GMC Yukon 2000–2006
Common on this vehicle:Warning lightNoiseLeakMisfire or rough idleVibration or shudderAir conditioning or heaterReduced brakingCorrosion or rust
Possible causes
47 causes not drawn
- Hydro-boost brake assist and power steering share one hydraulic supply (four campaigns)1
- Violent steering wheel shake or vibration at road speed (brake booster)1
- ABS lamp with DTC C0265 (EBCM motor relay circuit) after EBCM replacement1
- Front floor carpet wet or musty odor (rear door water deflector replacement)2
- Door sags or is hard to open or close (worn or corroded hinge pins and bushings)1
- Broken latch of the rear cupholder in the center console (replace the latch only)1
- Second-row rearward folding head restraint pinch points - recall 02V-2531
- Side access door noise (door check link replacement)1
- Oil leak after cold start from frozen PCV system (rear main seal)3
- Lean hesitation, sag or stumble at -6 to +20°C coolant temperature (PCM reprogram)4.8L, 5.3L, 6.0L only2
- Intake manifold gasket leak (cold idle misfire, lean codes)1
- Higher than expected engine oil consumption (PCV valve replacement)4.8L, 5.3L, 6.0L only1
- P0300 after engine repairs: injector connectors crossed (cylinders 5-7 / 6-8)1
- Slight roughness at idle with no DTCs (possible characteristic)1
- Passlock theft deterrent: starts then stalls / no-start with security lamp4
- Ground Ring Terminal: loose or misadjusted3
- Generator whine in the audio system (new ground for radio and amplifier)1
- Intermittent battery drain from a sticking A/C compressor relay1
- Rear wiper jumps when the fog lamps are turned on (auxiliary ground to rear washer pump)1
- Conversion equipment (not the vehicle as built): Southern Comfort running board courtesy lights overheating - recall 03V-0941
- Trailer brakes applied whenever headlamps or park lamps are on (brake controller jumper harness)1
- Turn signal flashes fast (export flasher relay installed)1
- Engine Control Module: failed1
- Tire recall (not the vehicle as built): Firestone Wilderness LE tread separation - recall 01T-0011500 only4
- Bolt1
- Engine compartment noise with A/C on and A/C inoperative (auxiliary rear A/C: suction hose and compressor)3
- A/C blows warm at extended idle (6.0L: auxiliary electric cooling fan)6.0L only1
- Loss of HVAC mode or temperature control (wiring harness rerouted)1
- Passenger side colder or warmer than the driver's side (HVAC case to cowl seal)1
- Insufficient heat from the rear heater in extreme cold (tee coupling replacement)1
- Encoder Motor: electrical fault, failed2
- Vehicle body tilt or lean left / right (torsion bar front suspension)3
- Aftermarket part (not the vehicle as built): Federal-Mogul National / Carquest replacement wheel hub assembly retention nut - recall 07E-1062WD only1
- Upper control arm bracket alignment (dowel) pin missing at front end alignment1
- Hub Assembly: worn1
- 4L80-E / 4L85-E planetary gear whine in first and second gear2
- 4L60-E slip or no forward engagement right after input housing replacement (service part 17803687)1
- Service 4WD indicator and DTC B2725 (transfer case shift control switch)4WD / AWD only1
- Electronic transfer case stops shifting with no DTC (shift abuse lock out mode, normal)1
- Transfer case speed sensor connector locks bend on disconnect (improved connector)1
- Grind / ratchet noise when shifting into Park in 4LO (characteristic)1
- Transmission: failed2
- OnStar System: failed, software2
- No response when the OnStar button is pressed (DTC B2476): button assembly test values1
- CD Player: software1
- OnStar Hardware: software1
- Purge Solenoid: failed1
Causes with no correction stated (33)
Causes the records name for which no check or repair is stated, in a technical document or in a record. Press one for the records that name it.
- Audio and telematics
- OnStar Vehicle Integration Unit: failed (4)OnStar Theft Notification: design or manufacturing, software (2)GPS: failed (1)
- Body, doors and interior
- Seat Back: loose or misadjusted (4)Head Restraint: design or manufacturing (2)
- Transmission and driveline
- Transfer Case: failed (4)Locking Rear Differential (2)Rear Axle: failed (2)Axle Differential Seal: leaking (1)Driveshaft (1)
- Electrical, wiring and power
- ATC Fuse: electrical fault, failed (2)Battery: broken (1)Cable: broken (1)Fuse: failed (1)
- Heating and air conditioning
- Air Conditioning Control Head: failed (1)Air Conditioning Low Pressure Switch: design or manufacturing (1)Blower Motor: failed (1)Evaporator Coil: clogged or contaminated (1)
- Airbags and seat belts
- Airbag: design or manufacturing (1)Airbag Sensor: failed (1)Seat Belt Buckle: clogged or contaminated (1)
- Suspension, wheels and tires
- Automatic Level Control: clogged or contaminated (1)Rear Axle Retainer Button: broken (1)
- Instruments and lighting
- Bulb: electrical fault (1)
The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.
FaultCrate・GMC Yukon 2000–2006・2000
Candidate cause (the documents say what to do)
Rear bank knock sensor corrosion from water intrusion (P0332)
Applies to: 4.8L, 5.3L, 6.0L only
Customers may report mild to severe engine ping (spark knock), usually worse during acceleration, and/or an illuminated MIL.
The technician may find DTC P0332 set.
How to tell
P0327P0332Check engine / Service Engine Soon
What to do
- If P0327 and P0332 set at the same time, inspect for poor connections at the two-wire knock sensor harness located at the left rear side of the intake manifold near the top, just under the cover.
- Check the resistance of the knock sensors including the harness before reinstalling the intake manifold.
- Replace the rear bank knock sensor and build an RTV dam around the sensor to divert water away from it.
Caution: Do not form the RTV into a complete circle; leave the rear section open.
What is needed
- Parts and materials
- Rear bank knock sensor
- RTV (to build a dam around the sensor that diverts water)
- Labor time
- Not stated
- Special tools
- Not stated
- Scan tool
- Not stated
Only what the technical documents state. "Not stated" does not mean not needed.
In the records
No record states work done for this cause.
See the evidence (1 technical documents, 3 records)
Passages of the technical documents
The bulletin covers 1999-2002 Chevrolet and GMC C/K pickup and utility models, including Yukon, Yukon XL, Yukon Denali and Yukon Denali XL, with the 4.8L, 5.3L or 6.0L engine.
1999-2002 Chevrolet and GMC C/K Pickup and Utility Models (Avalanche, Silverado, Sierra, Tahoe, Suburban, Yukon, Yukon XL, Yukon Denali, Yukon Denali XL) with 4.8L, 5.3L or 6.0L Engine
General Motors (copy hosted by Corvette Action Center)
Customers may report mild to severe engine ping (spark knock), usually worse during acceleration, and/or an illuminated MIL.
Some customers may comment on a mild to severe engine ping (commonly referred to as spark knock), usually worse during acceleration and/or an illuminated MIL.
General Motors (copy hosted by Corvette Action Center)
The technician may find DTC P0332 set.
Upon investigation, the technician may find DTC P0332 set.
General Motors (copy hosted by Corvette Action Center)
The condition may result from corrosion of the rear bank knock sensor caused by water intrusion into the sensor cavity.
This condition may be the result of corrosion of the rear bank knock sensor due to water intrusion into the sensor cavity.
General Motors (copy hosted by Corvette Action Center)
A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.
Put together by FaultCrate from public records and technical documents. The cause and the repair are for the workshop to decide with the vehicle in front of it. Counts are records, not failure rates.