Skip to content
FaultCrate
日本語

This is an open preview: every record can be read without an account.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

The vehicle (where a record says)

A record is under an engine, a drive or a series only where it says so: the characters of the vehicle identification number filed with a complaint, its text, or what its document says it applies to. A record that does not say is kept as "not stated". The filed numbers and the documents do not tell 4WD from AWD.

Common on this vehicle:NoiseWarning lightCorrosion or rustLeakMisfire or rough idleAir conditioning or heaterReduced brakingLights (headlights, turn signals)

Possible causes

Warning light, 2002102 records
Engine
Brakes
Fuel system
Airbags and seat belts
Suspension, wheels and tires
Transmission and driveline
10Intake manifold gasket leak (cold idle misfire, lean codes)7Single-cylinder misfire (P0300-P0308) and/or chirp, squeak or tick at camshaft speed: worn cam lobe / lifter, valve or valve spring3Rear bank knock sensor corrosion from water intrusion (P0332)4.8L, 5.3L, 6.0L only1P0300 after engine repairs: injector connectors crossed (cylinders 5-7 / 6-8)1Engine Valve: clogged or contaminated3Brake pipe (brake line) corrosion and rupture2Unwanted ABS activation at low speed (front wheel speed sensor mounting corrosion)1ABS light with C0265/C0201/U1041 or no communication with brake module (EBCM ground G110)0ABS lamp with DTC C0265 (EBCM motor relay circuit) after EBCM replacement0Stability System Disabled message and unwanted StabiliTrak activation (tire wear or mismatched tires)3DTC P0446 set with the SES lamp on (replace the EVAP vent solenoid, not the canister)2Seat Belt Buckle: clogged or contaminated, failed1Air bag (SIR) lamp on with DTC B1001 after BCM or SDM replacement1Seat Belt Warning Light: failed2Autoride (Z55) Service Ride Control / Service Suspension System message1Aftermarket part (not the vehicle as built): Federal-Mogul National / Carquest replacement wheel hub assembly retention nut - recall 07E-1062WD only1Service 4WD indicator and DTC B2725 (transfer case shift control switch)4WD / AWD only14WD/AWD lamps and system inoperative: "sleepy" New Venture Gear transfer case control module (reprogram the TCCM)4WD / AWD only
4 causes not drawn
Causes with no correction stated (4)

Causes the records name for which no check or repair is stated, in a technical document or in a record. Press one for the records that name it.

Electrical, wiring and power
ATC Fuse: electrical fault, failed (2)
Heating and air conditioning
Encoder Motor: electrical fault (1)
Exhaust and emissions
Evap Vent Valve: clogged or contaminated (1)
Transmission and driveline
Transmission Control Module: failed (1)

The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.

FaultCrate・GMC Yukon 2000–2006・Warning light, 2002

Candidate cause (the documents say what to do)

Engine Valve: clogged or contaminated

1 of the records matching this search name this component as the cause.

How to tell

P0300P0308Check engine / Service Engine Soon

What to do

No technical document states a check or a repair.

In the records

  • Engine Valve: cleaned 1
See the evidence (0 technical documents, 1 records)

Records

None among the records that can be opened now.

See all 1 records of this cause →

A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.

Put together by FaultCrate from public records and technical documents. The cause and the repair are for the workshop to decide with the vehicle in front of it. Counts are records, not failure rates.