GMC Yukon 2000–2006
Common on this vehicle:Corrosion or rust
Record by record
1 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.
Symptom
Component named as the cause
A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.
Read the records one by one (1)
Known issuesBrake pipe (brake line) corrosion and rupture1
Owner complaint2006 GMC YUKON DENALI ・ 2017-09-08
Severe brake line corrosion and wheel speed sensor corrosion causing ABS activation at low speeds
1Fault
2Finding the cause
3Correction
Not stated
What the documents say to do
Brake pipe (brake line) corrosion and ruptureConfirm
- In the joint inspections, scaling or flaking corrosion was taken as indicating the onset of metal loss and given the second lowest ranking (2); a leaking or previously repaired pipe was the lowest (1).
Repair
- GM recommends replacing the entire set of pipes whenever any pipe leaks or is corroded enough to need replacement.
- On June 28, 2013 GM released 66 new part numbers for servicing brake pipes in 1999-2007 GMT800 pickups and utility vehicles.
Caution
- Analysis of repair records indicates that consumers often elect to repair only the failed circuit.
Read the sentences of the record
- Fault
- MALFUNCTION OCCURS INTERMITTENTLY.
- Cause
- SEVERE BRAKE LINE CORROSION AND CORROSION AT WHEEL SPEED SENSORS CAUSES ABS TO ACTIVATE AT LOW SPEEDS. (1 more)
- Consequence
- I HAD 2 NEAR MISS CRASHES AND THEN CAR WOULD NOT STOP AND I HIT A FENCE IN MY YARD YESTERDAY.