GMC Yukon 2000–2006
Common on this vehicle:Reduced brakingCorrosion or rustNoiseParking brake
Record by record
2 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.
Component named as the cause
How it is said to have ended
- result not stated5
A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.
Read the records one by one (2)
Known issuesBrake pipe (brake line) corrosion and rupture1
Owner complaint2002 GMC YUKON ・ 2013-06-17
Brake pedal goes to floor when applied at 30 MPH
1Fault
2Finding the cause
3Correction
Read the sentences of the record
- Fault
- BRAKE PEDAL WENT TO THE FLOOR WHEN APPLIED AT 30 MPH (= 48.3 km/h).
- Remedy
- BRAKE HOSE NUTS RUSTED TO CALIPERS, COULD NOT BE REMOVED, REQUIRING 2 CALIPERS TO BE REPLACED. *TR
SERVICE BRAKES, HYDRAULIC1
Owner complaint2001 GMC YUKON DENALI ・ 2008-07-08
Continuous braking problems with ABS and brake lights
1Fault
2Finding the cause
Not stated
3Correction
Read the sentences of the record
- Fault
- CONTINUOUS BRAKING PROBLEMS. (2 more)
- Remedy
- I UNDERSTAND NORMAL WEAR AND TEAR, HOWEVER I HAVE HAD TO REPLACE MY FRONT ROTORS, CALIPERS, BRAKES, EMERGENCY BRAKE SYSTEM ON SEVERAL OCCASIONS.
- Inspection
- I HAVE HAD A GMC DEALERSHIP (FOLSOM GMC) AND LES SCHWAB PERFORM DIAGNOSTIC CHECKS TO ONLY TELL ME THAT I NEED TO REPLACE BRAKE PADS AND CALIPERS AGAIN DUE TO WEAR. (1 more)