GMC Yukon 2000–2006
Common on this vehicle:Warning lightNoiseLeakCorrosion or rustMisfire or rough idleAir conditioning or heaterSeat beltParking brake
Possible causes
44 causes not drawn
- Violent steering wheel shake or vibration at road speed (brake booster)1
- ABS lamp with DTC C0265 (EBCM motor relay circuit) after EBCM replacement1
- Roller Rocker: failed, broken4
- Rear bank knock sensor corrosion from water intrusion (P0332)4.8L, 5.3L, 6.0L only3
- Accessory drive belt whine (power steering pump pulley repositioned)1500 only1
- Castech cylinder head porosity crack (gradual coolant loss)4.8L, 5.3L only1
- Crankshaft position sensor may work intermittently or fail (8.1L V8) - recall 07V-5218.1L only1
- Intake manifold gasket leak (cold idle misfire, lean codes)1
- Higher than expected engine oil consumption (PCV valve replacement)4.8L, 5.3L, 6.0L only1
- P0300 after engine repairs: injector connectors crossed (cylinders 5-7 / 6-8)1
- Slight roughness at idle with no DTCs (possible characteristic)1
- Factory trailer hitch receiver bent, broken or weld failure2
- Door sags or is hard to open or close (worn or corroded hinge pins and bushings)1
- Broken latch of the rear cupholder in the center console (replace the latch only)1
- Second-row rearward folding head restraint pinch points - recall 02V-2531
- Side access door noise (door check link replacement)1
- Poor radio reception from a loose radio antenna mast1
- Rear wiper jumps when the fog lamps are turned on (auxiliary ground to rear washer pump)1
- Conversion equipment (not the vehicle as built): Southern Comfort running board courtesy lights overheating - recall 03V-0941
- Turn signal flashes fast (export flasher relay installed)1
- Steering intermediate shaft clunk4
- Tire scrub noise on low speed turns (steering rod / centerlink installed backwards)1
- Engine compartment noise with A/C on and A/C inoperative (auxiliary rear A/C: suction hose and compressor)2
- A/C blows warm at extended idle (6.0L: auxiliary electric cooling fan)6.0L only1
- Loss of HVAC mode or temperature control (wiring harness rerouted)1
- Passenger side colder or warmer than the driver's side (HVAC case to cowl seal)1
- Insufficient heat from the rear heater in extreme cold (tee coupling replacement)1
- Seat Belt Buckle: clogged or contaminated, failed2
- 2nd/3rd row outboard seat belt retractor internal crack - recall 01V-1591
- Second row seat belt retractor does not lock automatically for a child restraint1
- Air bag (SIR) lamp on with DTC B1001 after BCM or SDM replacement1
- Seat Belt Warning Light: failed1
- OnStar System: failed, software2
- CD Player: software1
- OnStar Hardware: software1
- 4L60-E burnt 3-4 clutch pack1
- 4L60-E slip or no forward engagement right after input housing replacement (service part 17803687)1
- 4L80-E / 4L85-E planetary gear whine in first and second gear1
- Service 4WD indicator and DTC B2725 (transfer case shift control switch)4WD / AWD only1
- Electronic transfer case stops shifting with no DTC (shift abuse lock out mode, normal)1
- Transfer case speed sensor connector locks bend on disconnect (improved connector)1
- Grind / ratchet noise when shifting into Park in 4LO (characteristic)1
- Front Planetary Gear Set: broken1
- Purge Solenoid: failed1
Causes with no correction stated (35)
Causes the records name for which no check or repair is stated, in a technical document or in a record. Press one for the records that name it.
- Airbags and seat belts
- Seat Belt: failed, design or manufacturing (6)Seat Belt Retractor: failed, broken (3)
- Transmission and driveline
- Transfer Case: failed (4)Transmission: failed, clogged or contaminated (3)Locking Rear Differential (2)Axle Differential Seal: leaking (1)
- Body, doors and interior
- Liftgate Glass Hinge: broken, failed (3)Head Restraint: design or manufacturing (2)
- Electrical, wiring and power
- ATC Fuse: electrical fault, failed (2)Body Control Module: failed (1)Connector: failed (1)
- Suspension, wheels and tires
- Hub Assembly: failed, worn (2)Tire Tread and Belt: broken (2)Automatic Level Control: clogged or contaminated (1)Rear Axle Retainer Button: broken (1)
- Heating and air conditioning
- Air Conditioning Control Head: failed (1)Air Conditioning Low Pressure Switch: design or manufacturing (1)Blower Motor: failed (1)Encoder Motor: electrical fault (1)
- Exhaust and emissions
- Catalytic Converter: failed (1)Evap Vent Valve: clogged or contaminated (1)Exhaust Manifold Heat Shield: loose or misadjusted (1)Secondary Air Injection Valve: corroded (1)
- Instruments and lighting
- Fog Lamp Mount: design or manufacturing (1)Headlight: loose or misadjusted (1)Information Center Screen: failed (1)Rearview Mirror Courtesy Lamp: broken (1)
- Cooling
- Radiator Seal: failed (1)
- Audio and telematics
- Tweeter Speaker: loose or misadjusted (1)Voice Recognition System: software (1)
The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.
FaultCrate・GMC Yukon 2000–2006・2001
Candidate cause (the documents say what to do)
Autoride (Z55) Service Ride Control / Service Suspension System message
On 2009 or earlier vehicles a Service Suspension System message may appear and the rear ride height may be incorrect.
The Electronic Suspension Control module will have DTC C0696 or C0711 set.
How to tell
C0580C0696C0711Service Ride Control / suspension message
What to do
- The compressor assembly may need to be removed to see whether the wiring is pinched between the compressor and the frame.
- The module checks level-system pressure at start-up and runs the compressor to add air to the shocks if it is below 10 psi (69 kPa).
- Repair the damaged or shorted circuits and reposition the wiring so it is not damaged again when the compressor is installed.
- The sensor is not serviced separately; install a complete air filter, dryer and sensor assembly.
- For a Service Ride Control message with DTC C0580, replace the right front shock absorber solenoid connector and install new A/C suction and auxiliary evaporator hoses.
- The jumper harness is included with the complete air filter, dryer, and sensor assembly PN 22964558; vehicles built in May, 2012 and later do not require the jumper harness and use PN 22941807.
Caution: Do not replace the complete air compressor assembly for this concern.
What is needed
- Parts and materials
- Air filter, dryer and sensor assembly PN 22964558 (includes the jumper harness)
- Right front shock absorber solenoid connector (for a Service Ride Control message with C0580)
- New A/C suction and auxiliary evaporator hoses (for a Service Ride Control message with C0580)
- Auto leveling compressor air inlet filter and hose assembly PN 22197160 (for condition 3)
Part numbers printed in the document
22964558Filter Assembly, Auto Level Control Air CompressorLook up at RockAuto (aftermarket candidates) ↗Search the web ↗
Discontinued (no successor stated)(replaces 20982305 / 22197161)as stated by GMPartsGiant (checked 2026-10-06) ↗
22941807Filter Assembly, Auto Level Control Air CompressorLook up at RockAuto (aftermarket candidates) ↗Search the web ↗
Discontinued (no successor stated)as stated by GMPartsGiant (checked 2026-10-06) ↗
22197160Look up at RockAuto (aftermarket candidates) ↗Search the web ↗
The numbers are as the document prints them. The name and the replacing number are what the pages of GMPartsGiant, a reseller of genuine parts and not GM, state. Aftermarket equivalents are not checked here (the links only search by number). Confirm the fit for the vehicle (VIN) before ordering.
- Labor time
- Not stated
- Special tools
- Not stated
- Scan tool
- Not stated
Only what the technical documents state. "Not stated" does not mean not needed.
In the records
- Air Compressor: repaired 1
- Air Conditioning Suction Hose: replaced 1
- Air Filter Dryer and Sensor Assembly: replaced 1
See the evidence (1 technical documents, 4 records)
Passages of the technical documents
The GM preliminary information covers 2001-2013 GMC Yukon, Yukon XL, Yukon Denali and Yukon Denali XL with RPO Z55 or Z95.
2001-2013 GMC Yukon, Yukon XL LD, Yukon Denali, Yukon Denali XL With RPO Z55 or Z95
General Motors (filed with NHTSA as SB-10052488) 2013-06-01
On 2009 or earlier vehicles a Service Suspension System message may appear and the rear ride height may be incorrect.
Some customers of 2009 or prior vehicles, may comment of a Service Suspension System message on the DIC and the rear suspension ride height is incorrect.
General Motors (filed with NHTSA as SB-10052488) 2013-06-01
The Electronic Suspension Control module will have DTC C0696 or C0711 set.
When checking for DTCs the Electronic Suspension Control (ESC) module will have DTC C0696 or C0711 set.
General Motors (filed with NHTSA as SB-10052488) 2013-06-01
The cause can be the automatic level control pressure sensor wiring shorted to ground.
This concern could be caused by the wiring to the automatic level control (ALC) pressure sensor being shorted to ground, as shown below.
General Motors (filed with NHTSA as SB-10052488) 2013-06-01
A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.
Put together by FaultCrate from public records and technical documents. The cause and the repair are for the workshop to decide with the vehicle in front of it. Counts are records, not failure rates.