GMC Yukon 2000–2006
Common on this vehicle:Warning light
Possible causes
8 causes not drawn
- Stability System Disabled message and unwanted StabiliTrak activation (tire wear or mismatched tires)0
- ABS lamp with DTC C0265 (EBCM motor relay circuit) after EBCM replacement0
- Throttle body carbon build-up: idle surge, reduced engine power, throttle DTCs (high mileage)0
- CHECK OIL LEVEL message stays on after an oil change or top-off until the engine cools0
- SIR lamp on and inside mirror temperature/compass display inoperative (open air bag fuse, circuit 1139 shorted to ground)0
- Air bag (SIR) lamp on with DTC B1001 after BCM or SDM replacement0
- Autoride (Z55) Service Ride Control / Service Suspension System message0
- Aftermarket part (not the vehicle as built): Federal-Mogul National / Carquest replacement wheel hub assembly retention nut - recall 07E-1062WD only0
Causes with no correction stated (2)
Causes the records name for which no check or repair is stated, in a technical document or in a record. Press one for the records that name it.
The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.
FaultCrate・GMC Yukon 2000–2006・Warning light, C0374, Transmission and driveline
Candidate cause (the documents say what to do)
Transfer case service light, New Venture Gear transfer case (replace the encoder motor sensor and reprogram the TCCM)
0 of the records matching this search name this component as the cause.
How to tell
C0327P0500P0836Service 4WD
What to do
- Verify that the encoder motor is the primary cause.
- Replace the encoder motor sensor and reprogram the TCCM; the labor operation is K9980.
Caution: Do not replace the module, the encoder motor or the transfer case for DTCs C0327, P0836, P0500; the reference is bulletin 03-04-21-001D.
What is needed
- Parts and materials
- Encoder motor sensor
- Labor time
- Labor Operation: K9980
- Special tools
- Not stated
- Scan tool
- Reprogramming of the TCCM
Only what the technical documents state. "Not stated" does not mean not needed.
In the records
No record states work done for this cause.
See the evidence (1 technical documents, 0 records)
Passages of the technical documents
Row for 2003 Fullsize Pickups and Utilities: transfer case service light, New Venture Gear transfer case.
2003 Fullsize Pickups and Utilities – Transfer Case Service Light/New Venture Gear Transfer Case
General Motors 2004-04-01
Verify that the encoder motor is the primary cause.
Verify that the encoder motor is the primary cause.
General Motors 2004-04-01
Replace the encoder motor sensor and reprogram the TCCM; the labor operation is K9980.
Replace encoder motor sensor and reprogram TCCM. Labor Operation: K9980
General Motors 2004-04-01
Do not replace the module, the encoder motor or the transfer case for DTCs C0327, P0836, P0500; the reference is bulletin 03-04-21-001D.
Don’t replace the module, encoder motor or transfer case for DTCs C0327, P0836, P0500 03-04-21-001D
General Motors 2004-04-01
A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.
Put together by FaultCrate from public records and technical documents. The cause and the repair are for the workshop to decide with the vehicle in front of it. Counts are records, not failure rates.