Skip to content
FaultCrate
日本語

This is an open preview: every record can be read without an account.

GMC Yukon XL 2000–2006

GMC Yukon XLModel years 2000–2006

Change vehicle →
Clear the search
1 conditions added

Common on this vehicle:Stalls or shuts offWarning light

causeCrankshaft Position SensorRemove

Record by record

1 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.

Symptom

Component named as the cause

A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.

Read the records one by one (1)

Known issuesCrankshaft position sensor may work intermittently or fail (8.1L V8) - recall 07V-5211

  1. Recall2001 GMC YUKON XL ・ 2007-11-09

    Crankshaft Position Sensor Failure Recall

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

      Not stated

      What the documents say to do

      Crankshaft position sensor may work intermittently or fail (8.1L V8) - recall 07V-521

      Repair

      1. Dealers replace the crankshaft position sensor.
      2. As the remedy, an improved CKP is installed.

      Caution

      • All of the surveyed consumers noted multiple stalling events before the CKP was properly diagnosed and replaced.
    Read the sentences of the record
    Cause
    On certain vehicles equipped with an 8.1L engine, the crankshaft position sensor may fail. If the sensor operates intermittently, the Service Engine Soon (SES) light may illuminate and the vehicle may run rough. In addition, the engine may stall, and if so, may re-start immediately or after a cool-down period. If the sensor becomes inoperable permanently, the engine will quit running and will not re-start. Engine stalling would result in lost propulsion which, in conjunction with traffic and road conditions, and the driver's reactions, could increase the risk of a crash. Correction: Dealers will replace the crankshaft position sensor.