GMC Yukon 2000–2006
Common on this vehicle:Gauge or instrument faultWarning lightAir conditioning or heaterLights (headlights, turn signals)NoiseLoss of engine power, no accelerationSmoke or fireLeak
Record by record
5 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.
Component named as the cause
How it is said to have ended
- result not stated3
A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.
Read the records one by one (5)
Known issuesIntermittent stall, misfire or crank no start (Ignition 1 feed wire broken near C148/C149)1
Manufacturer communication2005–2006 GMC YUKON ・ 2006-09-28
Loss of Ignition 1 Voltage to the Ignition Coils
1Fault
2Finding the cause
3Correction
What the documents say to do
Intermittent stall, misfire or crank no start (Ignition 1 feed wire broken near C148/C149)Confirm
- Complete the SI diagnostics first; if they are inconclusive and the concern can be duplicated, inspect for a loss of Ignition 1 voltage to the ignition coils.
Read the sentences of the record
- Remedy
- LOSS OF IGNITION 1 VOLTAGE TO THE IGNITION COILS. CONSUMER EXPERIENCED INTERMITTENT STALL, MISFIRE, OR CRANK NO START. THERE MAY BE NO TROUBLE CODES SET. *KB UPDATED 3/17/09. *PE
Known issuesPasslock theft deterrent: starts then stalls / no-start with security lamp1
Manufacturer communication2000–2001 GMC YUKON ・ 2001-10-26
Security Lamp and Engine Stall Condition – DTC B2960
1Fault
2Finding the cause
Not stated
3Correction
What the documents say to do
Passlock theft deterrent: starts then stalls / no-start with security lampConfirm
- A security lamp flashing after an attempted start means the fuel disable command is active.
Repair
- The condition is the Security lamp illuminated on the instrument panel, engine stalls or no start, with DTC B2960 (Security System Sensor Data Incorrect but Valid) set; the correction is to inspect and repair the cause of DTC B2960.
Caution
- Loss of Ignition 1 voltage to the BCM gives the same start-then-stall behaviour.
Read the sentences of the record
- Remedy
- SOME VEHICLES MAY EXHIBIT A SECURITY LAMP ILLUMINATED ON THE INSTRUMENT PANEL, ENGINE STALL, NO START CONDITION, AND DIAGNOSTIC TROUBLE CODE B2960. *TT
ELECTRICAL SYSTEM3
Owner complaint2001 GMC YUKON ・ 2015-06-03
Vehicle stalled without warning while driving at 40 mph
1Fault
2Finding the cause
Not stated
3CorrectionNot repaired
Read the sentences of the record
- Fault
- WHILE DRIVING AT 40 MPH (= 64.4 km/h), THE VEHICLE STALLED WITHOUT WARNING.
- Remedy
- THE VEHICLE WAS NOT DIAGNOSED OR REPAIRED.
Owner complaint2003 GMC YUKON ・ 2004-11-03
Fuel pump failure and steering jamming while driving and towing
1Fault
2Finding the cause
Not stated
3Correction
Read the sentences of the record
- Fault
- PRIOR TO STALLING THERE WAS SOME HESITATION AND JERKING AS IF NOT GETTING FUEL TO ENGINE. (3 more)
- Remedy
- THE DEALER TOOK VEHICLE TO DEALERSHIP IN ARIZONA, AND FUEL PUMP HAD TO BE REPLACED. (1 more)
Owner complaint2001 GMC YUKON ・ 2002-11-09
Dim headlights going out, only high beam works; stall; battery replaced
1Fault
2Finding the cause
Not stated
3Correction
1 owner complaints have no classified sentences yet, so their causes and repairs are not picked out. Their text is in the list of records.

