Skip to content
FaultCrate
日本語

This is an open preview: every record can be read without an account.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
1 conditions added

Common on this vehicle:NoiseVibration or shudder

issueEngine vibration or noise at idle felt in the steering wheel or seat (reprogram the PCM)Remove

Possible causes

Noise1 records
Engine
Body, doors and interior
Brakes
Transmission and driveline
Electrical, wiring and power
Exhaust and emissions
1Engine vibration or noise at idle felt in the steering wheel or seat (reprogram the PCM)0Accessory drive belt whine (power steering pump pulley repositioned)1500 only0Single-cylinder misfire (P0300-P0308) and/or chirp, squeak or tick at camshaft speed: worn cam lobe / lifter, valve or valve spring0Oil pump pickup (screen) O-ring cut: engine tick / lifter noise4.8L, 5.3L, 6.0L only0Rear bank knock sensor corrosion from water intrusion (P0332)4.8L, 5.3L, 6.0L only0Rattle from the center of the dash (cowl insulator clip)0Snap or popping noise from the front of the vehicle (slot the front crossmember mounting holes)0Headliner or roof rattle (roof drain channel)0Side access door noise (door check link replacement)0Buzz at the accelerator pedal on the first acceleration after start (Supplemental Brake Assist self-test, normal)0Parking brake linings worn out prematurely, parking brake does not hold (PBR single-shoe drum-in-hat)1500 only04L60-E / 4L65-E clunk on 2-3 upshift or 3-2 downshift (normal condition)04L80-E / 4L85-E planetary gear whine in first and second gear0Grind / ratchet noise when shifting into Park in 4LO (characteristic)0Generator whine in the audio system (new ground for radio and amplifier)0Hum or fan noise from the navigation radio (internal cooling fan, normal)0Exhaust pop or ping noise (replace the heat shield, not the exhaust system)
11 causes not drawn

The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.

FaultCrate・GMC Yukon 2000–2006・Noise

Candidate cause (the documents say what to do)

Engine vibration or noise at idle felt in the steering wheel or seat (reprogram the PCM)

1 of the records matching this search name this component as the cause.

What to do

  1. Reprogram the PCM.

Caution: Do not align the exhaust and/or hang weights. The reference bulletin is 05-06-01-006.

What is needed

Parts and materials
Not stated
Labor time
Not stated
Special tools
Not stated
Scan tool
  • Reprogramming of the PCM

Only what the technical documents state. "Not stated" does not mean not needed.

In the records

No record states work done for this cause.

See the evidence (2 technical documents, 1 records)

Passages of the technical documents

  • 2003-2005 Tahoe, Yukon, Escalade: engine vibration or noise at idle, with vibration felt in the steering wheel or seat.

    2003-2005 Tahoe, Yukon, Escalade – Engine Vibration/Noise at Idle, Vibration Felt in Steering Wheel/Seat

    General Motors 2005-11-01

  • Reprogram the PCM.

    Reprogram PCM.

    General Motors 2005-11-01

  • Do not align the exhaust and/or hang weights. The reference bulletin is 05-06-01-006.

    Don’t align exhaust and/or hang weights. 05-06-01-006

    General Motors 2005-11-01

Read every statement and its source →

Records

None among the records that can be opened now.

See all 1 records of this cause →

A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.

Put together by FaultCrate from public records and technical documents. The cause and the repair are for the workshop to decide with the vehicle in front of it. Counts are records, not failure rates.