GMC Yukon 2000–2006
Common on this vehicle:Corrosion or rustLeakNoise
Record by record
2 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.
Component named as the cause
Work done
How it is said to have ended
- result not stated1
A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.
Read the records one by one (2)
Known issuesUnwanted ABS activation at low speed (front wheel speed sensor mounting corrosion)1
Owner complaint2002 GMC YUKON ・ 2005-10-20
ABS sensors replacement needed
1Fault
2Finding the cause
3Correction
Read the sentences of the record
- Remedy
- THE CONSUMER HAD TO HAVE ABS SENSORS REPLACED. (1 more)
- Inspection
- MECHANIC TESTED THE SENSORS AND STATED THIS WOULD NOT STOP VEHICLE.*AK THE FRONT HUB AND BEARING WERE CORRODED ALONG WITH THE SENSORS.
SERVICE BRAKES, HYDRAULIC1
Owner complaint2000 GMC YUKON DENALI ・ 2007-09-28
Brake failure and rear end noise at 98,000 miles
1Fault
2Finding the cause
3Correction
Not stated
Read the sentences of the record
- Fault
- WHILE DRIVING 30 MPH (= 48.3 km/h), THE VEHICLE REFUSED TO STOP AND THE BRAKES MADE A LOUD NOISE WHEN THEY WERE APPLIED. (2 more)
- Inspection
- THE MECHANIC AT THE AUTO SHOP STATED THAT THE BRAKE SHOES AND DRUM FAILED.