Skip to content
FaultCrate
日本語

This is an open preview: every record can be read without an account.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
1 conditions added

The vehicle (where a record says)

A record is under an engine, a drive or a series only where it says so: the characters of the vehicle identification number filed with a complaint, its text, or what its document says it applies to. A record that does not say is kept as "not stated". The filed numbers and the documents do not tell 4WD from AWD.

Common on this vehicle:NoiseVibration or shudder

issueSteering intermediate shaft clunkRemove

Record by record

8 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.

Work done

How it is said to have ended

  • says it did not fix it1
  • result not stated1

A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.

Read the records one by one (6)

Known issuesSteering intermediate shaft clunk6

  1. Manufacturer communication2000–2006 GMC YUKON ・ 2008-07-14

    Upper Intermediate Steering Shaft Clunking Noise

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

    Read the sentences of the record
    Remedy
    CLUNKING NOISE UNDER HOOD AND CAN BE FELT IN STEERING WHEEL AND/OR STEERING COLUMN (REPLACE UPPER INTERMEDIATE STEERING SHAFT [I-SHAFT] ASSEMBLY). *PE

  2. Owner complaint2003 GMC YUKON ・ 2006-04-27

    Steering shaft popping and grinding noise with excessive wheel play

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

    Read the sentences of the record
    Fault
    WHILE DRIVING AT VARIOUS SPEEDS AND WHEN THE STEERING WHEEL IS TURNED THERE IS A POPPING AND GRINDING NOSE. (1 more)
    Remedy
    THE VEHICLE WAS TAKEN TO THE DEALER WHERE THE SHAFT WAS GREASED.

  3. Manufacturer communication2005–2006 GMC YUKON ・ 2006-03-16

    Intermediate steering shaft clunk noise or stick-slip communication

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      EI05061 - INTERMEDIATE STEERING SHAFT CLUNK NOISE OR STICK-SLIP (FOLLOW STRATEGY BASED DIAGNOSTICS). 05-02-35-003 AND 05-02-35-003A NOT YET RECEIVED. *TT

      What the documents say to do

      Steering intermediate shaft clunk

      Confirm

      • When properly lubricated, there should be 13 mm (1/2 inch) of grease showing on the shaft splines.

      Repair

      1. Replace the upper intermediate steering shaft assembly.
      2. There are significant differences between the car and truck procedures: the lubricant is applied to a different part of the steering system and uses a different lubrication kit, 26098419.
    Read the sentences of the record
    Remedy
    EI05061 - INTERMEDIATE STEERING SHAFT CLUNK NOISE OR STICK-SLIP (FOLLOW STRATEGY BASED DIAGNOSTICS). 05-02-35-003 AND 05-02-35-003A NOT YET RECEIVED. *TT

  4. Manufacturer communication2004–2006 GMC YUKON ・ 2005-02-11

    Clunking Noise Under Hood and Steering Wheel Vibration

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      CLUNKING NOISE UNDER HOOD AND CAN BE FELT IN STEERING WHEEL. *EH UPDATED *EH UPDATED. *KB

      What the documents say to do

      Steering intermediate shaft clunk

      Confirm

      • When properly lubricated, there should be 13 mm (1/2 inch) of grease showing on the shaft splines.

      Repair

      1. Replace the upper intermediate steering shaft assembly.
      2. There are significant differences between the car and truck procedures: the lubricant is applied to a different part of the steering system and uses a different lubrication kit, 26098419.
    Read the sentences of the record
    Remedy
    CLUNKING NOISE UNDER HOOD AND CAN BE FELT IN STEERING WHEEL. *EH UPDATED *EH UPDATED. *KB

  5. Manufacturer communication2000–2003 GMC FULLSIZE PICKUPS AND UTILITIES (YUKON) ・ 2003-09-01(also printed in 2 other issues)

    Noise on steering: lubricate the intermediate shaft instead of replacing it

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      Repair

      • The "Do This" column says to lube the I-Shaft.

      Caution

      • The "Don't Do This" column lists replacing the I-Shaft; the references are 00-02-35-003B and 02-02-35-006A.
    Read the sentences of the record

    From the manufacturer’s document

    • Applies to：Row for 1999-2003 Fullsize Pickups and Utilities, Midsize Utilities: noise on steering.
    • Repair：The "Do This" column says to lube the I-Shaft.
    • Caution：The "Don't Do This" column lists replacing the I-Shaft; the references are 00-02-35-003B and 02-02-35-006A.

    Open this issue of GM TechLink ↗ The points above are read from an article of TechLink, GM’s monthly publication for dealership technicians. The article itself is not reproduced here.

    Remedy
    Truck Issues – Fix It Right The First Time 1999-2003 Fullsize Pickups and Utilities, Midsize Utilities – Noise on Steering Fullsize Pickups and Utilities, Midsize Utilities – Noise on Steering Lube I-Shaft Replace I-Shaft 00-02-35-003B 02-02-35-006A

  6. Owner complaint2000 GMC YUKON ・ 2003-11-20

    Rattle noise and vibration during sharp turns

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

    Read the sentences of the record
    Fault
    WHILE MAKING A SHARP TURN, THE DRIVER HEARD A RATTLE NOISE AND VIBRATION. (1 more)

Showing 6 of the 8 you can open. Narrow the search to see the rest.