Skip to content
FaultCrate
日本語Open preview: everything readable

This is an open preview: every record can be read without an account. The details of the plans are in preparation.

GMC Yukon XL 2000–2006

GMC Yukon XLModel years 2000–2006

Change vehicle →
Clear the search
Add conditions (optional: symptom, model year, system, warning display, trouble code, kind of record)

Common on this vehicle:

causeOnStar SystemRemove

Record by record

5 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.

Component named as the cause

Work done

A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.

Read the records one by one (4)

ELECTRICAL SYSTEM4

  1. Manufacturer communication2006 GMC YUKON XL ・ 2017-08-15(1 earlier editions of this document folded here)

    OnStar System Power-Up Failure - Preliminary Information

    1. 1Fault

      • The OnStar system will not power up, or no LED is lit and the OnStar button assembly does not respond.

    2. 2Finding the cause

    3. 3Correction

    Read the sentences of the record

    From the manufacturer’s document

    • Applies to：Applies to 2006-2013 GM passenger cars and trucks with OnStar (RPO UE1).
    • Condition：The OnStar system will not power up, or no LED is lit and the OnStar button assembly does not respond.

    Open the manufacturer’s document (PDF) ↗ The points above were read from this document.

    Remedy
    This Preliminary Information communication provides information to the technician about vehicles that have an OnStar system that will not power up. Technician should turn off the ignition and cancel retained accessory power. After the vehicle has powered down, remove power to the OnStar module for five minutes. After the power has been removed for five minutes, if the OnStar system is working release the vehicle. If the OnStar system is still inoperative continue with published Service Information diagnostics.

  2. Manufacturer communication2000–2006 GMC YUKON XL ・ 2017-08-15

    OnStar System Voice Commands and Number Response Issue

    1. 1Fault

      Not stated

    2. 2Finding the cause

      Steps to confirm (in the document’s order)

      • Test the OnStar voice recognition (VR) system with the customer in the vehicle to verify the condition.

    3. 3Correction

      This Preliminary Information communication provides information to the technician about vehicles that have the OnStar system does not respond properly to some numbers and/or voice commands. Dealer should direct the customer to review the operational characteristics in the OnStar Users Guide.

    Read the sentences of the record

    From the manufacturer’s document

    • Applies to：2000-2015 GM passenger cars and light duty trucks with OnStar Gen6, Gen7, Gen8, Gen9 or Gen10.
    • Confirm：Test the OnStar voice recognition (VR) system with the customer in the vehicle to verify the condition.

    Open the manufacturer’s document (PDF) ↗ The points above were read from this document.

    Remedy
    This Preliminary Information communication provides information to the technician about vehicles that have the OnStar system does not respond properly to some numbers and/or voice commands. Dealer should direct the customer to review the operational characteristics in the OnStar Users Guide.

  3. Manufacturer communication2005–2006 GMC YUKON DENALI XL ・ 2017-04-10

    OnStar System Power-Up Issue Information

    1. 1Fault

      Not stated

    2. 2Finding the cause

    3. 3Correction

    Read the sentences of the record
    Remedy
    THIS PRELIMINARY INFORMATION COMMUNICATION PROVIDES INFORMATION TO THE TECHNICIAN ABOUT VEHICLES THAT HAVE AN ONSTAR SYSTEM THAT WILL NOT POWER UP. TECHNICIAN SHOULD TURN OFF THE IGNITION AND CANCEL RETAINED ACCESSORY POWER. AFTER THE VEHICLE HAS POWERED DOWN REMOVE POWER TO THE ONSTAR MODULE FOR FIVE MINUTES. AFTER THE POWER HAS BEEN REMOVED FOR FIVE MINUTES, IF THE ONSTAR SYSTEM IS WORKING RELEASE THE VEHICLE. IF THE ONSTAR SYSTEM IS STILL INOPERATIVE CONTINUE WITH PUBLISHED SERVICE INFORMATION DIAGNOSTICS.

  4. Manufacturer communication2003–2006 GMC YUKON XL ・ 2011-06-27

    OnStar Incomplete Calls Without Driver Knowledge

    1. 1Fault

      Not stated

    2. 2Finding the cause

    3. 3Correction

      GM: ONSTAR IS MAKING INCOMPLETE CALLS WITHOUT THE DRIVER KNOWING. WHEN HAVE A DATA CONNECTION. *RM

    Read the sentences of the record
    Remedy
    GM: ONSTAR IS MAKING INCOMPLETE CALLS WITHOUT THE DRIVER KNOWING. WHEN HAVE A DATA CONNECTION. *RM

Showing 4 of the 5 you can open. Narrow the search to see the rest.