GMC Yukon 2000–2006
Common on this vehicle:Gauge or instrument faultLeakStalls or shuts offWarning lightCorrosion or rustMisfire or rough idleDoes not startSmoke or fire
Record by record
4 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.
Symptom
Component named as the cause
Work done
How it is said to have ended
- result not stated3
A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.
Read the records one by one (4)
Known issuesAftermarket part (not the vehicle as built): Fram G3727 replacement fuel filter connector - recall 06E-0431
Recall2000–2005 GMC YUKON ・ —
Fram Replacement Fuel Filters (P/N G3727) Recall
1Fault
- The connector on the fuel filter was not manufactured to specification, so the O-ring may not seat correctly on the fuel line; this may cause an inadequate seal, potentially leading to a fuel leak (wetting or dripping) and possible vehicle fire.
2Finding the cause
Steps to confirm (in the document’s order)
- The part number (G3727), country of origin (Mexico) and the date code (e.g., X60031) are located on the side of the fuel filter.
3Correction
Repair
- Honeywell will replace the subject fuel filters at no charge to the customer.
Read the sentences of the record
From the manufacturer’s document
- Applies to:This is an equipment recall of fuel filters manufactured by Interfil in Mexico and sold by Honeywell under the FRAM brand name, part number G3727, intended for aftermarket installation on the vehicle applications in the attached table.
- Applies to:Only filters with date codes X52911 through X60801 sequentially or X600141, and with a Mexico country of origin marking on the filter housing, are subject to the recall.
- Applies to:The application table lists YUKON 1992 - 2005, YUKON DENALI 2005, YUKON DENALI XL 2005, YUKON XL 1500 2000 - 2005 and YUKON XL 2500 2000 - 2005.
- Condition:The connector on the fuel filter was not manufactured to specification, so the O-ring may not seat correctly on the fuel line; this may cause an inadequate seal, potentially leading to a fuel leak (wetting or dripping) and possible vehicle fire.
- Confirm:The part number (G3727), country of origin (Mexico) and the date code (e.g., X60031) are located on the side of the fuel filter.
- Repair:Honeywell will replace the subject fuel filters at no charge to the customer.
- Cause
- CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE.
- Remedy
- HONEYWELL WILL NOTIFY OWNERS AND REPLACE THE FUEL FILTERS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 18, 2006. OWNERS MAY CONTACT FRAM CUSTOMER SERVICE AT 1-800-890-2075 (OPTION 1).
- Consequence
- THIS CONDITION MAY CAUSE AN INADEQUATE SEAL AT THE CONNECTION, POTENTIALLY LEADING TO A FUEL LEAK. IN THE PRESENCE OF AN IGNITION SOURCE, A FIRE COULD OCCUR.
Known issuesFuel pressure regulator buzz / hum after replacement (check fuel pump feed voltage drop and connector crimps)1
Manufacturer communication2000–2003 GMC YUKON DENALI ・ 2017-08-15
Buzz Noise at Idle After Fuel Pressure Regulator Replacement
1Fault
2Finding the cause
Not stated
3Correction
Read the sentences of the record
- Remedy
- This Preliminary Information communication provides information to the technician about vehicles that may have a buzz noise at idle after fuel pressure regulator replacement. Technician will need to gain access to the fuel pump. After gaining access to the fuel pump check the power and ground for voltage drop with the key in the off from the fuel pump to the battery post. Technician should also check the pin fit and terminal drag. Technician may replace the fuel pump connector with the updated part using the latest version service bulletin 04-06-04-088C. Technician should inspect voltage drop points at the UBEC, fuel pump relay, ground at the frame and the battery cable grounds. If excessive resistance is found at the crimps, replace the crimp n seal splice sleeves for the affected circuits. If the circuits do not have high resistance replace the regulator using part number 19236428.
ELECTRICAL SYSTEM1
Owner complaint2003 GMC YUKON ・ 2004-11-03
Fuel pump failure and steering jamming while driving and towing
1Fault
2Finding the cause
Not stated
3Correction
Read the sentences of the record
- Fault
- PRIOR TO STALLING THERE WAS SOME HESITATION AND JERKING AS IF NOT GETTING FUEL TO ENGINE. (3 more)
- Remedy
- THE DEALER TOOK VEHICLE TO DEALERSHIP IN ARIZONA, AND FUEL PUMP HAD TO BE REPLACED. (1 more)
FUEL SYSTEM, GASOLINE1
Owner complaint2001 GMC YUKON DENALI ・ 2007-11-22
Fuel tank makes popping noise after engine shutdown
1Fault
2Finding the cause
Not stated
3Correction
Read the sentences of the record
- Fault
- FUEL TANK MAKES A POPPING NOISE WITHIN 5 MINUTES OF TURNING ENGINE OFF.
- Remedy
- FUEL TANK CAP REPLACED. *TR

