GMC Yukon 2000–2006
Common on this vehicle:Gauge or instrument faultWarning lightAir conditioning or heaterLights (headlights, turn signals)NoiseLoss of engine power, no accelerationSmoke or fireLeak
Record by record
5 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.
Component named as the cause
How it is said to have ended
- result not stated3
A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.
Read the records one by one (5)
Known issuesIntermittent stall, misfire or crank no start (Ignition 1 feed wire broken near C148/C149)1
Manufacturer communication2005–2006 GMC YUKON ・ 2006-09-28
Loss of Ignition 1 Voltage to the Ignition Coils
1Fault
2Finding the cause
3Correction
What the documents say to do
Intermittent stall, misfire or crank no start (Ignition 1 feed wire broken near C148/C149)Confirm
- Complete the SI diagnostics first; if they are inconclusive and the concern can be duplicated, inspect for a loss of Ignition 1 voltage to the ignition coils.
Read the sentences of the record
- Remedy
- LOSS OF IGNITION 1 VOLTAGE TO THE IGNITION COILS. CONSUMER EXPERIENCED INTERMITTENT STALL, MISFIRE, OR CRANK NO START. THERE MAY BE NO TROUBLE CODES SET. *KB UPDATED 3/17/09. *PE
Known issuesIntermittent no start with Service Stability, ABS light, 'Unknown Driver' and multiple DTCs / no module communication1
Manufacturer communication2003–2006 GMC YUKON ・ 2003-12-05
Intermittent No Start, Stability Message, ABS Light
1Fault
2Finding the cause
Not stated
3Correction
Read the sentences of the record
- Remedy
- INTERMITTENT NO START, SERVICE STABILITY MESSAGE, ANTI-LOCK BRAKE SYSTEM (ABS) LIGHT ILLUMINATED, MULTIPLE DIAGNOSTIC TROUBLE CODES (DTCS), DIC SHOWS UNKNOWN DRIVER, VARIOUS ELECTRICAL RELATED CONDITIONS. INCLUDES ESCALADE ESV AND EXT MODEL. *TT
Known issuesPasslock theft deterrent: starts then stalls / no-start with security lamp1
Manufacturer communication2000–2001 GMC YUKON ・ 2001-10-26
Security Lamp and Engine Stall Condition – DTC B2960
1Fault
2Finding the cause
Not stated
3Correction
What the documents say to do
Passlock theft deterrent: starts then stalls / no-start with security lampConfirm
- A security lamp flashing after an attempted start means the fuel disable command is active.
Repair
- The condition is the Security lamp illuminated on the instrument panel, engine stalls or no start, with DTC B2960 (Security System Sensor Data Incorrect but Valid) set; the correction is to inspect and repair the cause of DTC B2960.
Caution
- Loss of Ignition 1 voltage to the BCM gives the same start-then-stall behaviour.
Read the sentences of the record
- Remedy
- SOME VEHICLES MAY EXHIBIT A SECURITY LAMP ILLUMINATED ON THE INSTRUMENT PANEL, ENGINE STALL, NO START CONDITION, AND DIAGNOSTIC TROUBLE CODE B2960. *TT
ELECTRICAL SYSTEM2
Owner complaint2003 GMC YUKON ・ 2022-04-18
Multiple electrical and suspension failures, air bag warning on 2003 GMC Yukon
1Fault
2Finding the cause
Not stated
3Correction
Read the sentences of the record
- Fault
- The contact stated that upon purchasing the vehicle from a towing company, the vehicle would not start. (2 more)
- Remedy
- The battery was instantly replaced. (2 more)
- Inspection
- The independent mechanic then took the vehicle to an electrical failure specialist where it was diagnosed that the front end of the vehicle was experiencing electrical failures.
Manufacturer communication2006 GMC YUKON ・ 2006-05-16
No Crank, IGN A 40 Amp Fuse Blown
1Fault
2Finding the cause
3Correction
Read the sentences of the record
- Remedy
- NO CRANK, IGN A 40 AMP FUSE BLOWN. *TT