Skip to content
FaultCrate

This is an open preview: every record can be read without an account.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

The vehicle (where a record says)

A record is under an engine, a drive or a series only where it says so: the characters of the vehicle identification number filed with a complaint, its text, or what its document says it applies to. A record that does not say is kept as "not stated". The filed numbers and the documents do not tell 4WD from AWD.

Common on this vehicle:Warning lightReduced brakingNoiseABS activates (at low speed and the like)Seat beltSmoke or fireAir bag did not deployCorrosion or rust

Record by record

16 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.

A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.

Read the records one by one (16)

Known issuesUnwanted ABS activation at low speed (front wheel speed sensor mounting corrosion)3

  1. Owner complaint2000 GMC YUKON ・ 2012-05-21

    ABS brakes suddenly activate and pulsate at low speed stops

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

    Read the sentences of the record
    Fault
    WHEN SLOWING DOWN AT AN INTERSECTION STOP LIGHT, AT THE SPEED OF UNDER 10 MPH (= 16.1 km/h), THE ABS BRAKES SUDDENLY KICKED IN AND PULSATED, NOT ALLOWING THE TRUCK TO STOP.
    Remedy
    EVEN THOUGH THERE WAS NO ABS WARNING LIGHT OR ERROR CODE, WE ELECTED TO REPLACE BOTH ABS SPEED SENSORS AS A PRECAUTION. (1 more)
    Inspection
    AFTER TAKING THE VEHICLE TO THE MECHANICS THEY COULD NOT DIAGNOSE A PROBLEM.
    Consequence
    THIS ALMOST RESULTED IN A REAR END COLLISION WITH A STOPPED VEHICLE IN FRONT OF ME.
  2. Owner complaint2000 GMC YUKON DENALI ・ 2005-11-15

    Extended stopping distance during low-speed ABS activation

    1. 1Fault

    2. 2Finding the cause

      CONSEQUENCE OF CONDITION: WHEN THE PEAK-TO-PEAK WHEEL SPEED SENSOR VOLTAGE LEVEL RECEIVED AT THE ABS CONTROLLER IS BELOW THE MINIMUM SPECIFIED PEAK-TO-PEAK LEVEL, THE ABS CONTROLLER INTERPRETS THIS AS A WHEEL SPEED THAT IS LESS THAN THE ACTUAL WHEEL SPEED.

    3. 3Correction

      Not stated

      What the documents say to do

      Unwanted ABS activation at low speed (front wheel speed sensor mounting corrosion)

      Confirm

      • The reading should be at least 350 mV AC; if it is less, the wheel speed sensor must be replaced.

      Repair

      1. Dealers remove the sensor, clean its mounting surface on the bearing, apply rust inhibitor and grease, reinstall it and check peak-to-peak output voltage.
      2. The passage heading states that the repair is cleaning the wheel speed sensor mounting surface.

      Caution

      • Do not pry the sensor out of the bore; prying breaks the sensor body off in the bore.
    Read the sentences of the record
    Fault
    THIS CONDITION DOES NOT SET ANY ABS CODES NOR DOES IT ILLUMINATE THE ABS WARNING LAMP. (1 more)
    Cause
    CONSEQUENCE OF CONDITION: WHEN THE PEAK-TO-PEAK WHEEL SPEED SENSOR VOLTAGE LEVEL RECEIVED AT THE ABS CONTROLLER IS BELOW THE MINIMUM SPECIFIED PEAK-TO-PEAK LEVEL, THE ABS CONTROLLER INTERPRETS THIS AS A WHEEL SPEED THAT IS LESS THAN THE ACTUAL WHEEL SPEED.
  3. Owner complaint2001 GMC YUKON ・ 2005-05-24

    ABS activates at low speed, causing extended stopping distances

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

    Read the sentences of the record
    Fault
    DT: CONTACT STATES THE ABS COMES ON WHILE DRIVING APPROXIMATELY 5 MPH (= 8.05 km/h), CAUSING THE MANUAL BRAKES TO PUMP AT LOW SPEED, LEADING TO EXTENDED STOPPING DISTANCES. (1 more)
    Remedy
    THE SERVICE DEALER REPLACED THE RIGHT FRONT HUB AND THE SENSOR.

Known issuesBrake pipe (brake line) corrosion and rupture1

  1. Owner complaint2003 GMC YUKON ・ 2016-08-23

    Total brake failure when braking at intersection; ABS light on

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

      IN ORDER TO IMPROVE VEHICLE SAFETY THE LINES WILL ALL BE REPLACED WITH STAINLESS STEEL SO THIS DOESN'T HAPPEN AGAIN.

      What the documents say to do

      Brake pipe (brake line) corrosion and rupture

      Confirm

      • In the joint inspections, scaling or flaking corrosion was taken as indicating the onset of metal loss and given the second lowest ranking (2); a leaking or previously repaired pipe was the lowest (1).

      Repair

      1. GM recommends replacing the entire set of pipes whenever any pipe leaks or is corroded enough to need replacement.
      2. On June 28, 2013 GM released 66 new part numbers for servicing brake pipes in 1999-2007 GMT800 pickups and utility vehicles.

      Caution

      • Analysis of repair records indicates that consumers often elect to repair only the failed circuit.
    Read the sentences of the record
    Fault
    WHILE APPROACHING AN INTERSECTION I APPLIED THE BRAKES THE PEDAL WENT TO THE FLOOR ABS LIGHT CAME ON AND THE WAS TOTAL BRAKE FAILURE.
    Remedy
    IN ORDER TO IMPROVE VEHICLE SAFETY THE LINES WILL ALL BE REPLACED WITH STAINLESS STEEL SO THIS DOESN'T HAPPEN AGAIN.
    Inspection
    THEY FOUND RUSTED BRAKE LINES AT THE ABS VALVE ALONG WITH A RUSTED BACKING PLATE FOR THE VALVE.

SERVICE BRAKES, HYDRAULIC6

  1. Owner complaint2003 GMC YUKON ・ 2014-08-18

    Intermittent anti-lock braking system warning light and check brake system light

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

    Read the sentences of the record
    Fault
    *SMD THE CONSUMER STATED WHILE DRIVING DOWN THE ROAD, WARNING BELLS STARTED TO SOUND AND THE CHECK BRAKE SYSTEM LIGHT, ILLUMINATED.
    Remedy
    THE NEXT DAY, HE TOOK THE VEHICLE TO THE REPAIR SHOP, WHERE THEY REPLACED THE PADS AND CHECKED THE SYSTEM.
    Inspection
    THE CONSUMER CHECKED THE BRAKE FLUID, AND FOUND IT WAS OK. (2 more)
  2. Owner complaint2000 GMC YUKON ・ 2006-05-03

    ABS system failed to stop vehicle; braking failure at low speed

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      Not stated

    Read the sentences of the record
    Fault
    DT*: THE CONTACT STATED THE ABS SYSTEM FAILED TO STOP THE VEHICLE. (2 more)
    Consequence
    HOWEVER INJURIES WERE SUSTAINED TO THE DRIVER.
  3. Owner complaint2001 GMC YUKON ・ 2005-10-15

    Brake pedal stiffness and ABS warning light with continuous pump operation

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      I REMOVED THE ABS FUSE TO STOP THE PUMP.

    Read the sentences of the record
    Fault
    THE BRAKE PEDAL HAD BECOME INCREASINGLY HARD TO PUSH OVER THE COURSE OF A FEW WEEKS. (1 more)
    Remedy
    I REMOVED THE ABS FUSE TO STOP THE PUMP.
  4. Owner complaint2001 GMC YUKON ・ 2005-09-29

    ABS light on and ABS motor running continuously while driving

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

      THE MECHANIC UNHOOKED THE ABS MOTOR.

    Read the sentences of the record
    Fault
    DT: WHILE DRIVING ON THE INTERSTATE THE OWNER SAW THE ABS LIGHT COME ON AND DIDN'T KNOW WHAT IT WAS. (2 more)
    Remedy
    THE MECHANIC UNHOOKED THE ABS MOTOR.
  5. Owner complaint2001 GMC YUKON ・ 2005-04-24

    Anti-lock brake light came on while driving

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

    Read the sentences of the record
    Fault
    I WAS DRIVING HOME AND MY ANTI-LOCK BRAKE LIGHT CAME ON.
    Remedy
    THE BATTERY WAS DISCONNECTED AT THE ADVICE OF THE DEALER AS TO NOT CAUSE FURTHER DAMAGE.
  6. Owner complaint2004 GMC YUKON DENALI ・ 2008-11-12

    Traction control message after stop, vehicle sluggish to accelerate

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

    Read the sentences of the record
    Fault
    2004 GMC YUKON DENALI - TRACTION CONTROL MESSAGE COMES ON AFTER A STOP WHEN YOU START TO GO AGAIN AND IT FEELS LIKE THE VEHICLE DOES NOT WANT TO GO.
    Inspection
    WE HAVE TAKEN IT IN SEVERAL TIMES FOR THIS ISSUE BUT COULD NOT FIGURE OUT WHAT IT WAS DUE TO NO CODE IN THE COMPUTER.

SERVICE BRAKES3

  1. Owner complaint2004 GMC YUKON ・ 2019-10-23

    ABS warning indicator illuminating intermittently

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      Not stated

    Read the sentences of the record
    Fault
    THE CONTACT STATED THAT THE ABS WARNING INDICATOR ILLUMINATED INTERMITTENTLY.
    Inspection
    THE CONTACT TOOK THE VEHICLE TO A CERTIFIED MECHANIC WHO DIAGNOSED THAT THE BRAKE PADS NEEDED REPLACING, THE DRUMS NEEDED TO BE ROTATED, AND NEW BRAKE LINES WERE NEEDED. (1 more)
    Outcome
    THE VEHICLE WAS REPAIRED.
  2. Owner complaint2003 GMC YUKON ・ 2016-09-29

    Brake pedal sinks to floor and brakes fail while driving at 40 MPH

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3CorrectionNot repaired

      THE VEHICLE WAS NOT REPAIRED.

    Read the sentences of the record
    Fault
    WHILE ATTEMPTING TO SLOW DOWN, THE BRAKE PEDAL WENT TO THE FLOOR WHEN IT WAS DEPRESSED, BUT FAILED TO STOP THE VEHICLE. (1 more)
    Remedy
    THE VEHICLE WAS NOT REPAIRED.
    Inspection
    THE CONTACT SLOWLY DROVE THE VEHICLE TO AN INDEPENDENT MECHANIC WHO DIAGNOSED THAT THE HYDRAULIC UNIT NEEDED TO BE REPLACED.
  3. Owner complaint2003 GMC YUKON ・ 2014-05-27

    ABS warning indicator illuminated and anti-lock brakes failed

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3CorrectionNot repaired

      HOWEVER, THE PART WAS NOT AVAILABLE TO DO THE REPAIRS.

    Read the sentences of the record
    Fault
    THE CONTACT STATED THAT THE ABS WARNING INDICATOR ILLUMINATED AS THE ANTI LOCK BRAKES FAILED.
    Remedy
    HOWEVER, THE PART WAS NOT AVAILABLE TO DO THE REPAIRS.
    Inspection
    THE TECHNICIAN DIAGNOSED THAT THE PUMP AND THE MODULATOR HAD TO BE REPLACED.

ELECTRONIC STABILITY CONTROL (ESC)2

  1. Owner complaint2001 GMC YUKON ・ 2012-11-23

    ABS light came on, ABS pump overheated and made continuous humming noise

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

      TAPPED ON PUMP HOUSING TO GET IT TO GO OFF BUT NO SUCCESS. (1 more)

    Read the sentences of the record
    Fault
    ABS LIGHT CAME ON WHEN BACKING OUT OF DRIVEWAY. (2 more)
    Cause
    THERE IS SOMETHING WRONG WITH THE CIRCUIT LOGIC.
    Remedy
    TAPPED ON PUMP HOUSING TO GET IT TO GO OFF BUT NO SUCCESS. (1 more)
    Inspection
    UNABLE TO LOCATE SOURCE OF HUM. (1 more)
  2. Owner complaint2001 GMC YUKON ・ 2014-11-16

    ABS light and grinding noise from pump, recurring failures

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

    Read the sentences of the record
    Fault
    IN AUG 2005, THE ABS LIGHT ON OUR 2001 GMC YUKON WITH 51K MILES (= 82,077 km) CAME ON AND THERE WAS A GRINDING NOISE (THE PUMP) UNDERNEATH THE DRIVER'S SIDE WHICH REMAINS ON WHEN THE VEHICLE IS TURNED OFF.
    Remedy
    THE ABS FUSE MUST BE REMOVED TO SHUT OFF THE PUMP.

ELECTRICAL SYSTEM1

  1. Owner complaint2004 GMC YUKON DENALI ・ 2009-02-06

    ABS light and traction control light flashing intermittently

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

      Not stated

    Read the sentences of the record
    Fault
    FLASHING ABS LIGHT AND THEN ALTERNATING FLASHING TC (TRACTION CONTROL) LIGHT. (1 more)
    Cause
    CAUSE BY THE WHEEL SPEED SENSOR FAILING ON THE VEHICLE.