Skip to content
FaultCrate

This is an open preview: every record can be read without an account.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

Common on this vehicle:Reduced brakingCorrosion or rustWarning lightParking brake

Record by record

3 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.

A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.

Read the records one by one (3)

Known issuesBrake pipe (brake line) corrosion and rupture2

  1. Owner complaint2004 GMC YUKON ・ 2014-02-23

    Brake pedal to floor with service brake system message

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

      Not stated

      What the documents say to do

      Brake pipe (brake line) corrosion and rupture

      Confirm

      • In the joint inspections, scaling or flaking corrosion was taken as indicating the onset of metal loss and given the second lowest ranking (2); a leaking or previously repaired pipe was the lowest (1).

      Repair

      1. GM recommends replacing the entire set of pipes whenever any pipe leaks or is corroded enough to need replacement.
      2. On June 28, 2013 GM released 66 new part numbers for servicing brake pipes in 1999-2007 GMT800 pickups and utility vehicles.

      Caution

      • Analysis of repair records indicates that consumers often elect to repair only the failed circuit.
    Read the sentences of the record
    Fault
    ON MY NEXT BRAKE APPLICATION MY PEDAL WENT TO THE FLOOR AND THE SERVICE BRAKE SYSTEM MESSAGE CAME ON.
  2. Owner complaint2002 GMC YUKON ・ 2013-09-11

    Brake pedal dropped during braking, brake line rusted and failed

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

      Not stated

      What the documents say to do

      Brake pipe (brake line) corrosion and rupture

      Confirm

      • In the joint inspections, scaling or flaking corrosion was taken as indicating the onset of metal loss and given the second lowest ranking (2); a leaking or previously repaired pipe was the lowest (1).

      Repair

      1. GM recommends replacing the entire set of pipes whenever any pipe leaks or is corroded enough to need replacement.
      2. On June 28, 2013 GM released 66 new part numbers for servicing brake pipes in 1999-2007 GMT800 pickups and utility vehicles.

      Caution

      • Analysis of repair records indicates that consumers often elect to repair only the failed circuit.
    Read the sentences of the record
    Fault
    HIT BRAKES, STARTED TO SLOW THEN PEDDLE DROPPED, NO WARNING LIGHT .
    Inspection
    ON INSPECTION ,BRAKE LINE BETWEEN ABS BOX AND REAR AXLE BADLY RUSTED , FAILED AT POINT ABOVE CROSSMEMBER ,IN FRONT OF GAS TANK.

SERVICE BRAKES1

  1. Owner complaint2003 GMC YUKON ・ 2016-08-14

    Total brake failure while stationary in driveway

    1. 1Fault

    2. 2Finding the cause

      SUSPECT BRAKE LINE CORROSION.

    3. 3Correction

      Not stated

    Read the sentences of the record
    Fault
    TOTAL BRAKE FAILURE WHILE STATIONARY AND ENGAGING DRIVE MODE IN DRIVEWAY. (1 more)
    Cause
    SUSPECT BRAKE LINE CORROSION.
    Inspection
    RECENT TIRE/BRAKE/ALIGNMENT INSPECTION REVEALED NO ISSUES.