Skip to content
FaultCrate

This is an open preview: every record can be read without an account.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
1 conditions added

Common on this vehicle:Noise

issueHVAC actuator clicking / ticking noises (recalibrate the HVAC control module, do not replace actuators)Remove

Possible causes

Noise1 records
Heating and air conditioning
Body, doors and interior
Brakes
Transmission and driveline
Electrical, wiring and power
Engine
1HVAC actuator clicking / ticking noises (recalibrate the HVAC control module, do not replace actuators)0Engine compartment noise with A/C on and A/C inoperative (auxiliary rear A/C: suction hose and compressor)0Rear HVAC ticking noise, no rear temperature or mode control, DTC B0434 / B3764 (revised auxiliary HVAC control module)0Rattle from the center of the dash (cowl insulator clip)0Snap or popping noise from the front of the vehicle (slot the front crossmember mounting holes)0Headliner or roof rattle (roof drain channel)0Side access door noise (door check link replacement)0Buzz at the accelerator pedal on the first acceleration after start (Supplemental Brake Assist self-test, normal)0Parking brake linings worn out prematurely, parking brake does not hold (PBR single-shoe drum-in-hat)1500 only04L60-E / 4L65-E clunk on 2-3 upshift or 3-2 downshift (normal condition)04L80-E / 4L85-E planetary gear whine in first and second gear0Grind / ratchet noise when shifting into Park in 4LO (characteristic)0Generator whine in the audio system (new ground for radio and amplifier)0Hum or fan noise from the navigation radio (internal cooling fan, normal)0Accessory drive belt whine (power steering pump pulley repositioned)1500 only0Engine vibration or noise at idle felt in the steering wheel or seat (reprogram the PCM)0Single-cylinder misfire (P0300-P0308) and/or chirp, squeak or tick at camshaft speed: worn cam lobe / lifter, valve or valve spring0Oil pump pickup (screen) O-ring cut: engine tick / lifter noise4.8L, 5.3L, 6.0L only0Rear bank knock sensor corrosion from water intrusion (P0332)4.8L, 5.3L, 6.0L only
9 causes not drawn

The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.

Candidate cause (the documents say what to do)

HVAC actuator clicking / ticking noises (recalibrate the HVAC control module, do not replace actuators)

The condition is clicking/ticking noises from an HVAC actuator.

What to do

  1. Recalibrate the HVAC control module(s).

Caution: Do not replace the actuators.

What is needed

Parts and materials
Not stated
Labor time
Not stated
Special tools
Not stated
Scan tool
  • Recalibration of the HVAC control module(s)

Only what the technical documents state. "Not stated" does not mean not needed.

In the records

No record states work done for this cause.

See the evidence (2 technical documents, 1 records)

Passages of the technical documents

  • The row is for 2004-06 H2 and Fullsize Pick-ups and Utilities with HVAC actuator clicking/ticking noises.

    2004-06 H2, Fullsize Pick-ups and Utilities - HVAC actuator clicking/ticking noises

    General Motors 2007-01-01

  • The condition is clicking/ticking noises from an HVAC actuator.

    H2, Fullsize Pick-ups and Utilities - HVAC actuator clicking/ticking noises

    General Motors 2007-01-01

  • Recalibrate the HVAC control module(s).

    Recalibrate HVAC control module(s)

    General Motors 2007-01-01

  • Do not replace the actuators.

    Don’t replace actuators

    General Motors 2007-01-01

Read every statement and its source →

Records

None among the records that can be opened now.

See all 1 records of this cause →

A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.