GMC Yukon 2000–2006
Common on this vehicle:Gauge or instrument faultWarning lightAir conditioning or heaterLights (headlights, turn signals)NoiseLoss of engine power, no accelerationSmoke or fireLeak
Possible causes
14 causes not drawn
- Rear bank knock sensor corrosion from water intrusion (P0332)4.8L, 5.3L, 6.0L only0
- Throttle body carbon build-up: idle surge, reduced engine power, throttle DTCs (high mileage)0
- Brake pipe (brake line) corrosion and rupture0
- ABS light with C0265/C0201/U1041 or no communication with brake module (EBCM ground G110)0
- Front right-hand brake pipe contact with body cross sill - recall 00V-3450
- Service Brake Booster message on a Hydroboost vehicle with DTC C0136 (instrument cluster not SPS programmed)0
- Stability System Disabled / Service Stability message with DTC C0455 (bent terminals at the steering wheel position sensor)0
- Stability System Disabled message and unwanted StabiliTrak activation (tire wear or mismatched tires)0
- ABS lamp with DTC C0265 (EBCM motor relay circuit) after EBCM replacement0
- Transfer case service light, New Venture Gear transfer case (replace the encoder motor sensor and reprogram the TCCM)0
- P0420 / P0430 on a new or just-replaced catalytic converter (break-in not completed)0
- DTC P0446 set with the SES lamp on (replace the EVAP vent solenoid, not the canister)0
- Autoride (Z55) Service Ride Control / Service Suspension System message0
- Aftermarket part (not the vehicle as built): Federal-Mogul National / Carquest replacement wheel hub assembly retention nut - recall 07E-1062WD only0
Causes with no correction stated (8)
Causes the records name for which no check or repair is stated, in a technical document or in a record. Press one for the records that name it.
- Instruments and lighting
- Bulb: failed (1)Instrument Panel Cluster: failed (1)
- Electrical, wiring and power
- Bulb Socket: overheated (1)Intermittent no start with Service Stability, ABS light, 'Unknown Driver' and multiple DTCs / no module communication (0)
- Body, doors and interior
- Seat Position Sensor: broken (1)
- Transmission and driveline
- Transmission: failed (1)
The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.
FaultCrate・GMC Yukon 2000–2006・Warning light, Electrical, wiring and power
Candidate cause (named by records only; no technical document)
Battery: failed
1 of the records matching this search name this component as the cause.
What to do
No technical document states a check or a repair.
In the records
- Alternator: replaced 1（says it did not fix it: 1）
- Battery: replaced 1（says it did not fix it: 1）
- Instrument Panel Cluster: replaced 1（says it did not fix it: 1）
See the evidence (0 technical documents, 1 records)
Records
- Multiple electrical failures: turn signal activates hazard lights, inoperative gauges, battery failure, and gear shift noise Owner complaint 2008-07-17
A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.
Put together by FaultCrate from public records and technical documents. The cause and the repair are for the workshop to decide with the vehicle in front of it. Counts are records, not failure rates.