Skip to content
FaultCrate
日本語

This is an open preview: every record can be read without an account.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
1 conditions added

Common on this vehicle:

causeCoil Ground Ring TerminalRemove

Record by record

1 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.

Component named as the cause

Work done

A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.

Read the records one by one (1)

ENGINE AND ENGINE COOLING1

  1. Manufacturer communication2000–2006 GMC YUKON DENALI ・ 2017-08-15

    Premature Catalytic Converter Failures – Inspection and Repair

    1. 1Fault

      • The catalytic converter has come apart, or DTC P0420 and/or P0430 has set.

    2. 2Finding the cause

      Steps to confirm (in the document’s order)

      1. If the converter has failed for no apparent reason, inspect for a poor crimp at the ignition coil ground terminal on the engine block for the affected bank.
      2. Inspect the ground for corrosion or damage at the terminal ring, fasteners and grounding surfaces.

    3. 3Correction

      Repair

      • If no corrosion or damage is found, tighten the ground bolt to the proper torque.
    Read the sentences of the record

    From the manufacturer’s document

    • Applies to：Applies to 2016 and prior GM cars and gasoline-powered light duty and HD trucks.
    • Condition：The catalytic converter has come apart, or DTC P0420 and/or P0430 has set.
    • Confirm：If the converter has failed for no apparent reason, inspect for a poor crimp at the ignition coil ground terminal on the engine block for the affected bank.
    • Confirm：Inspect the ground for corrosion or damage at the terminal ring, fasteners and grounding surfaces.
    • Repair：If no corrosion or damage is found, tighten the ground bolt to the proper torque.

    Open the manufacturer’s document (PDF) ↗ The points above were read from this document.

    Remedy
    This Preliminary Information communication provides information to the technician about gasoline powered cars, mid-size trucks, light duty trucks, and heavy duty trucks with premature catalytic converter failures. It is recommended to inspect for a poor crimp on the coil grounds ring terminal at the engine block for the bank with the concern and repair the wire.