Skip to content
FaultCrate
日本語Open preview: everything readable

This is an open preview: every record can be read without an account. The details of the plans are in preparation.

GMC Yukon XL 2000–2006

GMC Yukon XLModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

Common on this vehicle:Warning light

Possible causes

Warning light, U10411 records
Brakes
Transmission and driveline
Electrical, wiring and power
Engine
Exhaust and emissions
Fuel system
1ABS light with C0265/C0201/U1041 or no communication with brake module (EBCM ground G110)0Brake pipe (brake line) corrosion and rupture0Front right-hand brake pipe contact with body cross sill - recall 00V-3450Service Brake Booster message on a Hydroboost vehicle with DTC C0136 (instrument cluster not SPS programmed)0Stability System Disabled / Service Stability message with DTC C0455 (bent terminals at the steering wheel position sensor)0Transfer case service light, New Venture Gear transfer case (replace the encoder motor sensor and reprogram the TCCM)0Intermittent battery lamp with history DTC B1489 after BGCM replacement (module not SPS programmed)0Intermittent MIL, service lamps/messages or DTCs from connector fretting corrosion0Reduced Engine Power from throttle body connector crimp, broken wire or grounds0Crankshaft position sensor may work intermittently or fail (8.1L V8) - recall 07V-5210Intake manifold gasket leak (cold idle misfire, lean codes)0Single-cylinder misfire (P0300-P0308) and/or chirp, squeak or tick at camshaft speed: worn cam lobe / lifter, valve or valve spring0P0300 after engine repairs: injector connectors crossed (cylinders 5-7 / 6-8)0Rear bank knock sensor corrosion from water intrusion (P0332)0P0420 / P0430 on a new or just-replaced catalytic converter (break-in not completed)0Fuel module reservoir assembly: fuel pump wire connectors may overheat - recall 05V-1550DTC P0446 set with the SES lamp on (replace the EVAP vent solenoid, not the canister)
6 causes not drawn

The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.

FaultCrate・GMC Yukon XL 2000–2006・Warning light, U1041

Candidate cause (the documents say what to do)

ABS light with C0265/C0201/U1041 or no communication with brake module (EBCM ground G110)

Upon inspection, DTCs C0265 and C0201 may be set in the brake module.

There may also be a loss of communication with the brake module.

How to tell

C0201C0265U1041ABS light

What to do

  1. The EBCM ground is on the frame beneath the driver's door; among several grounds it is the heavy 12-gauge wire.
  2. The battery-cable-to-frame ground can cause similar ABS symptoms and can be checked as well.
  3. Clean the area, front and back, using a tool such as a Scotch-Brite Roloc disc or equivalent.
  4. Use the bolts, washers and nuts specified in the bulletin because of their conductive finish.
  5. Cover the front and back of the repair area with rubberized undercoating.

Caution: Do not replace the brake module for this condition; do the ground repair before further EBCM diagnosis.

In the records

  • Electronic Brake Control Module Ground: adjusted 1
See the evidence (1 technical documents, 1 records)

Passages of the technical documents

  • 2000–2006 GMC Yukon, Yukon Denali, Yukon XL

    General Motors (third-party hosted copy at simple-engineering.com) 2009-03-11

  • Some customers may comment that the ABS light is on. Upon further inspection, DTCs C0265 and C0201 may be set in the brake module.

    General Motors (third-party hosted copy at simple-engineering.com) 2009-03-11

  • It is also possible for DTC U1041 to set in other modules.

    General Motors (third-party hosted copy at simple-engineering.com) 2009-03-11

  • There may also be a loss of communication with the brake module.

    General Motors (third-party hosted copy at simple-engineering.com) 2009-03-11

Read every statement and its source →

A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.

Put together by FaultCrate from public records and technical documents. The cause and the repair are for the workshop to decide with the vehicle in front of it. Counts are records, not failure rates.