Skip to content
FaultCrate
日本語Open preview: everything readable

This is an open preview: every record can be read without an account. The details of the plans are in preparation.

GMC Yukon XL 2000–2006

GMC Yukon XLModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

Common on this vehicle:Warning light

Record by record

1 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.

Read the records one by one (1)

Known issuesStability System Disabled / Service Stability message with DTC C0455 (bent terminals at the steering wheel position sensor)1

  1. Manufacturer communication2005 GMC FULL SIZE UTILITIES (YUKON XL) ・ 2005-07-01

    Stability System Disabled / Service Stability message with DTC C0455: bent terminals at the steering wheel position sensor

    1. 1Fault

      • Owners may comment on a Stability System Disabled or Service Stability message with DTC C0455.

    2. 2Finding the cause

      Possible causes

      • The concern may be caused by bent terminals on the SWPS (Steering Wheel Position Sensor).

      Steps to confirm (in the document’s order)

      • Remove the SWPS connector and inspect for bent terminals.

    3. 3Correction

      Repair

      • In most cases the terminals can be straightened without replacing the sensor.
    Read the sentences of the record

    From the manufacturer’s document

    • Applies to：Applies to 2005 Cadillac, Chevrolet and GMC Full Size Utilities with RPO JL4.
    • Condition：Owners may comment on a Stability System Disabled or Service Stability message with DTC C0455.
    • Cause：The concern may be caused by bent terminals on the SWPS (Steering Wheel Position Sensor).
    • Confirm：Remove the SWPS connector and inspect for bent terminals.
    • Repair：In most cases the terminals can be straightened without replacing the sensor.

    Open this issue of GM TechLink ↗ The points above are read from an article of TechLink, GM’s monthly publication for dealership technicians. The article itself is not reproduced here.

    Remedy
    Stability System This information applies to 2005 Cadillac, Chevrolet, and GMC Full Size Utilities with RPO JL4. Owners may comment on a Stability System Disabled or Service Stability message with DTC C0455. This concern may be caused by bent terminals on the SWPS (Steering Wheel Position Sensor). Remove the SWPS connector and inspect for bent terminals. In most cases, the terminals can be straightened without having to replace the sensor.