Skip to content
FaultCrate
日本語

This is an open preview: every record can be read without an account.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

The vehicle (where a record says)

A record is under an engine, a drive or a series only where it says so: the characters of the vehicle identification number filed with a complaint, its text, or what its document says it applies to. A record that does not say is kept as "not stated". The filed numbers and the documents do not tell 4WD from AWD.

Common on this vehicle:Seat beltAir bag did not deployWarning lightNoiseAir conditioning or heaterPower windowReduced brakingCorrosion or rust

Possible causes

Warning light, Air bags and seat belts27 records
Airbags and seat belts
Body, doors and interior
Engine
Electrical, wiring and power
Heating and air conditioning
Brakes
2Seat Belt Buckle: clogged or contaminated, failed1Seat Belt Warning Light: failed1Seat Belt: failed0SIR lamp on and inside mirror temperature/compass display inoperative (open air bag fuse, circuit 1139 shorted to ground)0Air bag (SIR) lamp on with DTC B1001 after BCM or SDM replacement1Rear door window inoperative (motor replacement)1Power Window: failed1Coil Harness: design or manufacturing1Accelerator Pedal: broken0Crankshaft position sensor may work intermittently or fail (8.1L V8) - recall 07V-5218.1L only0Intake manifold gasket leak (cold idle misfire, lean codes)0Single-cylinder misfire (P0300-P0308) and/or chirp, squeak or tick at camshaft speed: worn cam lobe / lifter, valve or valve spring0P0300 after engine repairs: injector connectors crossed (cylinders 5-7 / 6-8)1Rear Window Defroster Contact: broken0Intermittent MIL, service lamps/messages or DTCs from connector fretting corrosion0Reduced Engine Power from throttle body connector crimp, broken wire or grounds1Seat Heater: overheated0Brake pipe (brake line) corrosion and rupture0ABS light with C0265/C0201/U1041 or no communication with brake module (EBCM ground G110)0Front right-hand brake pipe contact with body cross sill - recall 00V-3450Service Brake Booster message on a Hydroboost vehicle with DTC C0136 (instrument cluster not SPS programmed)0Stability System Disabled / Service Stability message with DTC C0455 (bent terminals at the steering wheel position sensor)
10 causes not drawn
Causes with no correction stated (5)

Causes the records name for which no check or repair is stated, in a technical document or in a record. Press one for the records that name it.

Airbags and seat belts
Airbag: failed (1)Airbag Sensor: failed (1)
Suspension, wheels and tires
Shock: failed (1)
Electrical, wiring and power
Intermittent no start with Service Stability, ABS light, 'Unknown Driver' and multiple DTCs / no module communication (0)
Brakes
Service Stability message with DTC C0131, C0196, C0290 and/or C0292 (0)

The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.

FaultCrate・GMC Yukon 2000–2006・Warning light, Air bags and seat belts

Candidate cause (named by records only; no technical document)

Power Window: failed

1 of the records matching this search name this component as the cause.

How to tell

Air bag light

What to do

No technical document states a check or a repair.

In the records

  • Control Arm: replaced 1（result not stated: 1）
See the evidence (0 technical documents, 1 records)

A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.

Put together by FaultCrate from public records and technical documents. The cause and the repair are for the workshop to decide with the vehicle in front of it. Counts are records, not failure rates.