Skip to content
FaultCrate

This is an open preview: every record can be read without an account. The details of the plans are in preparation.

GMC Yukon XL 2000–2006

GMC Yukon XLModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

The vehicle (where a record says)

A record is under an engine, a drive or a series only where it says so: the characters of the vehicle identification number filed with a complaint, its text, or what its document says it applies to. A record that does not say is kept as "not stated". The filed numbers and the documents do not tell 4WD from AWD.

Common on this vehicle:Warning lightMisfire or rough idleLoss of engine power, no accelerationStalls or shuts offLeakNoiseGauge or instrument faultHard start or long crank

Possible causes

Gauge or instrument fault, Check engine / Service Engine Soon5 records
Engine
Exhaust and emissions
Electrical, wiring and power
Fuel system
Instruments and lighting
1Mass Air Flow Sensor: failed0Crankshaft position sensor may work intermittently or fail (8.1L V8) - recall 07V-5218.1L only0Intake manifold gasket leak (cold idle misfire, lean codes)0Single-cylinder misfire (P0300-P0308) and/or chirp, squeak or tick at camshaft speed: worn cam lobe / lifter, valve or valve spring0P0300 after engine repairs: injector connectors crossed (cylinders 5-7 / 6-8)0Rear bank knock sensor corrosion from water intrusion (P0332)4.8L, 5.3L, 6.0L only1Purge Solenoid: failed0P0420 / P0430 on a new or just-replaced catalytic converter (break-in not completed)0Intermittent MIL, service lamps/messages or DTCs from connector fretting corrosion0Reduced Engine Power from throttle body connector crimp, broken wire or grounds0Slow or short fuel fill, inaccurate fuel gauge (2500: fuel tank vent)2500 only0Fuel gauge reads low or drops to empty in Park / Neutral (normal characteristic)0Out of fuel with the gauge reading above empty, cranks but no start, stall (replace the fuel sensor, not the sender module)0Fuel module reservoir assembly: fuel pump wire connectors may overheat - recall 05V-1551500 only0DTC P0446 set with the SES lamp on (replace the EVAP vent solenoid, not the canister)0Instrument panel cluster gauges stick, flutter or stop working0Speedometer needle appears inaccurate (specification +/- 2 MPH)0Voltmeter fluctuates between 12 and 14 volts (Regulated Voltage Control, normal)
1 causes not drawn

The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.

Candidate cause (the documents say what to do)

Purge Solenoid: failed

1 of the records matching this search name this component as the cause.

How to tell

P0442Check engine / Service Engine Soon

What to do

No technical document states a check or a repair.

In the records

  • Purge Solenoid: replaced 1
See the evidence (0 technical documents, 1 records)

Records

None among the records that can be opened now.

See all 1 records of this cause →

A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.