情報源での番号 2006-08-01
メーカー通知 — 2006 GMC YUKON
参考報告者の区分: メーカー
対象車両との関係
- 情報源の車種欄はYukonで、XLかどうかの記載がありません。
- モデル年
- 一致 2006 — 情報源の車種欄
- 車種
- 不明 YUKON — 情報源の車種欄
- グレード
- 一致 Denali — 原文の記載
…uburban, Tahoe, and GMC Yukon and Yukon Denali. The CHECK OIL LEVEL message may displa…
メーカー文書の要点
不具合と対処 ・ この車種を名指し
対象
対象は 1999-2007年式の Chevrolet Silverado Classic、GMC Sierra Classic と、2002-06年式の Cadillac Escalade、Chevrolet Avalanche、Suburban、Tahoe、GMC Yukon、Yukon Denali。
原文の該当箇所
This information applies to 1999-2007 Chevrolet Silverado Classic and GMC Sierra Classic, 2002-06 Cadillac Escalade, Chevrolet Avalanche, Suburban, Tahoe, and GMC Yukon and Yukon Denali.
故障の状態
オイル交換中にキーをオンのままにした場合や、オイル量不足でエンジンオイルを補充した後に、修理後も CHECK OIL LEVEL のメッセージが表示されることがある。
原文の該当箇所
The CHECK OIL LEVEL message may display after a repair if the key is left on when doing an oil change, or after topping off the engine oil due to a low oil condition.
Tech 2 で Engine Oil Level Switch のデータを見ると OK と表示されるが、DIC には CHECK OIL LEVEL のメッセージが出たままになる。
原文の該当箇所
When using the Tech 2 to view the Engine Oil Level Switch data parameter, it will show OK, but the CHECK OIL LEVEL message will still be displayed on the DIC.
原因の特定
考えられる原因
CHECK OIL LEVEL をリセットするための冷却水温の条件が満たされていないと起きる。システムがオイル量を再確認するには、エンジン冷却水温が 50° F(10° C)下がる必要がある。
原文の該当箇所
These conditions could result if the engine coolant temperature criteria have not been met to reset the CHECK OIL LEVEL. The system must see a 50° F (10° C) drop in engine coolant temperature to recheck the engine oil level.
点検手順(文書の順)
次にキーを操作したとき、エンジンオイル量が正常なら DIC のメッセージは消えたままになる。
原文の該当箇所
On the next key cycle, if the engine oil level is OK, the DIC message will remain off.
対処
修理
エンジンを作動温度になるまで回し、その後エンジンを止めて、キーをオフにしたまま 1〜2 時間冷ます。
原文の該当箇所
To correct this concern, allow the engine to run until operating temperature is reached. Then shut the engine off and allow the engine to cool down for 1 to 2 hours with the key in the off position.
文書の本文を読んでまとめたものです。各項目は原文の該当箇所に基づいています。作業の前に、下の出典から文書そのものをご確認ください。
記載内容
通知の要約
日本語訳は未処理です。
CHECK OIL LEVEL Message This information applies to 1999-2007 Chevrolet Silverado Classic and GMC Sierra Classic, 2002-06 Cadillac Escalade, Chevrolet Avalanche, Suburban, Tahoe, and GMC Yukon and Yukon Denali. The CHECK OIL LEVEL message may display after a repair if the key is left on when doing an oil change, or after topping off the engine oil due to a low oil condition. When using the Tech 2 to view the Engine Oil Level Switch data parameter, it will show OK, but the CHECK OIL LEVEL message will still be displayed on the DIC. These conditions could result if the engine coolant temperature criteria have not been met to reset the CHECK OIL LEVEL. The system must see a 50° F (10° C) drop in engine coolant temperature to recheck the engine oil level. To correct this concern, allow the engine to run until operating temperature is reached. Then shut the engine off and allow the engine to cool down for 1 to 2 hours with the key in the off position. On the next key cycle, if the engine oil level is OK, the DIC message will remain off.
原文の該当箇所へ
出典
- 情報源
- GM TechLink
- 情報源での番号
- 2006-08-01
- 情報源の受付日
- 2006-08-01
- 発生日
- 不明
