Skip to content
FaultCrate
日本語Open preview: everything readable

This is an open preview: every record can be read without an account. The details of the plans are in preparation.

GMC Yukon XL 2000–2006

GMC Yukon XLModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

Common on this vehicle:Lights (headlights, turn signals)LeakGauge or instrument faultNoiseShifting faultPower window

Possible causes

Instruments and lighting, 200212 records
Steering
Transmission and driveline
Suspension, wheels and tires
1Steering intermediate shaft clunk1Steering Gear Box1Transmission Gasket1Vehicle body tilt or lean left / right (torsion bar front suspension)

The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.

FaultCrate・GMC Yukon XL 2000–2006・Instruments and lighting, 2002

Candidate cause (the documents say what to do)

Steering intermediate shaft clunk

A clunking noise under the hood that can be felt in the steering wheel and/or steering column.

Intermediate steering shaft clunk noise or stick-slip.

What to do

  1. When properly lubricated, there should be 13 mm (1/2 inch) of grease showing on the shaft splines.
  2. Replace the upper intermediate steering shaft assembly.
  3. There are significant differences between the car and truck procedures: the lubricant is applied to a different part of the steering system and uses a different lubrication kit, 26098419.
  4. On the affected trucks, remove the intermediate steering shaft from the vehicle and remove the spacer clip.
  5. Apply the contents of the syringe supplied with the kit into the open end of the fully-extended intermediate shaft.
  6. Insert the plug into the opening and tighten the wing nut.
Read the remaining 2 steps

Part numbers printed in the document

The numbers are as the document prints them. The name and the replacing number are what the pages of GMPartsGiant, a reseller of genuine parts and not GM, state. Aftermarket equivalents are not checked here (the links only search by number). Confirm the fit for the vehicle (VIN) before ordering.

In the records

  • Intermediate Steering Shaft: replaced 1（says it did not fix it: 1）
  • Running Board: adjusted 1（result not stated: 1）
  • Transmission Gasket: replaced 1（result not stated: 1）
See the evidence (1 technical documents, 1 records)

Passages of the technical documents

  • CLUNKING NOISE UNDER HOOD AND CAN BE FELT IN STEERING WHEEL AND/OR STEERING COLUMN

    NHTSA manufacturer-communications index (NHTSA's one-line summary of a GM bulletin; not the bulletin text) 2008-04-01

  • (REPLACE UPPER INTERMEDIATE STEERING SHAFT [I-SHAFT] ASSEMBLY)

    NHTSA manufacturer-communications index (NHTSA's one-line summary of a GM bulletin; not the bulletin text) 2008-04-01

  • INTERMEDIATE STEERING SHAFT CLUNK NOISE OR STICK-SLIP (FOLLOW STRATEGY BASED DIAGNOSTICS).

    NHTSA manufacturer-communications index (NHTSA's one-line summary of a GM bulletin; not the bulletin text) 2006-02-01

  • The condition covered here is found in bulletin 00-02-35-003A, and applies to 1999- 2002 C/K pickup and utility models with recirculating ball steering.

    General Motors 2002-04-01

Read every statement and its source →

A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.

Put together by FaultCrate from public records and technical documents. The cause and the repair are for the workshop to decide with the vehicle in front of it. Counts are records, not failure rates.