Skip to content
FaultCrate
日本語

This is an open preview: every record can be read without an account.

GMC Yukon XL 2000–2006

GMC Yukon XLModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

Common on this vehicle:Warning light

Possible causes

Warning light, C01361 records
Brakes
Transmission and driveline
Electrical, wiring and power
Engine
Exhaust and emissions
Fuel system
1Service Brake Booster message on a Hydroboost vehicle with DTC C0136 (instrument cluster not SPS programmed)0Brake pipe (brake line) corrosion and rupture0ABS light with C0265/C0201/U1041 or no communication with brake module (EBCM ground G110)0Front right-hand brake pipe contact with body cross sill - recall 00V-3450Stability System Disabled / Service Stability message with DTC C0455 (bent terminals at the steering wheel position sensor)0Transfer case service light, New Venture Gear transfer case (replace the encoder motor sensor and reprogram the TCCM)0Intermittent battery lamp with history DTC B1489 after BGCM replacement (module not SPS programmed)0Intermittent MIL, service lamps/messages or DTCs from connector fretting corrosion0Reduced Engine Power from throttle body connector crimp, broken wire or grounds0Crankshaft position sensor may work intermittently or fail (8.1L V8) - recall 07V-5218.1L only0Intake manifold gasket leak (cold idle misfire, lean codes)0Single-cylinder misfire (P0300-P0308) and/or chirp, squeak or tick at camshaft speed: worn cam lobe / lifter, valve or valve spring0P0300 after engine repairs: injector connectors crossed (cylinders 5-7 / 6-8)0Rear bank knock sensor corrosion from water intrusion (P0332)4.8L, 5.3L, 6.0L only0P0420 / P0430 on a new or just-replaced catalytic converter (break-in not completed)0Fuel module reservoir assembly: fuel pump wire connectors may overheat - recall 05V-1551500 only0DTC P0446 set with the SES lamp on (replace the EVAP vent solenoid, not the canister)
6 causes not drawn
Causes with no correction stated (2)

Causes the records name for which no check or repair is stated, in a technical document or in a record. Press one for the records that name it.

Electrical, wiring and power
Intermittent no start with Service Stability, ABS light, 'Unknown Driver' and multiple DTCs / no module communication (0)
Brakes
Service Stability message with DTC C0131, C0196, C0290 and/or C0292 (0)

The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.

FaultCrate・GMC Yukon XL 2000–2006・Warning light, C0136

Candidate cause (the documents say what to do)

Service Brake Booster message on a Hydroboost vehicle with DTC C0136 (instrument cluster not SPS programmed)

The Service Brake Booster message notifies the driver of a Supplemental Brake Assist (SBA) concern on vehicles with a vacuum boost brake system.

There have been reports of the Service Brake Booster message being displayed on vehicles equipped with a Hydroboost brake system.

How to tell

C0136

What to do

  1. During normal diagnostics a DTC C0136 may be present in the IPC; this DTC is not in SI for Sport Utility vehicles, because all Sport Utilities use Hydroboost brake systems starting in 2004.
  2. To be sure the vehicle is repaired, cycle the ignition off and on at least 5 consecutive times, staying in each position at least 30 seconds.
  3. To correct the concern, SPS program the IPC.

What is needed

Parts and materials
Not stated
Labor time
Not stated
Special tools
Not stated
Scan tool
  • SPS programming of the IPC

Only what the technical documents state. "Not stated" does not mean not needed.

In the records

No record states work done for this cause.

See the evidence (2 technical documents, 1 records)

Passages of the technical documents

  • Applies to all full-size 2004 Cadillac, Chevrolet and GMC trucks and utilities with the Hydroboost brake system.

    This information applies to all full-size 2004 Cadillac, Chevrolet and GMC trucks and utilities with Hydroboost brake system.

    General Motors 2005-08-01

  • The Service Brake Booster message notifies the driver of a Supplemental Brake Assist (SBA) concern on vehicles with a vacuum boost brake system.

    The Service Brake Booster message is used to notify the driver of a Supplemental Brake Assist (SBA) concern on vehicles equipped with a vacuum boost brake system.

    General Motors 2005-08-01

  • There have been reports of the Service Brake Booster message being displayed on vehicles equipped with a Hydroboost brake system.

    There have been reports of the Service Brake Booster Message being displayed on vehicles equipped with a Hydroboost brake system.

    General Motors 2005-08-01

  • The message could be caused by the IPC being programmed incorrectly.

    This message could be caused by the IPC being programmed incorrectly.

    General Motors 2005-08-01

Read every statement and its source →

Records

None among the records that can be opened now.

See all 1 records of this cause →

A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.

Put together by FaultCrate from public records and technical documents. The cause and the repair are for the workshop to decide with the vehicle in front of it. Counts are records, not failure rates.