Skip to content
FaultCrate
日本語

This is an open preview: every record can be read without an account.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

Common on this vehicle:LeakAir conditioning or heaterSmoke or fireWarning light

Record by record

1 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.

Read the records one by one (1)

ENGINE AND ENGINE COOLING1

  1. Manufacturer communication2000–2006 GMC YUKON DENALI ・ 2019-03-18

    Diagnostic Tip: Using Smoke Machine and Ultrasonic Detector for Air Leaks

    1. 1Fault

      • The SES light is on, and initial diagnosis may show fuel trim and/or O2 sensor related codes such as P0171, P0174, P0420 and P0430.

    2. 2Finding the cause

      Steps to confirm (in the document’s order)

      1. If normal SI diagnostics do not resolve it and an intake vacuum leak or exhaust leak is suspected, the J41413-200 Evaporative System Tester smoke machine, the J-41416 ultrasonic leak tester, or soapy water with low pressure air into the tailpipe may help find the leak.
      2. For an intake leak, the smoke can be introduced into the brake booster hose or the oil dipstick tube.
      3. Soapy water can be sprayed near the gasket and seams and on all vacuum nipples.
      4. For an exhaust leak, a hose into the tailpipe carrying smoke or air, sealed with shop towels, is effective.
      5. Then spray soapy water around the seals, seams and bosses.
      1 more points

    3. 3Correction

      Caution

      • All of these tests are much more effective if the throttle body is covered/sealed.
    Read the sentences of the record

    From the manufacturer’s document

    • Applies to：Applies to all 2000 - 2019 models with gasoline engines.
    • Condition：The SES light is on, and initial diagnosis may show fuel trim and/or O2 sensor related codes such as P0171, P0174, P0420 and P0430.
    • Confirm：If normal SI diagnostics do not resolve it and an intake vacuum leak or exhaust leak is suspected, the J41413-200 Evaporative System Tester smoke machine, the J-41416 ultrasonic leak tester, or soapy water with low pressure air into the tailpipe may help find the leak.
    • Caution：All of these tests are much more effective if the throttle body is covered/sealed.
    • Confirm：For an intake leak, the smoke can be introduced into the brake booster hose or the oil dipstick tube.
    • Confirm：Soapy water can be sprayed near the gasket and seams and on all vacuum nipples.
    • Confirm：For an exhaust leak, a hose into the tailpipe carrying smoke or air, sealed with shop towels, is effective.
    • Confirm：Then spray soapy water around the seals, seams and bosses.
    • Confirm：These methods are very good for finding small leaks around the O2 sensor bosses and slight cracks in an intake plenum or gasket.

    Open the manufacturer’s document (PDF) ↗ The points above were read from this document.

    Remedy
    This preliminary information document communicates a tip on the way to diagnose possible induction or exhaust air leaks using the evaporative emission cart smoke machine and ultrasonic leak detector tools.