Skip to content
FaultCrate
日本語

This is an open preview: every record can be read without an account.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

Common on this vehicle:NoiseWarning lightDoes not startVibration or shudder

Record by record

10 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.

Symptom

Component named as the cause

A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.

Read the records one by one (10)

Known issuesService Stability message with DTC C0131, C0196, C0290 and/or C02922

  1. Manufacturer communication2004–2006 GMC YUKON ・ 2005-05-13

    Service Stability Message, DTC C0131, C0196, C0290 and/or C0292

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      SERVICE STABILITY MESSAGE ON, DIAGNOSTIC TROUBLE CODE (DTC) C0131, C0196, C0290 AND/OR C0292 SET. *TT

    Read the sentences of the record
    Remedy
    SERVICE STABILITY MESSAGE ON, DIAGNOSTIC TROUBLE CODE (DTC) C0131, C0196, C0290 AND/OR C0292 SET. *TT

  2. Manufacturer communication2004–2005 GMC YUKON ・ 2005-04-21

    Service Stability Message Displayed in DIC

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      SERVICE STABILITY MESSAGE DISPLAYED IN THE DIC. DIAGNOSTIC TROUBLE CODES C0290, C0292, C0131, OR C0196 SET IN THE EBCM. *TT

    Read the sentences of the record
    Remedy
    SERVICE STABILITY MESSAGE DISPLAYED IN THE DIC. DIAGNOSTIC TROUBLE CODES C0290, C0292, C0131, OR C0196 SET IN THE EBCM. *TT

Known issuesIntermittent no start with Service Stability, ABS light, 'Unknown Driver' and multiple DTCs / no module communication1

  1. Manufacturer communication2003–2006 GMC YUKON ・ 2003-12-05

    Intermittent No Start, Stability Message, ABS Light

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      INTERMITTENT NO START, SERVICE STABILITY MESSAGE, ANTI-LOCK BRAKE SYSTEM (ABS) LIGHT ILLUMINATED, MULTIPLE DIAGNOSTIC TROUBLE CODES (DTCS), DIC SHOWS UNKNOWN DRIVER, VARIOUS ELECTRICAL RELATED CONDITIONS. INCLUDES ESCALADE ESV AND EXT MODEL. *TT

    Read the sentences of the record
    Remedy
    INTERMITTENT NO START, SERVICE STABILITY MESSAGE, ANTI-LOCK BRAKE SYSTEM (ABS) LIGHT ILLUMINATED, MULTIPLE DIAGNOSTIC TROUBLE CODES (DTCS), DIC SHOWS UNKNOWN DRIVER, VARIOUS ELECTRICAL RELATED CONDITIONS. INCLUDES ESCALADE ESV AND EXT MODEL. *TT

Known issuesStability System Disabled / Service Stability message with DTC C0455 (bent terminals at the steering wheel position sensor)1

  1. Manufacturer communication2005 GMC FULL SIZE UTILITIES (YUKON) ・ 2005-07-01

    Stability System Disabled / Service Stability message with DTC C0455: bent terminals at the steering wheel position sensor

    1. 1Fault

      • Owners may comment on a Stability System Disabled or Service Stability message with DTC C0455.

    2. 2Finding the cause

      Possible causes

      • The concern may be caused by bent terminals on the SWPS (Steering Wheel Position Sensor).

      Steps to confirm (in the document’s order)

      • Remove the SWPS connector and inspect for bent terminals.

    3. 3Correction

      Repair

      • In most cases the terminals can be straightened without replacing the sensor.
    Read the sentences of the record

    From the manufacturer’s document

    • Applies to：Applies to 2005 Cadillac, Chevrolet and GMC Full Size Utilities with RPO JL4.
    • Condition：Owners may comment on a Stability System Disabled or Service Stability message with DTC C0455.
    • Cause：The concern may be caused by bent terminals on the SWPS (Steering Wheel Position Sensor).
    • Confirm：Remove the SWPS connector and inspect for bent terminals.
    • Repair：In most cases the terminals can be straightened without replacing the sensor.

    Open this issue of GM TechLink ↗ The points above are read from an article of TechLink, GM’s monthly publication for dealership technicians. The article itself is not reproduced here.

    Remedy
    Stability System This information applies to 2005 Cadillac, Chevrolet, and GMC Full Size Utilities with RPO JL4. Owners may comment on a Stability System Disabled or Service Stability message with DTC C0455. This concern may be caused by bent terminals on the SWPS (Steering Wheel Position Sensor). Remove the SWPS connector and inspect for bent terminals. In most cases, the terminals can be straightened without having to replace the sensor.

Known issuesStability System Disabled message and unwanted StabiliTrak activation (tire wear or mismatched tires)1

  1. Manufacturer communication2002–2006 GMC YUKON ・ 2006-07-01

    Stability System Disabled message and unwanted StabiliTrak activation: check tire wear and mismatch

    1. 1Fault

      • The Driver Information Center (DIC) may display the Stability System Disabled message.
      • Other concerns are unwanted Stabilitrak activation, noticeable dimming of the vehicle lighting systems, and the VSES motor coming on unexpectedly.

    2. 2Finding the cause

      Possible causes

      • One example that could cause these conditions is two brand new tires with the other two tires excessively worn.
      • Another example is aftermarket wheels and tires, such as non-OEM 20 inch wheels with sand tires.

      Steps to confirm (in the document’s order)

      • Check for excessive wear on the tires and verify that all the tires are the same size, brand and model.

    3. 3Correction

      Stabilitrak Disable Message This information applies to the 2002-06 Cadillac Escalade, Chevrolet Avalanche, Suburban, Tahoe, GMC Yukon and Denali with RPO JL4. - Stability System Disabled message displayed on the Driver Information Center (DIC) - unwanted Stabilitrak activation - vehicle lighting systems may dim noticeably - VSES motor may come on unexpectedly Check for excessive wear on the tires on the vehicle and verify that all the tires are the same size, brand, and model. The following examples could cause any of the conditions listed above. - two tires on the vehicle are brand new and the other two tires have excessive wear - Aftermarket wheels and tires (non-OEM 20 inch wheels with sand tires)

      What the documents say to do

      Stability System Disabled message and unwanted StabiliTrak activation (tire wear or mismatched tires)

      Confirm

      • Check for excessive wear on the tires and verify that all the tires are the same size, brand and model.
    Read the sentences of the record

    From the manufacturer’s document

    • Applies to：The information applies to 2002-06 Cadillac Escalade, Chevrolet Avalanche, Suburban, Tahoe, GMC Yukon and Denali with RPO JL4.
    • Condition：The Driver Information Center (DIC) may display the Stability System Disabled message.
    • Condition：Other concerns are unwanted Stabilitrak activation, noticeable dimming of the vehicle lighting systems, and the VSES motor coming on unexpectedly.
    • Confirm：Check for excessive wear on the tires and verify that all the tires are the same size, brand and model.
    • Cause：One example that could cause these conditions is two brand new tires with the other two tires excessively worn.
    • Cause：Another example is aftermarket wheels and tires, such as non-OEM 20 inch wheels with sand tires.

    Open this issue of GM TechLink ↗ The points above are read from an article of TechLink, GM’s monthly publication for dealership technicians. The article itself is not reproduced here.

    Remedy
    Stabilitrak Disable Message This information applies to the 2002-06 Cadillac Escalade, Chevrolet Avalanche, Suburban, Tahoe, GMC Yukon and Denali with RPO JL4. - Stability System Disabled message displayed on the Driver Information Center (DIC) - unwanted Stabilitrak activation - vehicle lighting systems may dim noticeably - VSES motor may come on unexpectedly Check for excessive wear on the tires on the vehicle and verify that all the tires are the same size, brand, and model. The following examples could cause any of the conditions listed above. - two tires on the vehicle are brand new and the other two tires have excessive wear - Aftermarket wheels and tires (non-OEM 20 inch wheels with sand tires)

ELECTRICAL SYSTEM2

  1. Manufacturer communication2005 GMC YUKON ・ 2005-10-24

    Stability System Disabled or Service Stability Message with DTC C0455

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      STABILITY SYSTEM DISABLED OR SERVICE STABILITY MESSAGE WITH DIAGNOSTIC TROUBLE CODE C0455. *TT

    Read the sentences of the record
    Remedy
    STABILITY SYSTEM DISABLED OR SERVICE STABILITY MESSAGE WITH DIAGNOSTIC TROUBLE CODE C0455. *TT

  2. Manufacturer communication2004–2005 GMC YUKON ・ 2005-04-19

    Service Stability Message Displayed

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      SERVICE STABILITY MESSAGE DISPLAYED. *EH

    Read the sentences of the record
    Remedy
    SERVICE STABILITY MESSAGE DISPLAYED. *EH

ELECTRONIC STABILITY CONTROL2

  1. Manufacturer communication2003–2005 GMC YUKON ・ 2004-08-23

    StabiliTrak Malfunction or Disable Message on DIC

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      UNWANTED STABILITRAK ACTIVATION OR STABILITRAK DISABLE MESSAGE APPEARS ON THE DIC. *TT

    Read the sentences of the record
    Remedy
    UNWANTED STABILITRAK ACTIVATION OR STABILITRAK DISABLE MESSAGE APPEARS ON THE DIC. *TT

  2. Owner complaint2005 GMC YUKON ・ 2005-09-09

    StabiliTrak system caused vehicle lockup at 45 MPH

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

      Not stated

    Read the sentences of the record
    Fault
    I WAS DRIVING APPROXIMATELY 45 MPH (= 72.4 km/h) ON MY NORMAL ROUTE, A FAIRLY STRAIGHT ROUTE, WHEN THE VEHICLE MADE A LOUD GRINDING NOISE, BECAME IMPOSSIBLE TO MANEUVER, AND TOTALLY LOCKED UP. (1 more)
    Inspection
    THE DEALERSHIP WAS UNABLE TO PINPOINT THE CAUSE OF MALFUNCTION.

SERVICE BRAKES1

  1. Owner complaint2005 GMC YUKON DENALI ・ 2012-08-15

    SERVICE STABILITY warning with intermittent ABS grab causing shaking and speed loss

    1. 1Fault

    2. 2Finding the cause

      I THOUGHT THAT MAYBE IT WAS FLUKE ISSUE THAT COULD BE EXPLAINED BY WEATHER AS WE HAD EXCEPTIONALLY HOT SUMMER THUS FAR.

    3. 3Correction

      Not stated

    Read the sentences of the record
    Fault
    THE VEHICLE DISPLAY INDICATES "SERVICE STABILITY" AND THE VEHICLES ABS SYSTEM BEGINS TO GRAB INTERMITTENTLY CAUSING THE VEHICLE TO SHAKE AND LOSE SPEED DRASTICALLY. (1 more)
    Cause
    I THOUGHT THAT MAYBE IT WAS FLUKE ISSUE THAT COULD BE EXPLAINED BY WEATHER AS WE HAD EXCEPTIONALLY HOT SUMMER THUS FAR.