GMC Yukon 2000–2006
Common on this vehicle:Warning lightNoiseLeakCorrosion or rustMisfire or rough idleAir conditioning or heaterSeat beltParking brake
Record by record
6 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.
Component named as the cause
How it is said to have ended
- result not stated3
A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.
Read the records one by one (6)
Known issuesUnwanted ABS activation at low speed (front wheel speed sensor mounting corrosion)3
Owner complaint2001 GMC YUKON ・ 2005-12-16
ABS activates at low speeds, extending stopping distance
1Fault
2Finding the cause
Not stated
3CorrectionNot repaired
THE VEHICLE HAS NOT BEEN REPAIRED AT THIS TIME DUE TO THE EXCESSIVE EXPENSE.
What the documents say to do
Unwanted ABS activation at low speed (front wheel speed sensor mounting corrosion)Confirm
- The reading should be at least 350 mV AC; if it is less, the wheel speed sensor must be replaced.
Repair
- Dealers remove the sensor, clean its mounting surface on the bearing, apply rust inhibitor and grease, reinstall it and check peak-to-peak output voltage.
- The passage heading states that the repair is cleaning the wheel speed sensor mounting surface.
Caution
- Do not pry the sensor out of the bore; prying breaks the sensor body off in the bore.
Read the sentences of the record
- Fault
- *AK UPDATE 1/11/2006 - THE ABS ACTIVATED AT LOW SPEEDS RESULTING IN EXTENDED STOPPING DISTANCE. *NM
- Remedy
- THE VEHICLE HAS NOT BEEN REPAIRED AT THIS TIME DUE TO THE EXCESSIVE EXPENSE.
Owner complaint2001 GMC YUKON ・ 2005-05-24
ABS activates at low speed, causing extended stopping distances
1Fault
2Finding the cause
Not stated
3Correction
Read the sentences of the record
- Fault
- DT: CONTACT STATES THE ABS COMES ON WHILE DRIVING APPROXIMATELY 5 MPH (= 8.05 km/h), CAUSING THE MANUAL BRAKES TO PUMP AT LOW SPEED, LEADING TO EXTENDED STOPPING DISTANCES. (1 more)
- Remedy
- THE SERVICE DEALER REPLACED THE RIGHT FRONT HUB AND THE SENSOR.
Owner complaint2001 GMC YUKON ・ 2006-01-11
ABS activated at low speeds; wheel speed sensor replaced twice
1Fault
2Finding the cause
Not stated
3Correction
SERVICE BRAKES, HYDRAULIC3
Owner complaint2001 GMC YUKON ・ 2005-07-31
ABS activation caused swerving during braking over railroad tracks
1Fault
2Finding the cause
Not stated
3CorrectionNot repaired
Read the sentences of the record
- Fault
- I WAS GOING ABOUT 25-30 MPH (= 40.2–48.3 km/h).
- Remedy
- NOTHING HAS BEEN DONE TO FIX THIS PROBLEM. *NM
- Consequence
- I HIT THE GUARD RAIL WITH THE RIGHT FRONT QUARTER CAUSING $3500 IN DAMAGE.
Owner complaint2001 GMC YUKON ・ 2005-10-03
ABS brakes engaged at low speeds
1Fault
2Finding the cause
Not stated
3CorrectionNot repaired
Read the sentences of the record
- Fault
- DT: THE CONSUMER STATED THAT THE ABS BRAKES ENGAGED AT LOW SPEEDS, 25 MPH (= 40.2 km/h). (1 more)
- Remedy
- BUT, DID NOT HAVE THE VEHICLE FIXED.
Owner complaint2001 GMC YUKON ・ 2005-09-29
ABS light on and ABS motor running continuously while driving
1Fault
2Finding the cause
3Correction
Read the sentences of the record
- Fault
- DT: WHILE DRIVING ON THE INTERSTATE THE OWNER SAW THE ABS LIGHT COME ON AND DIDN'T KNOW WHAT IT WAS. (2 more)
- Remedy
- THE MECHANIC UNHOOKED THE ABS MOTOR.
1 owner complaints have no classified sentences yet, so their causes and repairs are not picked out. Their text is in the list of records.