GMC YUKON ・ 2014-12-23

    ABS and brake warning lights illuminate while driving

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

    Read the sentences of the record
    Fault
    THE CONTACT STATED THAT WHILE DRIVING AT APPROXIMATELY 45 MPH (= 72.4 km/h), THE ABS AND THE BRAKE WARNING LIGHTS ILLUMINATED CONTINUOUSLY.
    Remedy
    THE DRIVER SIDE HUB ASSEMBLY WAS REPLACED BUT THE PASSENGER SIDE WAS NOT REPLACED.
    Inspection
    THE VEHICLE WAS TAKEN TO AN INDEPENDENT MECHANIC WHO DIAGNOSED THAT THE HUB ASSEMBLIES NEEDED TO BE REPLACED.

SUSPENSION1

  1. Owner complaint2000 GMC YUKON ・ 2001-12-13

    Wheel bearing failure at low mileage

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

    Read the sentences of the record
    Inspection
    IT WAS MIS DIAGNOSED BY J.P. THIBODEAUX GMC IN NEW IBERIA, LA. (1 more)