Source reference 10139041
Manufacturer communication — 2006 GMC YUKON DENALI XL
Relation to the target vehicle
- The source's vehicle field includes the trim.
- Model year
- Match 2006 — Source vehicle field
- Model
- Match YUKON DENALI XL — Source vehicle field
- Trim
- Match Denali — Source vehicle field
What the manufacturer’s document says
05-03-07-009F ・ information ・ for GM vehicles in general
Applies to
The bulletin addresses 2014 and prior GM passenger cars and light duty trucks.
the passage
2014 and Prior GM Passenger Cars and Light Duty Trucks
Finding the cause
Steps to confirm (in the document’s order)
Jounce the front and the rear bumpers 3 times prior to checking the wheel alignment.
the passage
Jounce the front and the rear bumpers 3 times prior to checking the wheel alignment.
Correction
Repair
On vehicles requiring a 4-wheel alignment, set the rear wheel alignment angles first in order to obtain proper front wheel alignment angles.
the passage
When performing adjustments to vehicles requiring a 4-wheel alignment, set the rear wheel alignment angles first in order to obtain proper front wheel alignment angles.
Caution
Verify the vehicle is in original equipment condition for curb weight, tires, wheels, suspension and steering; vehicles modified in any of these areas are not covered for wheel alignment warranty.
the passage
Verify the vehicle is in an Original Equipment condition for curb weight, tires, wheels, suspension and steering configurations. Vehicles modified in any of these areas are not covered for wheel alignment warranty.
Lead/pull concerns due to road crown are considered "Normal Operation" and are not a warrantable condition.
the passage
Lead/pull concerns due to road crown are considered “Normal Operation” and are NOT a warrantable condition
New vehicles are generally not to be aligned until they have accumulated at least 800 km (500 mi).
the passage
For this reason, new vehicles are generally NOT to be aligned until they have accumulated at least 800 km (500 mi).
In general, wheel alignments are not to be performed as an investigation or correction for vibration concerns.
the passage
In general, wheel alignments are NOT to be performed as an investigation/correction for vibration concerns.
Technicians must refer to SI for the correct wheel alignment specifications.
the passage
Technicians must refer to SI for the correct wheel alignment specifications.
Compiled by reading the full text of the document; each point stands on the passage shown. Check the document itself, linked below, before working on a vehicle.
Stated content
Communication summary
本情報通知は05-03-07-009Eの改定であり、2014年型の追加と労務作業の更新を行います。 Machine translation (unreviewed)
This informational bulletin provides a revision for 05-03-07-009E to add the 2014 model year and update the Labor Operations.
Go to this passage in the original
Source
- Source
- NHTSA Manufacturer Communications
- Source reference
- 10139041
- Received by source
- 2018-06-04
- Incident date
- Unknown
Open original text and sourceOpen the provider's page (external)