GMC Yukon 2000–2006
Common on this vehicle:Gauge or instrument faultWarning lightLeakMisfire or rough idleStalls or shuts offHard start or long crankDoes not startLoss of engine power, no acceleration
Possible causes
Causes with no correction stated (4)
Causes the records name for which no check or repair is stated, in a technical document or in a record. Press one for the records that name it.
The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.
FaultCrate・GMC Yukon 2000–2006・Fuel system, 2002
Candidate cause (the documents say what to do)
Oil leak after cold start from frozen PCV system (rear main seal)
Oil leak can occur shortly after a cold start in extremely low ambient temperatures (approximately below 10°F (= -12.2 °C)) or with excessive short-trip driving.
This is the result of a frozen PCV system and excessive crankcase pressure.
What to do
- Clean the area of the leak and clean and dry the PCV hoses.
- Fit oil fill cap 12589430 (vented) to prevent a recurrence.
What is needed
- Parts and materials
- Oil fill cap 12589430 (vented)
- Labor time
- Not stated
- Special tools
- Not stated
- Scan tool
- Not stated
Only what the technical documents state. "Not stated" does not mean not needed.
In the records
- Oil Fill Cap: replaced 2
- PCV Hose: cleaned 2
See the evidence (2 technical documents, 2 records)
Passages of the technical documents
The bulletin lists GMC Yukon Models 2002 - 2014.
Yukon Models 2002 - 2014
General Motors (published by NHTSA) 2018-01-09
Oil leak can occur shortly after a cold start in extremely low ambient temperatures (approximately below 10°F (= -12.2 °C)) or with excessive short-trip driving.
oil leak shortly after a cold start when extremely low ambient temperatures are present (approximately below 10*F), or excessive short trip drive cycles.
General Motors (published by NHTSA) 2018-01-09
This is the result of a frozen PCV system and excessive crankcase pressure.
is noted, this is the result of a frozen PCV system and excessive crankcase pressure.
General Motors (published by NHTSA) 2018-01-09
Clean the area of the leak and clean and dry the PCV hoses.
clean the area of the oil leak, clean and dry the PCV hoses, and replace the oil fill cap with part number
General Motors (published by NHTSA) 2018-01-09
Manufacturer’s documents
- Oil Leak at Cold Start in Extreme Low Ambient Temperatures PIP3343F 2018-02-21
A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.
Put together by FaultCrate from public records and technical documents. The cause and the repair are for the workshop to decide with the vehicle in front of it. Counts are records, not failure rates.
