Skip to content
FaultCrate
日本語Open preview: everything readable

This is an open preview: every record can be read without an account. The details of the plans are in preparation.

GMC Yukon XL 2000–2006

GMC Yukon XLModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

Common on this vehicle:Warning lightLeakNoiseCorrosion or rustParking brakeStalls or shuts offGauge or instrument faultAir conditioning or heater

Possible causes

Warning light, 200167 records
Engine
Fuel system
Suspension, wheels and tires
Brakes
Airbags and seat belts
Transmission and driveline
4Single-cylinder misfire (P0300-P0308) and/or chirp, squeak or tick at camshaft speed: worn cam lobe / lifter, valve or valve spring1Crankshaft position sensor may work intermittently or fail (8.1L V8) - recall 07V-5211P0300 after engine repairs: injector connectors crossed (cylinders 5-7 / 6-8)1Rear bank knock sensor corrosion from water intrusion (P0332)0Intake manifold gasket leak (cold idle misfire, lean codes)3DTC P0446 set with the SES lamp on (replace the EVAP vent solenoid, not the canister)2Fuel module reservoir assembly: fuel pump wire connectors may overheat - recall 05V-1552Autoride (Z55) Service Ride Control / Service Suspension System message1Aftermarket part (not the vehicle as built): Federal-Mogul National / Carquest replacement wheel hub assembly retention nut - recall 07E-1061Unwanted ABS activation at low speed (front wheel speed sensor mounting corrosion)1Brake pipe (brake line) corrosion and rupture1ABS light with C0265/C0201/U1041 or no communication with brake module (EBCM ground G110)1Parking brake linings worn out prematurely, parking brake does not hold (PBR single-shoe drum-in-hat)1Anti-Lock Brake Motor0ABS lamp with DTC C0265 (EBCM motor relay circuit) after EBCM replacement1Seat Belt Buckle1Seat Belt Warning Light0Air bag (SIR) lamp on with DTC B1001 after BCM or SDM replacement1Service 4WD indicator and DTC B2725 (transfer case shift control switch)
1 causes not drawn

The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.

FaultCrate・GMC Yukon XL 2000–2006・Warning light, 2001

Candidate cause (the documents say what to do)

Single-cylinder misfire (P0300-P0308) and/or chirp, squeak or tick at camshaft speed: worn cam lobe / lifter, valve or valve spring

Customers may complain of an SES light, engine misfire and/or engine noise.

A verified noise is not eliminated by canceling fuel injectors and occurs at camshaft speed (half of crankshaft speed).

How to tell

P0300P0301P0302P0303P0304Check engine / Service Engine Soon

What to do

  1. If pressing on the valve side of the rocker changes the noise, a lifter and/or cam lobe concern on that cylinder is most likely.
  2. The misfiring/ticking cylinder should have less cam lobe lift than comparison cylinders if a worn lifter roller and/or cam lobe is the cause.
  3. During the noise, press with a wooden hammer handle on the rocker arms at the valve side, push rod side, and side of the rocker to find which one is making noise.
  4. Measure the cam lobe lift at the push rod side of the rocker arm.
  5. A good indicator of a sticking valve is engine misfires that continue to count on an aggressive deceleration with engine braking.
  6. Release the air pressure from the cylinder and work the valve up and down in the guide while turning it 360 degrees; if any binding is felt, a stem to guide clearance concern exists.
Read the remaining 9 steps

Caution: A damaged cam lobe is easy to overlook when inspecting through the lifter bores; unworn lifter rollers do not mean the cam lobes are okay.

In the records

No record states work done for this cause.

See the evidence (2 technical documents, 4 records)

Passages of the technical documents

  • GMC Yukon Models 2002 - 2018 All All V8 ALL

    General Motors (published by NHTSA) 2018-10-16

  • Some customers may complain of a SES light, engine misfire, and/or engine noise.

    General Motors (published by NHTSA) 2018-10-16

  • If a noise is verified, it will not be eliminated by canceling fuel injectors and the noise will occur at camshaft speed (half of crankshaft speed).

    General Motors (published by NHTSA) 2023-04-24

  • The noise may be described as a chirp, squeak, squeal or tick noise and may increase off of idle.

    General Motors (published by NHTSA) 2023-04-24

Read every statement and its source →

Manufacturer’s documents

Records

None among the records that can be opened now.

See all 4 records of this cause →

A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.

Put together by FaultCrate from public records and technical documents. The cause and the repair are for the workshop to decide with the vehicle in front of it. Counts are records, not failure rates.