Skip to content
FaultCrate
日本語Open preview: everything readable

This is an open preview: every record can be read without an account. The details of the plans are in preparation.

GMC Yukon XL 2000–2006

GMC Yukon XLModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

The vehicle (where a record says)

A record is under an engine, a drive or a series only where it says so: the characters of the vehicle identification number filed with a complaint, its text, or what its document says it applies to. A record that does not say is kept as "not stated". The filed numbers and the documents do not tell 4WD from AWD.

Common on this vehicle:Warning lightNoiseCorrosion or rustABS activates (at low speed and the like)Reduced brakingParking brakeLoss of engine power, no accelerationVibration or shudder

Record by record

2 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.

Symptom

Component named as the cause

A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.

Read the records one by one (2)

Known issuesUnwanted ABS activation at low speed (front wheel speed sensor mounting corrosion)1

  1. Owner complaint2001 GMC YUKON XL DENALI ・ 2012-01-19

    ABS engages and lifts brake pedal while slowing to a stop

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

      Not stated

      What the documents say to do

      Unwanted ABS activation at low speed (front wheel speed sensor mounting corrosion)

      Confirm

      • The reading should be at least 350 mV AC; if it is less, the wheel speed sensor must be replaced.

      Repair

      1. Dealers remove the sensor, clean its mounting surface on the bearing, apply rust inhibitor and grease, reinstall it and check peak-to-peak output voltage.
      2. The passage heading states that the repair is cleaning the wheel speed sensor mounting surface.

      Caution

      • Do not pry the sensor out of the bore; prying breaks the sensor body off in the bore.
    Read the sentences of the record
    Fault
    AS VEHICLE IS SLOWING TO A STOP, THE ABS ENGAGES LIFTS THE BRAKE PEDAL, ESSENTIALLY ALLOWING THE VEHICLE TO ROLL FORWARD, AND REQUIRING A QUICK REACTION TO STRONGLY DEPRESS THE BRAKE PEDAL TO STOP THE VEHICLE.
    Cause
    THIS IS CAUSED BY A FAULTY AND CORRODED ABS SPEED SENSOR, WHICH HAS BEEN RECALLED ON THESE VEHICLES FROM 2002, BUT THE RECALL DOES NOT INCLUDE THE 2001 YEAR.

SERVICE BRAKES1

  1. Owner complaint2001 GMC YUKON XL ・ 2013-05-05

    ABS indicator light on and motor sound continues

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      WE UNPLUGGED THE BATTERY SO IT WOULD NOT RUN DOWN.

    Read the sentences of the record
    Fault
    OUR DASHBOARD ABS INDICATOR LIGHT CAME ON. (1 more)
    Remedy
    WE UNPLUGGED THE BATTERY SO IT WOULD NOT RUN DOWN.