Skip to content
FaultCrate

This is an open preview: every record can be read without an account.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

Common on this vehicle:Gauge or instrument faultLights (headlights, turn signals)NoiseWarning light

causeBatteryRemove

Possible causes

Warning light, Transmission and driveline1 records
Electrical, wiring and power
Brakes
Transmission and driveline
Engine
Exhaust and emissions
Fuel system
1Battery: failed0Intermittent MIL, service lamps/messages or DTCs from connector fretting corrosion0Reduced Engine Power from throttle body connector crimp, broken wire or grounds0Brake pipe (brake line) corrosion and rupture0ABS light with C0265/C0201/U1041 or no communication with brake module (EBCM ground G110)0Front right-hand brake pipe contact with body cross sill - recall 00V-3450Service Brake Booster message on a Hydroboost vehicle with DTC C0136 (instrument cluster not SPS programmed)0Stability System Disabled / Service Stability message with DTC C0455 (bent terminals at the steering wheel position sensor)0Transfer case service light, New Venture Gear transfer case (replace the encoder motor sensor and reprogram the TCCM)0Crankshaft position sensor may work intermittently or fail (8.1L V8) - recall 07V-5218.1L only0Intake manifold gasket leak (cold idle misfire, lean codes)0Single-cylinder misfire (P0300-P0308) and/or chirp, squeak or tick at camshaft speed: worn cam lobe / lifter, valve or valve spring0P0300 after engine repairs: injector connectors crossed (cylinders 5-7 / 6-8)0Rear bank knock sensor corrosion from water intrusion (P0332)4.8L, 5.3L, 6.0L only0P0420 / P0430 on a new or just-replaced catalytic converter (break-in not completed)0DTC P0446 set with the SES lamp on (replace the EVAP vent solenoid, not the canister)
8 causes not drawn
Causes with no correction stated (2)

Causes the records name for which no check or repair is stated, in a technical document or in a record. Press one for the records that name it.

The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.

Candidate cause (the documents say what to do)

Intermittent MIL, service lamps/messages or DTCs from connector fretting corrosion

Intermittent illumination of the MIL, service lamps or service messages, or DTCs set by various control modules.

The passage is a heading about diagnosing and repairing fretting corrosion.

How to tell

Check engine / Service Engine Soon

What to do

  1. Disconnect the affected connector and apply dielectric lubricant.

What is needed

Parts and materials
  • Dielectric lubricant (applied to the disconnected connector)
Labor time
Not stated
Special tools
Not stated
Scan tool
Not stated

Only what the technical documents state. "Not stated" does not mean not needed.

In the records

No record states work done for this cause.

See the evidence (1 technical documents, 0 records)

Passages of the technical documents

  • Intermittent illumination of the MIL, service lamps or service messages, or DTCs set by various control modules.

    INTERMITTENT ILLUMINATION OF MIL, SERVICE LAMPS, SERVICE MESSAGES, OR DTC SET BY VARIOUS CONTROL MODULES

    NHTSA manufacturer-communications index (NHTSA's one-line summary of a GM bulletin; not the bulletin text) 2011-12-01

  • The passage is a heading about diagnosing and repairing fretting corrosion.

    DIAGNOSING AND REPAIRING FRETTING CORROSION

    NHTSA manufacturer-communications index (NHTSA's one-line summary of a GM bulletin; not the bulletin text) 2011-12-01

  • Disconnect the affected connector and apply dielectric lubricant.

    (DISCONNECT AFFECTED CONNECTOR AND APPLY DIELECTRIC LUBRICANT)

    NHTSA manufacturer-communications index (NHTSA's one-line summary of a GM bulletin; not the bulletin text) 2011-12-01

Read every statement and its source →

Records

None among the records that can be opened now.

See all 0 records of this cause →

A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.