Skip to content
FaultCrate
日本語

This is an open preview: every record can be read without an account.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

Common on this vehicle:Warning lightGauge or instrument faultLeakNoise

Record by record

1 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.

Read the records one by one (1)

EQUIPMENT1

  1. Manufacturer communication2000–2006 GMC YUKON DENALI ・ 2017-08-15

    Odometer Accuracy Verification

    1. 1Fault

      • The customer says the odometer appears inaccurate compared with a known distance traveled.

    2. 2Finding the cause

      Steps to confirm (in the document’s order)

      1. On a straight road over a mile long, mark a GPS waypoint when the odometer (not the trip odometer) rolls over a digit, take a reading when it rolls to the next digit, and compare the actual distance with the odometer.
      2. Confirm that the original size tires and wheels are fitted and that the axle ratio is as specified on the SPID label and has not been modified.
      3. If those are correct and the odometer is beyond the limit, look at the relationship between the VSS and the reluctor on the transmission output shaft, and inspect the associated wiring and connectors closely.

    3. 3Correction

      Repair

      • Finally, it may be necessary to exchange the instrument panel cluster (IPC) for a replacement unit.

      Caution

      • A tolerance of plus or minus 4% is generally allowed, but each dealer must know the local requirements before verifying an odometer.
      • Do not compare with another vehicle or with the trip odometer; expressway mileage markers are typically not accurate enough either.
    Read the sentences of the record

    From the manufacturer’s document

    • Applies to：1995-2016 GM passenger cars and light duty trucks.
    • Condition：The customer says the odometer appears inaccurate compared with a known distance traveled.
    • Caution：A tolerance of plus or minus 4% is generally allowed, but each dealer must know the local requirements before verifying an odometer.
    • Confirm：On a straight road over a mile long, mark a GPS waypoint when the odometer (not the trip odometer) rolls over a digit, take a reading when it rolls to the next digit, and compare the actual distance with the odometer.
    • Caution：Do not compare with another vehicle or with the trip odometer; expressway mileage markers are typically not accurate enough either.
    • Confirm：Confirm that the original size tires and wheels are fitted and that the axle ratio is as specified on the SPID label and has not been modified.
    • Confirm：If those are correct and the odometer is beyond the limit, look at the relationship between the VSS and the reluctor on the transmission output shaft, and inspect the associated wiring and connectors closely.
    • Repair：Finally, it may be necessary to exchange the instrument panel cluster (IPC) for a replacement unit.

    Open the manufacturer’s document (PDF) ↗ The points above were read from this document.

    Remedy
    This Preliminary Information communication provides information to the technician about vehicle's odometer appears to be inaccurate relative to a known distance traveled. Technician should obtain a hand-held GPS unit to test the odometer. If a hand held GPS unit is not available, the only other option is to verify the miles traveled using a surveyor's wheel or a dynamometer.