Skip to content
FaultCrate
日本語

This is an open preview: every record can be read without an account.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

The vehicle (where a record says)

A record is under an engine, a drive or a series only where it says so: the characters of the vehicle identification number filed with a complaint, its text, or what its document says it applies to. A record that does not say is kept as "not stated". The filed numbers and the documents do not tell 4WD from AWD.

Common on this vehicle:NoiseVibration or shudderLeakGauge or instrument faultSteering effort changeLoss of engine power, no accelerationReduced brakingAir conditioning or heater

Record by record

10 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.

Symptom

Component named as the cause

Work done

How it is said to have ended

  • says it came back3
  • says it did not fix it2
  • result not stated8

A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.

Read the records one by one (10)

Known issuesSteering intermediate shaft clunk1

  1. Owner complaint2000 GMC YUKON ・ 2003-11-20

    Rattle noise and vibration during sharp turns

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

    Read the sentences of the record
    Fault
    WHILE MAKING A SHARP TURN, THE DRIVER HEARD A RATTLE NOISE AND VIBRATION. (1 more)

STEERING6

  1. Owner complaint2003 GMC YUKON ・ 2005-08-01

    Multiple chassis problems: front end vibration and others

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

    Read the sentences of the record
    Fault
    AFTER THE NEAR MISS, I REALIZED THAT THE VEHICLE HAD LOST POWER STEERING, ONLY TO THE RIGHT.
    Remedy
    IN THE PAST, GM SERVICE HAS ALIGNED THE FRONT END, BALANCED WHEELS, REPLACED TIRES, REPLACED THE POWER STEERING PUMP, AND REPLACED THE STEERING GEAR.
    Consequence
    I HAD A NEAR MISS AS THERE WAS TRAFFIC COMING FROM BOTH DIRECTIONS ON A ROAD WITH A POSTED SPEED LIMIT OF 45 MPH (= 72.4 km/h).

  2. Owner complaint2003 GMC YUKON ・ 2005-08-01

    Intermittent loss of power steering and front-end vibration at highway speeds

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

    Read the sentences of the record
    Fault
    AFTER THE NEAR MISS, I REALIZED THAT THE VEHICLE HAD LOST POWER STEERING, ONLY TO THE RIGHT.
    Remedy
    IN THE PAST, GM SERVICE HAS ALIGNED THE FRONT END, BALANCED WHEELS, REPLACED TIRES, REPLACED THE POWER STEERING PUMP, AND REPLACED THE STEERING GEAR.
    Consequence
    I HAD A NEAR MISS AS THERE WAS TRAFFIC COMING FROM BOTH DIRECTIONS ON A ROAD WITH A POSTED SPEED LIMIT OF 45 MPH (= 72.4 km/h).

  3. Manufacturer communication2000–2006 GMC YUKON ・ 2005-04-21

    Steering Assist or Shudder During Low-Speed Maneuvers

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      LACK OF STEERING ASSIST OR SHUDDER DURING PARKING LOT TYPE MANEUVERS. *TT

    Read the sentences of the record
    Remedy
    LACK OF STEERING ASSIST OR SHUDDER DURING PARKING LOT TYPE MANEUVERS. *TT

  4. Manufacturer communication2003–2004 GMC YUKON ・ 2004-05-03

    Steering Assist or Shudder During Parking Lot Maneuvers

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      LACK OF STEERING ASSIST OR SHUDDER DURING PARKING LOT TYPE MANEUVERS. *MR

    Read the sentences of the record
    Remedy
    LACK OF STEERING ASSIST OR SHUDDER DURING PARKING LOT TYPE MANEUVERS. *MR

  5. Owner complaint2003 GMC YUKON ・ 2005-01-04

    Steering shaft loose and noisy, steering difficult and shaking

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

      Not stated

    Read the sentences of the record
    Fault
    IT WAS LOOSE WHICH MADE THE STEERING DIFFICULT AT TIMES. (2 more)

  6. Owner complaint2001 GMC YUKON ・ 2004-12-10

    Steering wheel shakes on turns with driveline noise and declining performance

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

      Not stated

    Read the sentences of the record
    Fault
    THE STEERING WHEEL SHAKES WHENEVER MAKING A TURN, AND THERE IS A LOUD NOISE COMING FROM THE DRIVELINE. (1 more)

ENGINE AND ENGINE COOLING2

  1. Manufacturer communication2004–2006 GMC YUKON DENALI ・ 2023-11-22

    Vibration Analysis Worksheet Service Bulletin

    1. 1Fault

    2. 2Finding the cause

      Steps to confirm (in the document’s order)

      1. When diagnosing vibration, use the worksheet together with the Vibration Analysis - Road Testing procedure in the service information.
      2. Place the sensor where the vibration is felt: on the seat track for a seat complaint, on the steering column for a steering wheel complaint.
      3. Moving the sensor to other areas, look for the same Hz reading with the greatest amplitude.
      4. If a system balance was attempted and the vibration remains, check ring gear backlash at each tooth; readings should not vary more than 0.050 mm (0.002 in).
      5. Aluminum wheel/tire runout measured on the vehicle: maximum 0.030 in (.762 mm).
      2 more points

    3. 3Correction

      This service bulletin provides a vibration analysis worksheet the technician can use in conjunction with the appropriate Vibration Analysis-Road testing procedure when diagnosing vibration concerns.

    Read the sentences of the record

    From the manufacturer’s document

    • Applies to：Applies to 2024 and prior GM passenger cars and trucks.
    • Confirm：When diagnosing vibration, use the worksheet together with the Vibration Analysis - Road Testing procedure in the service information.
    • Confirm：Place the sensor where the vibration is felt: on the seat track for a seat complaint, on the steering column for a steering wheel complaint.
    • Confirm：Moving the sensor to other areas, look for the same Hz reading with the greatest amplitude.
    • Confirm：If a system balance was attempted and the vibration remains, check ring gear backlash at each tooth; readings should not vary more than 0.050 mm (0.002 in).
    • Confirm：Aluminum wheel/tire runout measured on the vehicle: maximum 0.030 in (.762 mm).
    • Confirm：Hub mounting surface runout: maximum 0.005 in (0.132 mm).
    • Confirm：Wheel stud runout: maximum 0.010 in (0.254 mm).

    Open the manufacturer’s document (PDF) ↗ The points above were read from this document.

    Remedy
    This service bulletin provides a vibration analysis worksheet the technician can use in conjunction with the appropriate Vibration Analysis-Road testing procedure when diagnosing vibration concerns.

  2. Owner complaint2006 GMC YUKON ・ 2006-12-05

    Clunking noise when turning wheel, vibration at 65 MPH and more

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

    Read the sentences of the record
    Fault
    2006 YUKON MAKES A CLUNKING NOISE WHEN TURNING THE WHEEL, VIBRATION IS ALSO NOTICED WHEN DRIVING 65 MPH (= 104.6 km/h). (5 more)
    Remedy
    THE VEHICLE WAS RETURNED AND THEY REPLACED THE RIGHT FRONT TIRE WHICH THEY CLAIMED WAS DEFECTIVE FROM THE FACTORY. (5 more)
    Inspection
    THE VEHICLE WAS TAKEN TO SERVICE DEALER WHO DETERMINED THAT THE UPPER AND LOWER CONTROL ARMS NEEDED TO BE REPLACED. (1 more)

ELECTRICAL SYSTEM1

  1. Owner complaint2005 GMC YUKON ・ 2014-03-12

    Engine stalls while moving slowly in parking lot, twice in 3 months

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      Not stated

    Read the sentences of the record
    Fault
    THIS IS THE 2ND OCCURRENCE OF THE SAME INCIDENT IN 3 MONTHS. (2 more)
    Consequence
    WITHOUT POWER, STEERING IS IMPAIRED OR IMPOSSIBLE.