GMC Yukon 2000–2006
Common on this vehicle:NoiseCorrosion or rustLoss of engine power, no accelerationWarning light
Record by record
7 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.
Component named as the cause
How it is said to have ended
- says it did not fix it2
- result not stated8
A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.
Read the records one by one (7)
SERVICE BRAKES, HYDRAULIC3
Owner complaint2003 GMC YUKON ・ 2007-04-03
2003 GMC Yukon: rear rotors and front wheel hub assemblies replaced
1Fault
Not stated
2Finding the cause
3Correction
Read the sentences of the record
- Remedy
- BOTH REAR ROTORS AND FRONT WHEEL HUB AND BEARING ASSEMBLY UNITS WERE REPLACED.
Owner complaint2002 GMC YUKON ・ 2005-12-06
Skidding and grinding when brake pedal applied, vehicle not included in recall
1Fault
THE VEHICLE WOULD SKID AND GRIND WHEN THE BRAKE PEDAL WAS APPLIED.
2Finding the cause
Not stated
3Correction
Read the sentences of the record
- Fault
- THE VEHICLE WOULD SKID AND GRIND WHEN THE BRAKE PEDAL WAS APPLIED.
- Remedy
- THE SAME DAY THE VEHICLE WAS TAKEN TO A LOCAL REPAIR FACILITY WHERE THEY REPLACED THE LEFT FRONT UNITIZED BEARING AND FRONT WHEEL DRIVE HUB ASSEMBLY. *NM
Owner complaint2002 GMC YUKON ・ 2005-11-30
Front wheel assembly replacement on 2002 GMC Yukon
1Fault
2Finding the cause
3Correction
Read the sentences of the record
- Remedy
- 2002 GMC YUKON FRONT WHEEL ASSEMBLY HAD TO BE REPLACED.
ELECTRONIC STABILITY CONTROL (ESC)1
Owner complaint2004 GMC YUKON DENALI ・ 2012-10-16
Stability control disabled and reduced engine power warnings, then engine stalls while driving
1Fault
2Finding the cause
3Correction
Read the sentences of the record
- Fault
- WHILE IN THE MIDDLE OF DRIVING, THE "STABILITY CONTROL DISABLED" SENSOR COMES ON FOLLOWED BY "REDUCED ENGINE POWER" AND MY VEHICLE JUST SHUTS OFF.
- Remedy
- I HAVE ALREADY REPLACED A HUB THAT MY MECHANIC SAID WAS CAUSING A "TRACTION CONTROL" PROBLEM FROM EARLIER.
POWER TRAIN1
Owner complaint2001 GMC YUKON ・ 2012-06-18
Slight grinding noise resembling brake dragging
1Fault
2Finding the cause
Not stated
3Correction
Read the sentences of the record
- Fault
- I HEARD A SLIGHT GRINDING NOISE, THAT SOUNDED LIKE A BRAKE DRAGGING.
- Remedy
- I REPLACED BRAKES ALL THE WAY AROUND, AND THAT DIDN'T STOP THE NOISE. (1 more)
SERVICE BRAKES1
Owner complaint2002 GMC YUKON ・ 2014-12-23
ABS and brake warning lights illuminate while driving
1Fault
2Finding the cause
Not stated
3Correction
Read the sentences of the record
- Fault
- THE CONTACT STATED THAT WHILE DRIVING AT APPROXIMATELY 45 MPH (= 72.4 km/h), THE ABS AND THE BRAKE WARNING LIGHTS ILLUMINATED CONTINUOUSLY.
- Remedy
- THE DRIVER SIDE HUB ASSEMBLY WAS REPLACED BUT THE PASSENGER SIDE WAS NOT REPLACED.
- Inspection
- THE VEHICLE WAS TAKEN TO AN INDEPENDENT MECHANIC WHO DIAGNOSED THAT THE HUB ASSEMBLIES NEEDED TO BE REPLACED.
SUSPENSION1
Owner complaint2000 GMC YUKON ・ 2001-12-13
Wheel bearing failure at low mileage
1Fault
2Finding the cause
3Correction
Read the sentences of the record
- Inspection
- IT WAS MIS DIAGNOSED BY J.P. THIBODEAUX GMC IN NEW IBERIA, LA. (1 more)

