Skip to content
FaultCrate

This is an open preview: every record can be read without an account.

GMC Yukon XL 2000–2006

GMC Yukon XLModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

The vehicle (where a record says)

A record is under an engine, a drive or a series only where it says so: the characters of the vehicle identification number filed with a complaint, its text, or what its document says it applies to. A record that does not say is kept as "not stated". The filed numbers and the documents do not tell 4WD from AWD.

Common on this vehicle:NoiseVibration or shudderAir conditioning or heaterLeakLoss of engine power, no accelerationLiftgate, rear glass or door lockWarning lightReduced braking

Possible causes

Warning light, Steering4 records
Electrical, wiring and power
Other
Suspension, wheels and tires
Brakes
Transmission and driveline
Engine
1Reduced Engine Power from throttle body connector crimp, broken wire or grounds0Intermittent battery lamp with history DTC B1489 after BGCM replacement (module not SPS programmed)0Intermittent MIL, service lamps/messages or DTCs from connector fretting corrosion1Bolt: loose or misadjusted1Hub Assembly: failed0Autoride (Z55) Service Ride Control / Service Suspension System message0Aftermarket part (not the vehicle as built): Federal-Mogul National / Carquest replacement wheel hub assembly retention nut - recall 07E-1062WD only0Brake pipe (brake line) corrosion and rupture0ABS light with C0265/C0201/U1041 or no communication with brake module (EBCM ground G110)0Front right-hand brake pipe contact with body cross sill - recall 00V-3450Service Brake Booster message on a Hydroboost vehicle with DTC C0136 (instrument cluster not SPS programmed)0Stability System Disabled / Service Stability message with DTC C0455 (bent terminals at the steering wheel position sensor)0Transfer case service light, New Venture Gear transfer case (replace the encoder motor sensor and reprogram the TCCM)0Crankshaft position sensor may work intermittently or fail (8.1L V8) - recall 07V-5218.1L only0Intake manifold gasket leak (cold idle misfire, lean codes)0Single-cylinder misfire (P0300-P0308) and/or chirp, squeak or tick at camshaft speed: worn cam lobe / lifter, valve or valve spring0P0300 after engine repairs: injector connectors crossed (cylinders 5-7 / 6-8)0Rear bank knock sensor corrosion from water intrusion (P0332)4.8L, 5.3L, 6.0L only
7 causes not drawn
Causes with no correction stated (2)

Causes the records name for which no check or repair is stated, in a technical document or in a record. Press one for the records that name it.

The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.

Candidate cause (named by records only; no technical document)

Bolt: loose or misadjusted

1 of the records matching this search name this component as the cause.

How to tell

ABS light

What to do

No technical document states a check or a repair.

In the records

  • Bolt: adjusted 1(result not stated: 1)
See the evidence (0 technical documents, 1 records)

A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.