Skip to content
FaultCrate
日本語

This is an open preview: every record can be read without an account.

GMC Yukon XL 2000–2006

GMC Yukon XLModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

The vehicle (where a record says)

A record is under an engine, a drive or a series only where it says so: the characters of the vehicle identification number filed with a complaint, its text, or what its document says it applies to. A record that does not say is kept as "not stated". The filed numbers and the documents do not tell 4WD from AWD.

Common on this vehicle:Warning lightLoss of engine power, no accelerationMisfire or rough idleStalls or shuts offGauge or instrument faultHard start or long crankLeakDoes not start

issuenoneRemove

Possible causes

Gauge or instrument fault, Check engine / Service Engine Soon5 records
Engine
Exhaust and emissions
Electrical, wiring and power
Fuel system
Instruments and lighting
1Mass Air Flow Sensor: failed0Crankshaft position sensor may work intermittently or fail (8.1L V8) - recall 07V-5218.1L only0Intake manifold gasket leak (cold idle misfire, lean codes)0Single-cylinder misfire (P0300-P0308) and/or chirp, squeak or tick at camshaft speed: worn cam lobe / lifter, valve or valve spring0P0300 after engine repairs: injector connectors crossed (cylinders 5-7 / 6-8)0Rear bank knock sensor corrosion from water intrusion (P0332)4.8L, 5.3L, 6.0L only1Purge Solenoid: failed0P0420 / P0430 on a new or just-replaced catalytic converter (break-in not completed)0Intermittent MIL, service lamps/messages or DTCs from connector fretting corrosion0Reduced Engine Power from throttle body connector crimp, broken wire or grounds0Slow or short fuel fill, inaccurate fuel gauge (2500: fuel tank vent)2500 only0Fuel gauge reads low or drops to empty in Park / Neutral (normal characteristic)0Out of fuel with the gauge reading above empty, cranks but no start, stall (replace the fuel sensor, not the sender module)0Fuel module reservoir assembly: fuel pump wire connectors may overheat - recall 05V-1551500 only0DTC P0446 set with the SES lamp on (replace the EVAP vent solenoid, not the canister)0Instrument panel cluster gauges stick, flutter or stop working0Speedometer needle appears inaccurate (specification +/- 2 MPH)0Voltmeter fluctuates between 12 and 14 volts (Regulated Voltage Control, normal)
1 causes not drawn

The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.

FaultCrate・GMC Yukon XL 2000–2006・Gauge or instrument fault, Check engine / Service Engine Soon

Candidate cause (the documents say what to do)

Purge Solenoid: failed

1 of the records matching this search name this component as the cause.

How to tell

P0442Check engine / Service Engine Soon

What to do

No technical document states a check or a repair.

In the records

  • Purge Solenoid: replaced 1
See the evidence (0 technical documents, 1 records)

Records

None among the records that can be opened now.

See all 1 records of this cause →

A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.

Put together by FaultCrate from public records and technical documents. The cause and the repair are for the workshop to decide with the vehicle in front of it. Counts are records, not failure rates.