Skip to content
FaultCrate
日本語

This is an open preview: every record can be read without an account.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

The vehicle (where a record says)

A record is under an engine, a drive or a series only where it says so: the characters of the vehicle identification number filed with a complaint, its text, or what its document says it applies to. A record that does not say is kept as "not stated". The filed numbers and the documents do not tell 4WD from AWD.

Common on this vehicle:Gauge or instrument faultWarning lightNoiseLeakMisfire or rough idleAir conditioning or heaterCorrosion or rustVibration or shudder

Possible causes

Warning light, 2004116 records
Engine
Exhaust and emissions
Airbags and seat belts
Suspension, wheels and tires
Brakes
Transmission and driveline
10Intake manifold gasket leak (cold idle misfire, lean codes)7Single-cylinder misfire (P0300-P0308) and/or chirp, squeak or tick at camshaft speed: worn cam lobe / lifter, valve or valve spring1P0300 after engine repairs: injector connectors crossed (cylinders 5-7 / 6-8)1Coil Harness: design or manufacturing5P0420 / P0430 on a new or just-replaced catalytic converter (break-in not completed)1Purge Solenoid: failed1Oxygen Sensor: failed2Seat Belt Buckle: clogged or contaminated, failed1SIR lamp on and inside mirror temperature/compass display inoperative (open air bag fuse, circuit 1139 shorted to ground)1Air bag (SIR) lamp on with DTC B1001 after BCM or SDM replacement1Seat Belt Warning Light: failed2Autoride (Z55) Service Ride Control / Service Suspension System message1Aftermarket part (not the vehicle as built): Federal-Mogul National / Carquest replacement wheel hub assembly retention nut - recall 07E-1062WD only1Brake pipe (brake line) corrosion and rupture1ABS light with C0265/C0201/U1041 or no communication with brake module (EBCM ground G110)1Service Brake Booster message on a Hydroboost vehicle with DTC C0136 (instrument cluster not SPS programmed)0ABS lamp with DTC C0265 (EBCM motor relay circuit) after EBCM replacement0Stability System Disabled message and unwanted StabiliTrak activation (tire wear or mismatched tires)14WD/AWD lamps and system inoperative: "sleepy" New Venture Gear transfer case control module (reprogram the TCCM)4WD / AWD only1Transfer Case Speed Sensor Wiring Harness: electrical fault
6 causes not drawn
Causes with no correction stated (4)

Causes the records name for which no check or repair is stated, in a technical document or in a record. Press one for the records that name it.

Brakes
Wheel Speed Sensor: failed (2)Service Stability message with DTC C0131, C0196, C0290 and/or C0292 (1)
Body, doors and interior
Seat Position Sensor: broken (1)
Electrical, wiring and power
Intermittent no start with Service Stability, ABS light, 'Unknown Driver' and multiple DTCs / no module communication (0)

The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.

FaultCrate・GMC Yukon 2000–2006・Warning light, 2004

Candidate cause (the documents say what to do)

Vehicle Communication Interface Module: electrical fault

1 of the records matching this search name this component as the cause.

How to tell

B2455

What to do

No technical document states a check or a repair.

In the records

  • Vehicle Communication Interface Module: repaired 1
See the evidence (0 technical documents, 1 records)

Records

None among the records that can be opened now.

See all 1 records of this cause →

A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.

Put together by FaultCrate from public records and technical documents. The cause and the repair are for the workshop to decide with the vehicle in front of it. Counts are records, not failure rates.