本文へ移動
FaultCrate

公開準備中のため、いまは登録なしですべての記録を閲覧できます。プランの詳細は準備中です。

← 症例へ戻る

GM TechLink 2006-08-51

原文と出典

原文

Creak or Squeak Noise This information applies to 2005-06 full size utilities, Cadillac Escalade, Chevrolet Avalanche, and HUMMER H2 built after May, 2005. Owners may comment of a creak or squeak type noise on acceleration, deceleration, over bumps, turns or garage shifts. This noise may sound like it is from the front or the rear of the vehicle. This noise (felt or heard using Chassis Ears) may seem to be coming from along the entire frame side rail or body mount areas. In some cases, the noise may sound like loose lumber while driving on a minimally rough road surface while driving straight or turning. IMPORTANT: This noise can sound like it is coming from the propshaft. Do not replace the propshaft for this condition. This noise could be coming from the rear lower control arm bushings. The squeak is caused by relative movement of the bushing to the control arm flange. To help isolate the noise to the control arm bushing, spray penetrating oil (WD-40 or equivalent) on the bushing to the control arm area. If the noise is eliminated or reduced, replace the control arm assembly.

提供元のページを開く(外部)

出典

情報源
GM TechLink — メーカーがディーラーへ出した通知(行政機関が要約を公開)
報告者の区分
メーカー
情報源での番号
2006-08-51
国・市場
US
言語
en
文書版
第2版(保持2版)
情報源についての注記
Copyright General Motors Corporation. No licence is stated. Held as the headline and short quoted passages with the issue named and linked; the articles themselves are not stored or shown.

日時

発生日
不明
情報源の受付日
2006-08-01
情報源のファイルへの追加日
情報源のAPIが返さないため不明
発行・公表日
2006-08-01
初回観測
2026-10-06 19:12 JST (初回の一括取得)
この版の取得
2026-10-09 21:52 JST