Skip to content
FaultCrate

This is an open preview: every record can be read without an account.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
1 conditions added

The vehicle (where a record says)

A record is under an engine, a drive or a series only where it says so: the characters of the vehicle identification number filed with a complaint, its text, or what its document says it applies to. A record that does not say is kept as "not stated". The filed numbers and the documents do not tell 4WD from AWD.

Common on this vehicle:Warning lightNoiseLeakMisfire or rough idleVibration or shudderAir conditioning or heaterReduced brakingCorrosion or rust

Possible causes

2000752 records
Brakes
Body, doors and interior
Airbags and seat belts
Engine
Fuel system
Steering
21Unwanted ABS activation at low speed (front wheel speed sensor mounting corrosion)10Brake pipe (brake line) corrosion and rupture9Parking brake linings worn out prematurely, parking brake does not hold (PBR single-shoe drum-in-hat)1500 only2ABS light with C0265/C0201/U1041 or no communication with brake module (EBCM ground G110)2Brake Backing Plate: corroded1Front right-hand brake pipe contact with body cross sill - recall 00V-34512Rear door window inoperative (motor replacement)8Power Window: failed, electrical fault6Seat: loose or misadjusted, broken5Loose or missing rear wheelhouse plugs (exhaust gas entry) - recall 00V-3433Door Manual Lock Lever: loose or misadjusted2Center console lid hard to open or close (lubricate the latch)2Door manual lock lever disengages from the door trim panel (lock lever replacement)2Driver's seatback moves during braking (recliner replacement)6Seat Belt: failed2Air bag sensing diagnostic module (SDM) anomaly - recall 02V-1782Second row seat belt retractor does not lock automatically for a child restraint1AIR BAG indicator on with side impact module DTCs (connector CPA replacement)1Air bag (SIR) lamp on with DTC B1001 after BCM or SDM replacement5Engine Block4Increased accelerator pedal effort / throttle body sticks (clean and adjust, do not replace)4.8L, 5.3L, 6.0L only4Single-cylinder misfire (P0300-P0308) and/or chirp, squeak or tick at camshaft speed: worn cam lobe / lifter, valve or valve spring4Cylinder4Roller Rocker: failed, broken5Fuel Pump: failed, leaking3DTC P0446 set with the SES lamp on (replace the EVAP vent solenoid, not the canister)1Aftermarket part (not the vehicle as built): Fram G3727 replacement fuel filter connector - recall 06E-0431Fuel gauge reads low or drops to empty in Park / Neutral (normal characteristic)1Fuel pressure regulator buzz / hum after replacement (check fuel pump feed voltage drop and connector crimps)4.8L, 5.3L, 6.0L only1Fuel Tank: leaking5Steering intermediate shaft clunk1Tire scrub noise on low speed turns (steering rod / centerlink installed backwards)
47 causes not drawn
Causes with no correction stated (33)

Causes the records name for which no check or repair is stated, in a technical document or in a record. Press one for the records that name it.

Instruments and lighting
Bulb: electrical fault (1)

The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.

Candidate cause (the documents say what to do)

Electronic transfer case stops shifting with no DTC (shift abuse lock out mode, normal)

The electronic transfer case may stop shifting and not set any DTCs.

This occurs if the transfer case control module senses repeated shift requests in a short period of time.

What to do

  1. Cycling the ignition off for 30 seconds or more should allow the transfer case to resume normal operation.

What is needed

Parts and materials
Not stated
Labor time
Not stated
Special tools
Not stated
Scan tool
Not stated

Only what the technical documents state. "Not stated" does not mean not needed.

In the records

No record states work done for this cause.

See the evidence (1 technical documents, 1 records)

Passages of the technical documents

  • The information applies to 1999-2007 vehicles including GMC Yukon, Yukon Denali and Yukon XL with RPO NR4, NP1 or NP8 transfer case.

    This information applies to 1999-2007 Cadillac Escalade, Chevrolet Avalanche, Trailblazer, Colorado, Blazer, S10, Silverado, Suburban, Tahoe, GMC Canyon, Envoy, Sierra, Yukon, Yukon Denali, Yukon XL, Jimmy, Sonoma, Suburban, Hummer H2 and H3 with RPO NR4, NP1, or NP8 Transfer Case.

    General Motors 2006-12-01

  • The electronic transfer case may stop shifting and not set any DTCs.

    The electronic transfer case may stop shifting and not set any DTCs.

    General Motors 2006-12-01

  • This occurs if the transfer case control module senses repeated shift requests in a short period of time.

    This condition will occur if the transfer case control module senses repeated shift requests in a short period of time.

    General Motors 2006-12-01

  • The transfer case control module software has a shift abuse lock out mode to protect the module and the encoder motor.

    The software in the transfer case control module has a shift abuse lock out mode to protect the module and encoder motor.

    General Motors 2006-12-01

Read every statement and its source →

Records

None among the records that can be opened now.

See all 1 records of this cause →

A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.