GMC Yukon XL 2000–2006
Common on this vehicle:Warning light
Possible causes
6 causes not drawn
- ABS lamp with DTC C0265 (EBCM motor relay circuit) after EBCM replacement0
- Throttle body carbon build-up: idle surge, reduced engine power, throttle DTCs (high mileage)0
- SIR lamp on and inside mirror temperature/compass display inoperative (open air bag fuse, circuit 1139 shorted to ground)0
- Air bag (SIR) lamp on with DTC B1001 after BCM or SDM replacement0
- Autoride (Z55) Service Ride Control / Service Suspension System message0
- Aftermarket part (not the vehicle as built): Federal-Mogul National / Carquest replacement wheel hub assembly retention nut - recall 07E-1062WD only0
Causes with no correction stated (2)
Causes the records name for which no check or repair is stated, in a technical document or in a record. Press one for the records that name it.
The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.
FaultCrate・GMC Yukon XL 2000–2006・Warning light, C0201
Candidate cause (the documents say what to do)
ABS light with C0265/C0201/U1041 or no communication with brake module (EBCM ground G110)
Upon inspection, DTCs C0265 and C0201 may be set in the brake module.
There may also be a loss of communication with the brake module.
How to tell
C0201C0265U1041ABS light
What to do
- The EBCM ground is on the frame beneath the driver's door; among several grounds it is the heavy 12-gauge wire.
- The battery-cable-to-frame ground can cause similar ABS symptoms and can be checked as well.
- Clean the area, front and back, using a tool such as a Scotch-Brite Roloc disc or equivalent.
- Use the bolts, washers and nuts specified in the bulletin because of their conductive finish.
- Cover the front and back of the repair area with rubberized undercoating.
Caution: Do not replace the brake module for this condition; do the ground repair before further EBCM diagnosis.
What is needed
- Parts and materials
- The bolts, washers and nuts specified in the bulletin (for their conductive finish)
- Rubberized undercoating (to cover the front and back of the repair area)
- Labor time
- Not stated
- Special tools
- Not stated
- Scan tool
- Not stated
Only what the technical documents state. "Not stated" does not mean not needed.
In the records
- Electronic Brake Control Module Ground: adjusted 1
See the evidence (1 technical documents, 1 records)
Passages of the technical documents
The bulletin lists 2000-2006 GMC Yukon, Yukon Denali and Yukon XL.
2000–2006 GMC Yukon, Yukon Denali, Yukon XL
General Motors (third-party hosted copy at simple-engineering.com) 2009-03-11
Upon inspection, DTCs C0265 and C0201 may be set in the brake module.
Some customers may comment that the ABS light is on. Upon further inspection, DTCs C0265 and C0201 may be set in the brake module.
General Motors (third-party hosted copy at simple-engineering.com) 2009-03-11
DTC U1041 can also set in other modules.
It is also possible for DTC U1041 to set in other modules.
General Motors (third-party hosted copy at simple-engineering.com) 2009-03-11
There may also be a loss of communication with the brake module.
There may also be a loss of communication with the brake module.
General Motors (third-party hosted copy at simple-engineering.com) 2009-03-11
Records
- ABS Light On with DTCs C0265, C0201, U1041 and Others Manufacturer communication 2007-08-15
A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.
Put together by FaultCrate from public records and technical documents. The cause and the repair are for the workshop to decide with the vehicle in front of it. Counts are records, not failure rates.