GMC Yukon 2000–2006
Common on this vehicle:Gauge or instrument faultNoiseWarning lightCorrosion or rustLeakReduced brakingAir conditioning or heaterVibration or shudder
Possible causes
21 causes not drawn
- Crankshaft position sensor may work intermittently or fail (8.1L V8) - recall 07V-5218.1L only0
- Throttle body carbon build-up: idle surge, reduced engine power, throttle DTCs (high mileage)0
- Front right-hand brake pipe contact with body cross sill - recall 00V-3450
- Stability System Disabled message and unwanted StabiliTrak activation (tire wear or mismatched tires)0
- ABS lamp with DTC C0265 (EBCM motor relay circuit) after EBCM replacement0
- Aluminum Wheel Bead Seat: corroded2
- Aftermarket part (not the vehicle as built): Federal-Mogul National / Carquest replacement wheel hub assembly retention nut - recall 07E-1062WD only1
- Rear door window inoperative (motor replacement)1
- Power Window: failed1
- Sunroof: failed1
- Service 4WD indicator and DTC B2725 (transfer case shift control switch)4WD / AWD only1
- 4WD/AWD lamps and system inoperative: "sleepy" New Venture Gear transfer case control module (reprogram the TCCM)4WD / AWD only1
- Transfer case service light, New Venture Gear transfer case (replace the encoder motor sensor and reprogram the TCCM)0
- Transfer Case Speed Sensor Wiring Harness: electrical fault1
- Rear HVAC ticking noise, no rear temperature or mode control, DTC B0434 / B3764 (revised auxiliary HVAC control module)1
- Seat Heater: overheated1
- No response when the OnStar button is pressed (DTC B2476): button assembly test values1
- Red OnStar LED and DTC B2455 after Canada upgrade bulletin 15-08-44-001 (audio and microphone drain wires shorted)1
- Instrument panel cluster gauges stick, flutter or stop working1
- CHECK OIL LEVEL message stays on after an oil change or top-off until the engine cools0
- Quadrasteer: rear wheels stay turned after the front wheels are straight (controlled re-centering after a fault, normal operation)1
Causes with no correction stated (23)
Causes the records name for which no check or repair is stated, in a technical document or in a record. Press one for the records that name it.
- Electrical, wiring and power
- ATC Fuse: electrical fault, failed (2)Bulb Socket: overheated (1)Powertrain Control Module: software (1)Intermittent no start with Service Stability, ABS light, 'Unknown Driver' and multiple DTCs / no module communication (0)
- Brakes
- Wheel Speed Sensor: failed (2)Service Stability message with DTC C0131, C0196, C0290 and/or C0292 (1)Anti-Lock Brake Motor: failed (1)Anti-Lock Brake Pump: failed (1)
- Airbags and seat belts
- Airbag: failed (1)Airbag Sensor: failed (1)
- Instruments and lighting
- Bulb: failed (1)Instrument Panel Cluster: failed (1)
- Heating and air conditioning
- Encoder Motor: electrical fault (1)
- Exhaust and emissions
- Evap Vent Valve: clogged or contaminated (1)Exhaust Manifold Bolt: broken (1)Secondary Air Injection Valve: corroded (1)
- Fuel system
- Fuel Tank: leaking (1)
- Audio and telematics
- OnStar System: failed (1)
- Body, doors and interior
- Seat Position Sensor: broken (1)
- Suspension, wheels and tires
- Shock: failed (1)
- Transmission and driveline
- Transmission: failed (1)Transmission Control Module: failed (1)Transmission Range Switch: failed (1)
The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.
FaultCrate・GMC Yukon 2000–2006・Warning light
Candidate cause (the documents say what to do)
Autoride (Z55) Service Ride Control / Service Suspension System message
On 2009 or earlier vehicles a Service Suspension System message may appear and the rear ride height may be incorrect.
The Electronic Suspension Control module will have DTC C0696 or C0711 set.
How to tell
C0580C0696C0711Service Ride Control / suspension message
What to do
- The compressor assembly may need to be removed to see whether the wiring is pinched between the compressor and the frame.
- The module checks level-system pressure at start-up and runs the compressor to add air to the shocks if it is below 10 psi (69 kPa).
- Repair the damaged or shorted circuits and reposition the wiring so it is not damaged again when the compressor is installed.
- The sensor is not serviced separately; install a complete air filter, dryer and sensor assembly.
- For a Service Ride Control message with DTC C0580, replace the right front shock absorber solenoid connector and install new A/C suction and auxiliary evaporator hoses.
- The jumper harness is included with the complete air filter, dryer, and sensor assembly PN 22964558; vehicles built in May, 2012 and later do not require the jumper harness and use PN 22941807.
Caution: Do not replace the complete air compressor assembly for this concern.
What is needed
- Parts and materials
- Air filter, dryer and sensor assembly PN 22964558 (includes the jumper harness)
- Right front shock absorber solenoid connector (for a Service Ride Control message with C0580)
- New A/C suction and auxiliary evaporator hoses (for a Service Ride Control message with C0580)
- Auto leveling compressor air inlet filter and hose assembly PN 22197160 (for condition 3)
Part numbers printed in the document
22964558Filter Assembly, Auto Level Control Air CompressorLook up at RockAuto (aftermarket candidates) ↗Search the web ↗
Discontinued (no successor stated)(replaces 20982305 / 22197161)as stated by GMPartsGiant (checked 2026-10-06) ↗
22941807Filter Assembly, Auto Level Control Air CompressorLook up at RockAuto (aftermarket candidates) ↗Search the web ↗
Discontinued (no successor stated)as stated by GMPartsGiant (checked 2026-10-06) ↗
22197160Look up at RockAuto (aftermarket candidates) ↗Search the web ↗
The numbers are as the document prints them. The name and the replacing number are what the pages of GMPartsGiant, a reseller of genuine parts and not GM, state. Aftermarket equivalents are not checked here (the links only search by number). Confirm the fit for the vehicle (VIN) before ordering.
- Labor time
- Not stated
- Special tools
- Not stated
- Scan tool
- Not stated
Only what the technical documents state. "Not stated" does not mean not needed.
In the records
- Air Compressor: repaired 1
- Air Filter Dryer and Sensor Assembly: replaced 1
- Auto Leveling Compressor Air Inlet Filter and Hose Assembly: replaced 1
See the evidence (1 technical documents, 2 records)
Passages of the technical documents
The GM preliminary information covers 2001-2013 GMC Yukon, Yukon XL, Yukon Denali and Yukon Denali XL with RPO Z55 or Z95.
2001-2013 GMC Yukon, Yukon XL LD, Yukon Denali, Yukon Denali XL With RPO Z55 or Z95
General Motors (filed with NHTSA as SB-10052488) 2013-06-01
On 2009 or earlier vehicles a Service Suspension System message may appear and the rear ride height may be incorrect.
Some customers of 2009 or prior vehicles, may comment of a Service Suspension System message on the DIC and the rear suspension ride height is incorrect.
General Motors (filed with NHTSA as SB-10052488) 2013-06-01
The Electronic Suspension Control module will have DTC C0696 or C0711 set.
When checking for DTCs the Electronic Suspension Control (ESC) module will have DTC C0696 or C0711 set.
General Motors (filed with NHTSA as SB-10052488) 2013-06-01
The cause can be the automatic level control pressure sensor wiring shorted to ground.
This concern could be caused by the wiring to the automatic level control (ALC) pressure sensor being shorted to ground, as shown below.
General Motors (filed with NHTSA as SB-10052488) 2013-06-01
A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.
Put together by FaultCrate from public records and technical documents. The cause and the repair are for the workshop to decide with the vehicle in front of it. Counts are records, not failure rates.